Categories

Best 5w Rf Module

Happymodel ELRS 2.4GHz RX SX1280 EXPRESSLRS Nano Long Range Receiver EP1 RX

  • The Happymodel 2.4GHz ELRS nano series receiver is an open source program based on ExpressLRS, we have 3 types rx module released..
  • On the basis of PP RX, we have developed the Nano 2.4GHz rx of ESP8285 version named EP1 and EP2. The RF module of EP1/EP2 is the same like PP RX and....
  • Due to the low-latency and high-refresh-rate RF module, they are very comfortable for FPV race and Long Range FPV. And very suitable for Tiny whoop....
Check Stock

SunFounder Reader Module Kit Mifare RC522 Reader Module with S50 White Card and Key Ring Compatible with Arduino Raspberry Pi

  • The RF IC Card module design the circuit of card read by using the original Philips MFRC522 chip.
  • Easy to use, with pin header. The module can be directly loaded into the various reader molds..
  • Applicable for the user who need to design or manufacture the RF card terminal..
  • Module Interface: SPI， Data transfer rate: Maximum 10Mbit/s..
  • Power Voltage : 3.3V,Operating frequency: 13.56MHz..
Check Stock

UMLIFE 5pcs NRF24L01+PA+LNA RF Transceiver Module with SMA Antenna 2.4 GHz 1100m + 5pcs NRF24L01 Wireless Module with Breakout Adapter On-Board 3.3V Regulator for Arduino

  • It can be wildly used to wireless remote control, somatosensory devices, RFID, NFC, smart grid, smart home, wireless audio etc..
  • 5PCS NRF24L01 8 Pin Socket Breakout Adapter Board: On-board AMS1117-3.3 chip, a simple socket breakout board which is for 8-Pin NRF24L01 wireless module.
  • 5PCS NRF24L01+PA+LNA RF Transceiver Module with SMA Antenna: Built-in 2.4Ghz antenna: available software to set the address, only received local address when output data(Provide interrupt instruction), can be directly connected to a variety of microcontrollers.
  • RF24L01+ Breakout Adapter: Small power on SMD LED indicator, On-board 3.3V voltage regulator, which accepts +5V power supply input and provides 3.3V for the attached "nRF24L01+" module..
  • The packing list includes: 5 * NRF24L01+PA+LNA Wireless Transceiver RF Transceiver Module.
Check Stock

FrSky Tandem X20S Transmitter with Built-in 900M/2.5G Dual-Band Internal RF Module

  • Built-in TD 900M/2.4G Dual-Band Internal RF Module Supports Multiple Working Modes 2.4G ACCST D16Mode (Compatible with ACCST Receivers with D16 V2 or later FW) 2.4G ACCESSMode (Compatible with ACCESS Receivers) 900M ACCESSMode (Compatible with ACCESS R9 868/915MHz Receivers) (*Capable of simultaneous working under ACCESS mode) 2.4G & 900M TD Mode (Compatible with TD Receivers).
  • Super-low latency and long-range control with telemetry (*Up to 50 to 100KM range and down to 4ms end-to-end latency) 800*480 Color Touch-Screen Displays 6 Quick-Mode Custom Buttons (Front) and 2 Momentary Buttons (Rear) Lite Type External Module Bay Built-in 6-axis Gyroscope Sensor All CNC Metal Trims, Knobs.
  • Haptic Vibration Alerts and Voice Speech Outputs Supports SWR Indicator Warning Supports Recharge System for 2S Li-ion Battery (USB Type-C Interface) High-speed PARA Wireless Training System (Compatible with FreeLink App3.0) Built-in Audio Wireless Module (Compatible with Bluetooth Audio Device).
  • All CNC High-Precision Hall-Sensor Gimbals with 10 Ball-Bearing, adjustable 45° to 60° stcik travel and 8° rotatable panel. ETHOS: The more pow....
Check Stock

Mixer Module, Bandwidth Mixing 0.1‑500MHz High Frequency Transducer -10dBm for Quadrature Modulation for Base Station for HF VHF Receiver

  • Single Power Supply: The mixer module is designed to be powered by a single power supply, and the RF, IF and LO ports have DC isolation capacitors for easy use.
  • 10.3dB SSB Noise Figure at 70MHz: With the output amplifier and optimal source impedance of this mixer module, the SSB noise figure is 10.3dB at 70MHz. There is no insertion loss, no external duplexer, and no passive termination.
  • Low Distortion and Wide Dynamic Range: AD831 is a low distortion, wide dynamic range, single chip mixer, very practical.
  • -10dBm LO Power Consumption: Provides +24dBm third order intercept point, can achieve -10dBm LO power consumption, without high power LO drivers, there are no corresponding shielding and isolation problems, can improve system performance and reduce costs.
  • Wide Application: Suitable for applications such as RF‑IF down conversion in HF and VHF receivers, second mixer in base stations, DC baseband conversion, quadrature modulation and demodulation, and Doppler shift detection in imaging.
Check Stock

Analog CATV Tuner with RCA A/V Output for Cable TV Satellite Receiver

  • ... VHF/UHF channel support for CH2 to CH83 (471.25 MHz to 885.25 MHz) Great MATV setup solution for all public A/V broadcast, SMATV systems used in campus, classrooms, hotels, hospitals, sports bars or restaurants. Easy RF input replacement solution for those TVs with broken coax inputs..
  • External TV tuner add-on module for video monitors, projectors or DVR systems without RF inputs. Easy operation via IR remote or push buttons on the front panel. Provides convenient viewing access for coax signals coming from cable outlets or cable boxes with RF out, satellite receivers or modulated surveillance systems. Perfect for existing modulated cameras and works with quad video processors, multiplexers, and DVR's. Record TV channel, satellite TV RF out or camera channel through video reco.
  • Professional RF coax to RCA video demodulator for NSTC CATV and aerial UHF/VHF system. Digital LED screen for TV channel display on the front panel of the module to show users the TV channel selected..
  • Users have the option to remove the unwanted TV channels from the reception for parental control or other purposes. The deleted channel can be skipped when flipping channel up/down button and can always be added back if needed. Supports last channel memory after power-of....
Check Stock

High Frequency Transducer, Bandwidth Mixing Board Mixer Module -10dBm for Quadrature Modulation for Base Station for HF VHF Receiver

  • 【Important Data】: SSB noise figure (NF) of 9.75 dB--Input IP3: 28.5 dBm--Input P1dB: 13.3 dBm--Typical LO drive: 0 dBm--Power conversion gain of 1.8 dB.
  • 【Wild Used】: This 5V double balance up and down frequency mixer module is widely used for cellular base station receivers, Radio link down converters, Broadband block conversion, Instrumentation.
  • 【Low Power】: Our 130mA 50 Ohms Balun coil coupling frequency conversion mixer features adjustable bias for low power operation, so you can trust and use this RF mixer inverter with confidence.
  • 【Wonderful Components】: This 5V ADL5801 double balance up and down frequency mixer module is equipped with exposed paddle, 4mm x 4mm, 24-lead LFCSP package, so it will be an ideal choice for you.
  • 【Size】: Power supply: DC+5V@80mA(anti-reverse connection protection.)--RF_IN/RF_LO input frequency range: 10-6000Mhz--Input and output impedance: 50 ohm--Type:Input Balun coupling, Input/output Balun coupling(Optional)--Weight: Approx.15g/0.5oz.
Check Stock

Yaesu FT-60R Dual Band Handheld 5W VHF / UHF Amateur Radio Transceiver

  • Dual Band VHF/UHF 2 Meter & 70cm Amateur Radio..
  • CTCSS/DCS (PL & DPL), DTMF, AlphaNumeric Display, Lighted Keypad, Scan modes..
  • Receives 108-520Mhz and 700-999.99Mhz (less cell), Transmits 144-148Mhz & 430-470Mhz, Locking mode prevents accidental changes of frequency..
  • One Thousand memory Channels, NOAA Weather Alert, Receives Emergency channels in 800-900Mhz, RF Power Output: 5W (High) / 2W (Middle) / 5W (Low).
  • Includes 1400mA Battery, Charger, antenna & belt clip..
Check Stock

Spectrum Analyzer USB 35-4400M Signal Source RF Frequency Domain Black Analysis Tool with Tracking Source Module Industrial Supplies

  • RF Frequency Domain Analysis Tool. Sweep Bandwidth: 33mHz---4400mHz.
  • Turn on the tracking source output bandwidth 33mhz---3000mhz.
  • Made of fine quality material, the Spectrum Analyzer has a long service life. Small and portable, high accuracy.
  • Signal Source Spectrum Analyzer. Software used on the computer side: NWT4.11.09 version.
  • Computer operating system: Winxp, Win7, Win10.
  • 35-4400M Signal Tracking Source Module is an RF frequency domain analysis tool.
  • Signal Tracking Source Module with Shell. Sweep Step: ≥33-68.75mHz/125Hz, 68.75-137.5mHz/250Hz, 137.5-275mHz/500Hz, 275-550mHz/1kHz,....
Check Stock

CHENLAN Original Wireless RF Module PCB Board Power On/Off Circuit Board Replacement Part for Microsoft Xbox One Console

  • Original Wireless RF Module PCB Board Power On / Off Circuit Board.
  • Compatible with XBOX One console ONLY, NOT FIT for Xbox One Slim or Xbox One X consoles..
  • Please Double Check the Model Number of Your Device in Case of Wrong Part Ordered.
  • Perfect replacement part for faulty/broken/damage or worn out RF Module Board.No need for or Soldering connection cables. Just plug the proprietary connector into the motherboard, and screw into place..
  • Please Replace This Part Under Professional Guide(You can watch some tutorial video on YouTube)Please Make Sure No Man-Made Damage or Scratch when Returning.
Check Stock

RF Coax to HDMI DVI Demodulator Analog UHF VHF CATV Tuner for NTSC System

  • Decode all UHF/VHF channels, analog cable TV channels, satellite RF output and other modulated outputs. Supports all coax signals coming from cable....
  • Professional grade agile RF coax demodulator for converting the RF coax cable TV. External add-on TV tuner module for LCD TV, HD monitor/projector....
  • Premium de-Interlacer with low noise reduction technology adopted for clear and sharp images with fine details. [Note]: This is an analog TV tuner so....
  • Great RF coax to HDMI audio decoder for streamline setup with new home A/V receiver or home theater system. Easy operation control via IR remote....
  • Automatic video/audio gain control for compensating the input signal level variation for the best broadcast quality performance. Supports last channel....
Check Stock

Dpg-200 Vacuum Transducer with

  • -10dBm LO Power Consumption: Provides +24dBm third order intercept point, can achieve -10dBm LO power consumption, without high power LO drivers, there are no corresponding shielding and isolation problems, can improve system performance and reduce costs.
  • Single Power Supply: The mixer module is designed to be powered by a single power supply, and the RF, IF and LO ports have DC isolation capacitors for easy use.
  • 10.3dB SSB Noise Figure at 70MHz: With the output amplifier and optimal source impedance of this mixer module, the SSB noise figure is 10.3dB at 70MHz. There is no insertion loss, no external duplexer, and no passive termination.
  • Low Distortion and Wide Dynamic Range: AD831 is a low distortion, wide dynamic range, single chip mixer, very practical.
  • Wide Application: Suitable for applications such as RF‑IF down conversion in HF and VHF receivers, second mixer in base stations, DC baseband conversion, quadrature modulation and demodulation, and Doppler shift detection in imaging.
Check Stock

LORAWAN SX1262 LoRa TCXO Wireless Transceiver E22-900M22S SPI 868MHz SMD 915MHz SMD ebyte Transmitter Receiver rf Module

  • 【Practical】The large heat dissipation area can increase the continuous working time. High working frequency, increases the scope of application, strong practicality.
  • 【Brand New】100% brand new high quality right RF switch board, strictly full tested to ensure the best quality before shipment, safe to use.
  • 【High Quality】The RF switch module replacement is made of PCB material, corrosion‑resistant, anti‑oxidation, increased service life. Advanced manufacturing technology, high reliability and stable performance.
  • 【Easy Installation】The RD switch module is easy to install and convenient to use, can directly replacement for the old or broken one.
  • 【Note】For detailed product parameters, refer to the instructions. Please confirm whether the product is suitable for your equipment before ordering, wish you a happy life.
Check Stock