Categories

Best Ac Servo Motor Use

Adeept AD002 2 Pcs Compatible with MG90S 9G Micro Servo Motor, Metal Geared Micro Servo for RC Robot Car Helicopter Airplane Controls Boat Raspberry Pi Project

  • 【High Quality】100% new, good quality, AD002 Micro servo motor, Compatible with MG90 servo motor..
  • 【Full Metal Gear】 Metal gear with less noise,the metal gears help with the movement,these will rotate the proper direction..
  • Operating Speed: 0.11 seconds/60 degrees(4.8V).The servo Maximum angle is 180..
  • 【Wide Application】The great micro servo motors for helicopter/ boat / robot car / robot arm /remote controlled aircraft DIY. Fit for electronics DIY, compatible with Arduino, Raspberry Pi..
  • 【Service Guarantee】If you encounter any problems during use, please contact us, we will provide solutions to ensure your experience. We will reply within 24 hours.This AD002 servo motor is compatible with all Adeept robots..
Check Stock

Miuzei 10 Pcs SG90 9G Micro Servo Motor Kit for RC Robot Arm/Hand/Walking Helicopter Car Boat Control with Cable, Mini Small Servos for Arduino Project

  • Application Fields: Miuzei SG90 9G Servo Motor Compatible with Remote Control Helicopters, Micro Robot, Robot Arm and Boats. Support All Kind of R/C Toys and Arduino Experiments.
  • Interface Type: This SG90 Servo Compatible With JR & Futaba Interface. Miuzei Micro Servo 9g no Load Running Speed: 0.09±0.01 sec/60° at 4.8V.
  • Miuzei Micro Servo Motor Stall Torque (4.8V): 17.5oz /in (1kg/cm).
  • NOTE: The Starting Current of The Analog Servo Motor Should Be Over 1A and Miuzei Servo SG90 are Analog Servos Need to Continuously Provide a PMW Signal, Then it Will Be Work Normally.
  • How to Reach 180 degree -- Miuzei SG90 9g Servo Motor Need to Meet 4.8V Power Supply Voltage and 2500usec Pulse Signal, the Angle of Rotation.
Check Stock

FEETECH 35KG Servo Motor 360 Degree High Torque Digital Servo High Voltage Waterproof Metal Gear Aluminium Case for RC Helicopter Airplane Car Boat Robot Controls - FT6335M

  • HIGH QUALITY SERVO: FT6335M servo motor is composed of a sturdy PA aluminum middle shell, a strong steel metal gear, and a hard iron shaft, provide higher stability and provide longer service life..
  • GREAT COMPATIBLE MOTOR: The servo motor system is controlled by pulse, compatible with 1/8 and 1/10 scale RC robots, trucks, off-road vehicles, robotic arms, and any application that uses a standard servo system..
  • SERVO PROTECTION MECHANISM: The steering gear has IP54 waterproof performance and ball bearings.The output torque exceeds the overload torque, lasts 8S, or the temperature over 70 ℃, the steering gear will automatically stop the output torque. The overload torque can be modified..
  • HIGH ROTATION SPEED SERVO: A high-torque servo, the rotation angle is 360 degrees (at 500→2500μsec), when the power is stopped, it can rotate 360 degrees. Dead width ≤ 4 μsec. Durable and reliable..
  • STRONG STALL TORGUE MOTOR: The operating voltage range is 4V-8.4V, the stall torgue is (6V) 400.65oz/in(28.8kg/cm), (7.4V) 493.86oz/in(35.5kg/cm). The servo size is 55X20x43mm..
Check Stock

4Pcs MG996R Servo Metal Gear Torque Digital Servo Motor for Smart Car Robot Boat RC Helicopter

  • MG996R Micro Servo motor, which updated from SG90 Micro Servo and MG90S micro servo motor. The speed, tension and accuracy all increase..
  • Compatible with most standard receiver connector: Futaba, Hitec, Sanwa, JR..
  • Torsional moment: 12kg/cm(6V), 13kg.cm.at(7.2V).
  • Stable and shock proof, metal gear, connector wire length 300mm..
  • Micro Servo Motor for 1:10 RC car robot helicopter servo remote controlled aircraft for DIY..
Check Stock

SEEU. AGAIN 5pcs 25T Metal RC Servo Arm Horn Aluminum M3 Threads Steering for Savox Xcore Power HL HD Servo Motors

  • Type: 5pcs Black 25T Aluminum Servo Horn Arm, Ideal Servo Accessories for Hobby Projects DIY. Suitable for power HD servos..
  • Material: Made from high quality Aluminum alloy, CNC machined for high precision, anodized finish lasting performance. Hard construction, more durable in use..
  • Special Design: Single sided arm style with 3 predrilled starter holes, 2 threaded linkage holes for adjustable pull rod position, straight arm design for more accurate and powerful turn..
  • Each steering arm come with 2 fastening screw bolts for spline locking, to secure the split-clamp onto the servo motor output..
  • Fit for most standard and high torque servo motor, MG995, MG996R, MG946R, S3003 etc. RC Model Motor..
Check Stock

ALAMSCN 5PCS SG90 9g Servo Motor + 16 Channel PWM Servo Motor Driver PCA9685 IIC Module 12-Bit DIY Kit for RC Robot Arm Helicopter Airplane Car Boat Remote Control for Arduino for Raspberry pi

  • These SG90 9G micro servo motors have a completely new redesigned PCB and control system to provide more accuracy..
  • Its internal gearing and motor are also upgraded to improve dead bandwidth and centering..
  • For SG90 9G micro servo motor is far more accurate and safe to use in aircraft which require precise servo movements and perfect centering..
  • Apply to remote control helicopters, micro robot, robot arm and boats. Fit for ALL kind of R/C Toys and also make electronics DIY based on Arduino ,Raspberry Pi..
  • Package includes: 5PCS SG90 9g Micro Servo + 1PC PWM Servo Motor Driver. Cost-effective kit to meet your DIY needs..
Check Stock

ACEIRMC SG90 Servo Motor Micro Servo 9G Servo Motor for RC Robot Arm Helicopter Airplane Remote Control (5 Pcs) (5pcs)

  • SG90 9G micro servo motor for remote control helicopters, micro robot, robot arm and boats. Fit for ALL kind of R/C Toys and also make electronics DIY based on compatible for Arduino ,Raspberry Pi.
  • The SG90 mini servo motor is lightweight, high-quality and lightning-fast.The servo is designed to work with almost all the radio control systems..
  • SG90 Micro Servo Motor compatible for Mini Arduino Servo SG90 9g Servo Kit for RC Helicopter Airplane Car Boat Robot Arm/Hand/Walking/Servo Door Lock Control with Cable.
  • The SG90 has 3 wire interfaces in which the connections should be made as follows: Red wire-5V, Brown Wire-Ground, Yellow wire-digital pin 9..
  • Stall Torque (4.8V): 17.5oz /in (1kg/cm).
Check Stock

FEETECH 35KG Servo Motor 7.4V High Voltage Waterproof High Torque RC Servo Full Metal Gear Digital Servo, Aluminium Case, Control Angle 180° for 1/8 1/10 RC Cars, TRAXXS x4, Baja, RC4WD, GTR and More

  • HIGH QUALITY SERVO: FT5330M servo motor is composed of a sturdy PA aluminum middle shell, a strong steel metal gear, and a hard iron shaft, provide higher stability and provide longer service life..
  • GREAT COMPATIBLE MOTOR: The servo motor system is controlled by pulse, compatible with 1/8 and 1/10 scale RC robots, trucks, off-road vehicles, robotic arms, and any application that uses a standard servo system..
  • SERVO PROTECTION MECHANISM: The steering gear has IP54 waterproof performance and ball bearings.The output torque exceeds the overload torque, lasts 8S, or the temperature over 70 ℃, the steering gear will automatically stop the output torque. The overload torque can be modified..
  • HIGH ROTATION SPEED SERVO: A high-torque servo, the rotation angle is 180 degrees (at 500→2500μsec), when the power is stopped, it can rotate 360 degrees. Dead width ≤ 4 μsec. Durable and reliable..
  • STRONG STALL TORGUE MOTOR: The operating voltage range is 4V-8.4V, the stall torgue is (6V) 400.65oz/in(28.8kg/cm), (7.4V) 493.86oz/in(35.5kg/cm). The servo size is 55X20x43mm..
Check Stock

Electric CNC Linear Stage Actuator Linear Rail 200mm Stroke Cross Sliding Table SFU1605 Ballscrew C7 Slide Module for CNC Engraving Machine

  • 1. Motor seat can be replaced by Handwheel.
  • 2. It can be equipped with hand wheel, stepper motor, servo motor, AC motor, DC motor.
  • 3. It can organize cross, vertical, three-axis, four-axis gantry structure.
  • 4. The cushion is added before and after the sliding table to extend the service life of the sliding table..
  • 5. The front end increases the diagonal bearing seat, the sliding table has high precision and better stability..
Check Stock

[4-Pack] MG996R 55g Metal Gear Torque Digital Servo Motor for Futaba JR RC Helicopter Car Boat Robot

  • This MG996R Servo motor which updated from SG90 and MG90S micro servo motor. (the Speed, Tension and Accuracy all increase).
  • The MG996R model compliant with most standard receiver connector,for Futaba, Hitec, Sanwa, GWS etc..
  • Power Supply: Through External Adapter. Stable and Shock Proof. Coreless Motor , Metal Gear ..
  • Torque at 6V 12kg/cm, 7.2V 13kg/cm.(Recommended voltage: 5V, current usage: 3A ). Positioning speed at 4.8V without load 0.17s / 60 degrees.
  • Universally Applicable: Micro Servo Motor for 1:10 RC car robot helicopter servo remote controlled aircraft and suitable for most DIY projects..
Check Stock

[2-Pack] MG996R 55g Metal Gear Torque Digital Servo Motor for Futaba JR RC Helicopter Car Boat Robot

  • The MG996R model compliant with most standard receiver connector,for Futaba, Hitec, Sanwa, GWS etc..
  • This MG996R Servo motor which updated from SG90 and MG90S micro servo motor. (the Speed, Tension and Accuracy all increase).
  • Power Supply: Through External Adapter. Stable and Shock Proof. Coreless Motor , Metal Gear ..
  • Torque at 6V 12kg/cm, 7.2V 13kg/cm.(Recommended voltage: 5V, current usage: 3A ). Positioning speed at 4.8V without load 0.17s / 60 degrees.
  • Universally Applicable: Micro Servo Motor for 1:10 RC car robot helicopter servo remote controlled aircraft and suitable for most DIY projects..
Check Stock

RGBZONE 6Pcs MG90S 9G Geared Micro Servo Motor for Remote Control Helicopter Airplane Boat Smart Robot Car Micro Robot

  • MG90S micro servo motor, updated SG90 serve motor..
  • Mini micro Servo 450Dead band width: 10usec..
  • Fit for ALL kind of R/C Toys and also make electronics DIY based on Arduino ,Raspberry Pi, etc..
  • Gear Micro Servo Motor For robot Plane Helicopter Boat Car Horns servo Remote controlled aircraft for DIY..
  • The model is suitable for ordinary small electric aircraft models and is not recommended in large fixed wing and electric helicopter..
Check Stock

DWEII MG995 Servo Motor Control 180 Angle Metal Gear Servo 20KG Digital High Speed Torque Servo Motor for Smart Car Robot Boat RC Helicopter Pack of 3

  • Stall torque: 12kg/cm(6V), 13kg/cm(7.2V). Recommended voltage: 5V, current usage: 3A.
  • Application: Analog Servo Motor Great for RC Helicopters, Micro Robots,Robotic Arms and RC Rock Crawler, RC Boat Motor,Truck, Boat, Racing Car,Various Remote Control Toys.
  • Dimension:40.7*19.7*42.9mm(1.6*0.78*1.69in).
  • This high-speed standard servo motor can rotate 180 degrees (90 in each direction)..
  • Good performance digital standard servo, which can be a common use for robots, mechanical arms, climbing cars and remote control toys..
  • Compatible with most standard receiver connector.
Check Stock