Categories

Best Aluminum Cathode

5mm Super Bright Piranha LED - RGB - Common Cathode (Pack of 20)

  • 5mm Super Bright Piranha LED - RGB - Common Cathode (Ships from US).
  • Size: 5mm Piranha / Superflux LED, Color: Red/Green/Blue (RGB), Luminosity: 9,000-11,000 mcd.
  • Forward Voltage: R(1.8-3.5) B(3.0-3.5) G(3.0-3.5), Current: 20mA, Wavelength: N/A RGB Common Cathode.
  • Viewing Angle: 100-120 Degrees, MountStyle: Through Hole (DIP), Lens Color: Clear.
  • Super bright LEDs, used for mods, RC, adruino, cars, HO Scale models, planes, trucks, adafruit projects, halloween, christmas, PC, Ultra Light, etc....
Check Stock

4Pcs MAX7219 8 Digit 7 Segment LED Tube Display Control Module for MCU/51/AVR/STM32

  • MAX7219 is an integrated serial input / output common-cathode display driver, which connects your microprocessor to a 7-segment digital LED display with 8 digits.This module is compatible with 5V and 3.3V microcontrollers, and you you can use it.
  • Material: PCB+Electronic components, LED color: Red.
  • Only three IO ports are used to drive the eight digit display. MAX7219 supports flicker free displays as well as cascading displays. PCV board four corners of the fixed copper stud, which can effectively precent short circuit accidents happen..
  • Wiring instructions (take the provided program as an example, you can pick any IO port definition can be modified in the program): VCC to 5V, GND to GND, DIN to P00, CLK to P02, CS to P01.
  • Digital tube is 0.36 inch 4-bit integrated cathode digital tube.
  • Note: VCC and GND should not be connected reversed, so as not to burn the chip.
  • 51 MCU P0 port requires pull-up resistor, if your device does not have a pull-up resistor can be connected to other ports data lines..
  • A convenient four-wire serial interface can connect all common microprocessor. Each data can be addressed in the update without rewriting all displays. MAX7219 also allows the user to select each data encoding or no coding..
Check Stock

DAOKI 10PCS LED Display 7 Segment 1Bit 2Bit 3Bit 4Bit Common Cathode 10PIN Red Light for Arduino,DIY + Jump Wire

  • Type:Common Cathode(Note:5643 Series may be Common Cathode or Common Anode, Be suject to part number).
  • Five different LED Display 7 Segment are available to satisfy your different needs..
Check Stock

SEEU. AGAIN 4pcs 8-Digit 7 Segment Module MAX7219 8 Bit Digital Segment Tube LED Display Module Supports Cascade Eight Bit Serial 3 IO Ports for MCU/51/AVR/STM32

  • MAX7219 is an integrated serial input / output common-cathode display driver, which connects your microprocessor to a 7-segment digital LED display with 8 digits.
  • MAX7219 digital display control module, you can use it..
  • The module is compatible of 5V / 3.3V microcontroller.
  • Only three IO ports are used to drive the eight digit display..
  • Only three IO ports are used to drive the eight digit display. MAX7219 supports flicker free displays as well as cascading displays.
  • PCV board four corners of the fixed copper stud, which can effectively precent short circuit accidents happen..
  • Wiring instructions (a program, for example, you can pick any IO port definition can be modified in the program): VCC to 5V, GND to GND, DIN to P00, CLK to P02, CS to P01.
  • Digital tube is 0.36 inch 4-bit integrated cathode digital tube.
  • Note:VCC and GND do not reversed, it would burn the chip.51 MCU P0 port requires pull-up resistor, if your device does not have a pull-up resistor can be connected to other ports data lines..
Check Stock

Aluminum Zinc Hex Head Flexible Anode Rod (.800" x 3/4" x 44") - Stops Rotten Egg Smelly Water! …

  • Sacrificial anode rod for water heater tank made from aluminum-zinc alloy cures rotten egg (sulfur) smell in hot water..
  • Replaces water heater tank’s existing magnesium anode rod (hex head only)..
  • Eliminates rotten egg smell in hot water caused by hydrogen sulfide gas (H2S) and extends service life of water heater tank..
  • Segmented flexible design for easy installation.
  • can be cut to length to fit different size heaters..
  • Not recommended when water softener is in use (use a powered anode/cathode instead)..
Check Stock

DC 5-12V/15-160V Stepper Motor Drive,PWM Adjustable Stepper Motor Controller Signal Generator Speed Regulator

  • Power supply: 15-160VDC or 5-12VDC. If you are using 5-12VDC power, positive end connect DC 5-12V Input, negative end connect Common Cathode End..
  • 3 Frequency: High: 5.8KHZ-127KHZ, Mid: 590HZ-15.8KHZ, Low: 82HZ-2.3KHZ.
  • To control the stepper motor, mus connect to the driver.
  • PUL + and PUL- pulsed positive and negative.
  • EN + and EN- is to enable the positive and negative terminals.
  • DIR + and DIR- are the positive and negative directions..
  • Frequency of measurement can amount PUL and common cathode terminal (GND) two ports..
Check Stock

uxcell Common Cathode 10 Pin 1 Bit 7 Segment 1.1 x 0.79 x 0.35 Inch 0.55\ Red LED Display Digital Tube 10pcs

  • Panel Size: 19 x 12.7 x 8mm / 0.75" x 0.5" x 0.31" (L*W*H).
  • Total Size: 19 x 12.7 x 14mm / 0.75" x 0.5" x 0.55" (L*W*H).
  • Package Content: 10 x LED Digital Display Tube.
Check Stock

uxcell Common Cathode 10 Pin 2 Bit 7 Segment 1.41 x 1.02 x 0.39 Inch 0.8\ Red LED Display Digital Tube 2pcs

  • Panel Size: 35.8 x 25.8 x 10mm / 1.41" x 1.02" x 0.39" (L*W*H).
  • Total Size: 35.8 x 25.8 x 14mm / 1.41" x 1.02" x 0.55" (L*W*H).
  • Package Content: 2 x LED Digital Display Tube.
Check Stock

uxcell Common Cathode 10 Pin 2 Bit 7 Segment 0.59 x 0.55 x 0.28 Inch 0.35\ Red LED Display Digital Tube 5pcs

  • Panel Size: 15 x 14 x 7.2mm / 0.59" x 0.55" x 0.28" (L*W*H).
  • Total Size: 15 x 14 x 13.5mm / 0.59" x 0.55" x 0.53" (L*W*H).
  • Package Content: 5 x LED Digital Display Tube.
Check Stock

uxcell Common Cathode 12 Pin 4 Bit 7 Segment 1.18 x 0.55 x 0.28 Inch 0.35\ Red LED Display Digital Tube 5pcs

  • Panel Size: 30 x 14 x 7.2mm / 1.18" x 0.55" x 0.28" (L*W*H).
  • Total Size: 30 x 14 x 13.5mm / 1.18" x 0.55" x 0.53" (L*W*H).
  • Package Content: 5 x LED Digital Display Tube.
Check Stock

uxcell Common Cathode 11 Pin 3 Bit 7 Segment 0.89 x 0.55 x 0.28 Inch 0.35\ Red LED Display Digital Tube 5pcs

  • Panel Size: 22.5 x 14 x 7.2mm / 0.89" x 0.55" x 0.28" (L*W*H).
  • Total Size: 22.5 x 14 x 13.5mm / 0.89" x 0.55" x 0.53" (L*W*H).
  • Package Content: 5 x LED Digital Display Tube.
Check Stock

Apera Instruments, LLC-AI1312 Apera Instruments 201T-S pH/Temp. Electrode, 8-pin Connector, The Replacement Electrode for Apera 400/400S Series Portable Meters

  • 3.Glassy carbon electrode is one of the widely used working electrodes. It is a good inert electrode with good conductivity, high hardness, high finish, high hydrogen overpotential, wide polarization range and chemical stability. It can be used as inert electrode for anodic stripping, voltammetric determination of cathode and variable valence ions, and can also be used as chemically modified electrode.
  • 4.The glassy carbon surface must be mirror and clean. Since the surface of glassy carbon is easily polluted by some organic metal compounds, which seriously affects the measurement (no peak, no impurity peak and no recurrence), it must be cleaned before measurement.
  • 5.There are three main maintenance methods, chemical method 1. Nitric acid immersion and scrubbing. 2. Soak and scrub with ammonia water, anhydrous ethanol or acetate 1:1. 3. It can also be scrubbed with alcohol and then soaked in 6nhcl or 4nho3. Electrochemical treatment: repeated polarization (reset scan) (anode cathode to cathode) in the voltage range of + 0.8V - (- 1.8V (0.5mkclph7 except o2i).
Check Stock

GOONSDS Tungsten Filament 99% Purity Tungsten Metal Wire Coil,Length 1m,Diameter 0.04mm

  • Purity: W ≥ 99% . Dimensions: diameter:0.04-0.1mm(Buy on demand) , length:1m. Package: 1 x Tungsten wire.
  • Tungsten and its alloys are widely used in electronics and power industry because of its strong plasticity, low evaporation rate, high melting point and strong electron emission ability. For example, due to its high luminous efficiency and long service life, tungsten filament is widely used in the manufacture of various bulb filaments, such as incandescent lamp, iodine tungsten lamp, etc,.
  • Tungsten wire is used to make direct hot cathode and grid of electronic oscillator tube and side hot cathode heater in various electronic instruments. The properties of tungsten make it suitable for TIG welding and other electrode materials similar to this kind of work..
  • It is widely used in aerospace, aviation, oil drilling, electrical instrument and other industries, such as manufacturing heat sink, balance weight of control rudder and contact materials of switch, circuit breaker, spot welding electrode, etc..
  • We are a supplier of high quality metal materials. We can provide you with the materials you need. You can contact us to get any materials you need.
Check Stock