Best Arduino Antenna Tracker
HiLetgo NEO-7M GPS Satellite Positioning Module for Arduino STM32 C51 Replace NEO-6M 3.3V/5V Power Supply
- 1.Get 51 Arduino STM32 microcontroller routine..
- 2.With a USB interface, you can watch the computer positioning effect directly phone line..
- 3.With the passive ceramic antenna and passive antenna amplifier, make better use of the individual effects..
- 4.With SMA interface can be directly connected to an active antenna SMA..
- 5.TTL level, compatible with 3.3V/5V systems.(Size:39*25.5mm).
Check StockALMOCN 4 Set 433MHz RF Wireless Transmitter and Receiver Kit High Frequency Super Regenerative Transceiver Module for Arduino Raspberry pi
- Great influence on the antenna module reception, preferably connected to the 1/4 wavelength of the antenna, typically 50 ohm single conductor. The....
- Wireless Transmitter Modules allow your Arduino to wirelessly comunicate with other arduinos, or with radio frequency (RF) controlled devices that....
- Antenna position has also affected the reception of the module, the installation, the antenna as possible straight away from the shield, high....
- Frequency used to receive, decode and oscillation resistor should match with the transmitter..
- Application:Usually used for remote control systems, such as Remote control rolling gates, smart car, smart home, etc..
Check StockMIDLAND 75-785 4 WATT HANDHELD CB RADIO
- ...st signal automatically, with 40 channels to chose from. You won't have to manually search for a strong signal again..
- Dual watch - select two channels to constantly monitor simultaneously. Keep an ear open for incoming transmissions on multiple channels so you will hear alerts around you..
- MAGNETIC MOUNT MOBILE ANTENNA - Allows mobile operation from your vehicle. Mount the magnetic antenna to the roof of your car and use your radio easily from inside your vehicle..
- SOUND TRACKER SYSTEM - Don’t miss any important information due to interference or static, with the Sound tracker system cutting 90% of the noise, you'll hear crystal clear communication.
- 10 NOAA WEATHER CHANNELS - Be the first to know of incoming hazards or changing weather w/ instant access to NOAA weather channels 24 hours a day and audible tone if an emergency or threatening weather is nearby while monitoring up to 3 channels at once.
- DUAL WATCH - select two channels to constantly monitor simultaneously. Keep an ear open for incoming transmissions on multiple channels so you will hear alerts around you..
Check StockBotletics SIM7000 LTE CAT-M1 NB-IoT Cellular + GPS + Antenna Shield Kit for Arduino (SIM7000A)
- Operates on LTE CAT-M1 and/or NB-IoT technology + GPS + temperature sensor.
- Directly compatible with Arduino Uno, Mega, and Leonardo + easy connection for other logic voltages.
- Ultra low-power mode drawing < 8uA, ideal for battery-powered IoT devices + LiPo battery charging.
- Kit includes dual flexible LTE/GPS antenna and stacking female header kit.
- Detailed documentation, wiki, Arduino library, and code examples on Github + community forum to ask questions.
Check StockXimimark NEO-7M UBLOX GPS Satellite Positioning Module with SMA Antenna Interface for Arduino STM32 C51 Replace NEO-6M 3.3V/5V Power Supply 1Pcs
- Get 51 Arduino STM32 microcontroller routine..
- with a USB interface, you can watch the computer positioning effect directly phone line..
- with the passive ceramic antenna and passive antenna amplifier, make better use of the individual effects..
- with SMA interface can be directly connected to an active antenna SMA..
- TTL level, compatible with 3.3V/5V systems..
Check StockACEIRMC ESP32 ESP-32S Development Board 2.4GHz Dual-Mode WiFi Bluetooth Dual Cores Microcontroller Processor Integrated with ESP32s Antenna RF AMP Filter AP STA for Arduino IDE (3pcs)
- 1.ESP-WROOM-32 ESP32 ESP-32S Development Board 2.4GHz Dual-Mode WiFi + Bluetooth Dual Cores Microcontroller Processor Integrated with Antenna RF AMP Filter AP STA for Arduino IDE.
- 2.Ultra-Low power consumption, works perfectly with the for Arduino IDE.
- 3.SupportThree Modes: AP, STA, and AP+STA.
- 5.ESP32 is a safe, reliable, and scalable to a variety of applications.
Check StockGY-NEO6MV2 New NEO-6M GPS Module NEO6MV2 with Flight Control EEPROM MWC APM2.5 Large Antenna for Arduino Color Antenna
- GPS modules NEO-6M,3V-5V power supply Universa.
- GPS Module with Flight Control EEPROM MWC APM2.5 Large Antenna for Arduino.
- Module size 25mm*35mm,Antenna size 25*25mm.
- Compatible with various flight control modules that provide GPS computer test software.
Check StockAorkuler GPS Dog Tracker, Pet Tracker No Monthly Fee No Subscription, Dog Tracker Without Cellular Networks,Real-Time Tracking Device for Dog and Pets, Dog Tracker Without Mobile Phones
- ... Aorkuler Dog Gps Tracker Up To 3.5 Miles In An Open Environment : The tracking radius can be up to 3.5 miles in an open environment and 0.65 miles in downtown/dense space. Aorkuler Dog GPS tracker Use the Low power and long-range wireless technologies with high-precision RF, GPS chips, High sensitivity antenna and optimized design..
- Up to 8H Continuous Real-Time Tracking : Take your beloved dog to go outside and Real-Time Tracking for a Whole Day,different from traditional 4G/5G GPS pet tracker,Aorkuler GPS Dog Tracker is a real-time tracking mode without delay of cellular network,not a positioner.With stronger built-in battery and optimized algorithms, Aorkuler pet tracker Continuous Real-Time Tracking up to 8H..
- Simpler and Easier Real-Time Dog Tracker, Not Traditional 4G Positioner : Aorkuler GPS Dog Tracker With such a simple screen design, say goodbye to the complicated steps and the complex maps. Find whatever you’ve lost, with ease! Gives a strong sense of security and is always reliable..
Check StockAURSINC WiFi Deauther & Bad USB Watch V4 ESP8266 & Atmega32u4 Programmable Development Board | Attack/Control/Test Tool | LOT DSTIKE for NodeMCU Arduino Leonardo | 1000mAh Rechargeable Battery
- ... same watch, which is more powerful and capable than the former version DSTIKE deauther watches.
- There are empty solder pads at the back of this watch which can be soldered to connect ESP8266 with atmega32u4. For example if you solder IIC pads this watch could become a wifi duck.
- [Added Atmega32u4 - Bad USB] Flashed Arduino Leonardo bootloader already, the D&B watch can be programmed as bad usb directly. Two buttons(Digital pin 9 and 10) could be used to execute different commands. Moreover, a demo program has been flashed as well. Therefore when bad usb port connects PC, press DP9 button cmd window will be opened. Press DP10 button Notepad will be opened. Which can be programmed via Arduino IDE.
- [Improved Battery Capacity - 800 to 1000mAh] Compared to Deauther watch V3, this deauther and bad usb watch V4 has been upgraded the battery capacity from 800mAh to 1000mAh, which will have a longer battery life and the fun will last longer.
- Note: there are two usb ports on the watch, and each one could be used to charge battery, but do not suggest to use them at the same time.
Check StockSparkFun Pro RF - LoRa, 915MHz (SAMD21) - Wireless Board Easy-to-use IoT Qwiic Enabled microcontroller 915MHz ISM Band Reinforced Micro-B USB Connector Included u.FL Antenna Connector
- A LoRa-enabled wireless board that marries a SAMD21 and a long-range RFM95W to make a compact and easy-to-use IoT board. Compatible with Arduino..
- A short (3 inch) wire antenna is sufficient for "short" distances (up to 1 mile line-of-sight), but we've also included a u.FL antenna connector for potentially longer distances..
- SAMD21G18A, Cortex M0+, 256KB Flash Memory, 32MHz External Oscillator, 4 Digital and 5 Analog IO Pins with exclusive GND pins.
- Hope RFM95W LoRa modem, Point to Point Radio capabilities, LoRa Enabled, Frequency range: 915 MHz, Spread factor: 6-12, Range up to 1 mile line of sight, U.FL Antenna.
- LiPo Battery Charger, 500mA Charge Rate. Qwiic Enabled. Power LED disconnect jumper for low power applications. PTH pins for software debug (SWD).
Check StockPet GPS Tracker for 1-3 Dogs,No Monthly Fee,Real-Time Tracking Device,Activity Monitor(Only for Dog,3 Dogs Track at Most)
- ...TRACKING: The mobile app of Petfon GPS Tracker is easy to install and intuitive to use. Just download the Petfon app and follow the instructions. The entire setup process only takes minutes. With the app, you can view your pet's activities and pinpoint his location at any time. The embedded high-gain, laser carving antenna amplifies signal making it capable of tracking up to 0.65 miles in downtown/dense space and 3.5 miles in an open environment..
- GEOFENCING,MULTICOLOR ALERT,CUSTOMIZABLE VOICE COMMAND: With Petfon GPS tracker You can define a safe area around your pet's location and get notified instantly if your pet leaves that area. You can also activate the colorful lights on the GPS tracker (which can be attached to your current collar) to locate your pet more easily in dim light or at night time. Voice commands can be recorded and stored on the tracker to communicate with your pets remotely..
- RAINPROOF,LONG STANDBY TIME: The Petfon GPS tracker is small and durable (1.65 IN* 1.65 IN* 0.7 IN). The waterproof feature enables it to work in wet weather. Petfon GPS Tracker's battery can last up to 8-16 hours and comes with a compact charging station. It can recharge the device multiple times, which is essential for great activities that span a couple of....
Check StockHiLetgo 5 Sets 433M Transmitter + Receiver Kit High Frequency Super Regenerative Transceiver Module for Burglar Alarm
- Easy to use, nice range (using antenna on both), you can send strings (text) from one point to another. If you want to automate your house without....
- Wireless Transmitter Modules allow your Arduino to wirelessly comunicate with other arduinos, or with radio frequency (RF) controlled devices that....
- They work in pairs, meaning you need both a receiver and a transmitter to comunicate with each other.
- Compatible with SparkFun’s 434MHz RF transmitter and RF receiver.
- This Radio Transmitter & Receiver pair is perfectly matched to allow you to control items from a distance up to 500 feet wirelessly!.
Check StockAEDIKO 2pcs 4G LTE Antenna 7dBi Magnetic Base Antenna RP- SMA Male Antenna for 4G LTE Cellular Router Gateway Modem Hotspot
- Frequency Range: 698-960 MHz, 1710-2170 MHz, 2300-2700 MHz.
- Easy to Install: Radio Antenna Come With Magnetic Base Can Installs On Any Metal Surface And With RP-SMA Male Connector, You Do NOT Need To Install Any Drivers. Just Screw It To The Connectors of Your Device and Antenna Runs.
- Compatible with 4G LTE Mobile Router, Mobile Broadband Modem Hotspot, Cellular Gateway, Vehicle Car Truck RV Bus Van Mobile Cellular.
- Compatible with 4G LTE Cellular Trail Camera, Game Camera, Hunting Camera, Outdoor Security Camera, Celluar Surveillance Camera.
- Vehicle 4G LTE Tracker, Real Time Monitor, Mobile Vehicle Car DVR MDVR Video Recorder.
- Compatible with Industrial 4G LTE Router, Cellular IoT Gateway, 4G LTE M2M Terminal, Cellular Embedded Module, Remote Metering and SMS Alarm, Remote Relay Gate Opener Switch, Vending Machine, Digital Signage, Delivery Locker, Cellular Temperature Humidity Sensor Monitoring System,Wireless Security Sensor Motion Detector Alert.
Check Stock