Categories

Best Bolted Fixing

Steel Flat Washer,900pcs M3-M10 A3 Plain Washers Assortment Kit with Box for Distribute Load of Threaded Fastener

  • ✔【 Rational Design】- The washer is a thin disk-shaped plate with a hole in the middle that is normally used to distribute the load of a threaded fastener, such as a screw or nut..
  • ✔【Function 】- These washers can be used as a spacer, wear pad, pre-load indicating device, locking device, and to reduce vibration..
  • ✔【Meet Your Need 】- Each set includes many flat washers that can be used for a long time, flat washer is applied when the hole is a larger diameter than the fixing nut..
  • ✔【Usage 】- High-quality bolted joints require hardened steel washers to prevent the loss of pre-load after the torque is applied..
  • ✔【Characteristic 】- The washers are also important for preventing galvanic corrosion, particularly by insulating steel screws from aluminum surfaces..
Check Stock

Goldring 1042 MM Moving Magnet Phono Cartridge

  • ...ility and user-replacement stylus assembly allowing the immediate replacement of worn or damaged Styli..
  • The four 1000 Series cartridges all share the same strong, one-piece body made from Pocan, an ultra-rigid glass-reinforced polyester. All fixed parts can be held securely in place and the body can be tightly bolted to the headshell..
  • The 1000 Series are each endowed with a highly efficient magnetic circuit which makes for a smooth and extended frequency response. As with all Goldring cartridges, the 1000 Series is rigorously tested to ensure optimum standards of performance and reliability..
  • Frequency Response: 20Hz-20kHz±3dB Channel Balance: 2dB @ 1kHz Channel Separation: 25dB @ 1kHz Sensitivity: 6.5mV±1.5dB, 1kHz @ 5 cm/sec Static Compliance: 24mm/N lat., 16mm/N vert Equivalent tip mass: 0.45 mg Vertical Tracking Angle: 24° Stylus Radius: Gyger S Stylus Type: Replaceable Load Resistance: 47,000 Ohm Load Capacitance: 150-200pF Internal Inductance: 570 mH Internal Resistance: 660 Ohm Cartridge Weight: 6.3g Fixing Center: 12.7mm Playing Weight: 1.5-2.0g (1.7g nom.).
Check Stock

Cab Level 6'6

  • Extruded aluminum octagon roller axle telescope to exact bed width.
  • Cast bearings bolted to the mounting brackets. Through Bolted Handle and Flip lever locking device to keep tarp axle from un-rolling.
  • 6'6" x 14' Black Mesh Tarp with Double-stitched hem with 2in. nylon webbing.
  • Full perimeter brass grommets every 24" NOTE: MESH TARP IS BLACK not MultiColor as seen in some pictures!.
  • RETENTION BOW IN PICTURE IS OPTIONAL!!!!! Part No. ATP1010.
Check Stock

Harmar Mobility AL 065 Electric Scooter or Wheelchair Lift Power Chair Lift

  • (1) Carrier model 210 + (1) Swing Away Joint model 130..
  • Shipped assembled and ready to be bolted to Vehicles Hitch..
  • Two bolted on retractable ratchets for securing scooter or power chair..
  • Built in angle on platform to allow for a smoother ride while transporting your mobility unit..
Check Stock

Midwest Rake 40948 LF-40 Spring Brace Rake with 54\ Yellow Fiberglass Handle, 24 Tine 24\ Steel Head

  • Double through-bolted head-to-handle connection.
  • 24" head with 24 heavy-duty steel continuous tines.
  • 54" Extra-reach fiberglass handle with 6" vinyl grip.
Check Stock

FARRAY Wood Screws, 224pcs Wood Screws Assortment Kit, Galvanized Carbon Steel Phillips Screw Set, Round Head Screws, Assorted Screws, Assorted Wood Screws, Screw Set Assortment, Self Tapping Screws

  • What You Get: we will provide you with 120 white screws for wood, including 3 sizes, each size has 40 pieces, enough to meet your daily using and replacing needs.
  • Warm note: if these truss head screws loosen during use, it is mainly caused by the compression of the supporting surface, the radial force of the bolted connection, or the initial loosening.
Check Stock

Honeywell V5011N2089 1 2\ 2-Way F-NPT Globe Valve

  • Class 800 inline globe valve with non-rising stem and bolted bonnet for on/off actuation and flow control (throttling) in a pipeline.
  • Carbon steel valve body for tensile strength and hardness.
  • Bolted bonnet for tight assembly and reduced risk of leakage.
  • Socket-weld ends for welding to unthreaded pipes.
  • Maximum working pressure of 200 pounds per square inch (psi).
Check Stock

ALL TRUCK PRODUCTS (5' X 12') Dump Truck and Trailer Tarp Kit

  • Extruded aluminum octagon roller axle telescope to exact bed width.
  • Cast bearings bolted to the mounting brackets. Through Bolted Handle and Flip lever locking device to keep tarp axle from un-rolling.
  • Black Mesh Tarp with Double-stitched hem with 2in. nylon webbing.
  • Full perimeter brass grommets ever 24" NOTE: MESH TARP IS BLACK. Note: IN MOST CASES THE TARP SHOULD NOT BE WIDER THAN THE WIDTH BETWEEN THE MOUNTING BRACKETS!.
  • RETENTION BOW IN PICTURE IS OPTIONAL!!!!! Search for ATP1010 Retention Bow.
Check Stock

Telescoping Boat Ladder Stainless Steel Slide Mount Under Platform Marine

  • 【HIGH QUALITY】 stainless steel construction can withstand harsh marine conditions and easy to maintain..
  • 【MORE PROTECTION】 black non-slip threads on the steps will give your safety an extra layer of protection..
  • 【TELESCOPIC DESIGN】 can slide smoothly, which is easy to open when used, and it can fully save space on the boat when not used..
  • 【MULTI-POSITION INSTALLATION】 made to be bolted to a horizontal platform such as boat floor or side railings depending on the installation..
  • 【APPLICATION】:This telescopic boat ladder is made to be bolted to a horizontal platform such a the boat floor or side railings depending on the installation. The design of this platform ladder makes it possible to be used as on a pontoon boat..
Check Stock

ALL TRUCK PRODUCTS Dump Truck and Trailer Tarp Kit Manual Pull Hand Crank Hexagon Axle w/wo Mesh Tarp

  • Extruded aluminum octagon roller axle telescope to exact bed width.
  • Cast bearings bolted to the mounting brackets. Through Bolted Handle and Flip lever locking device to keep tarp axle from un-rolling.
  • Black Mesh Tarp with Double-stitched hem with 2in. nylon webbing.
  • Full perimeter brass grommets ever 24" NOTE: MESH TARP IS BLACK. Note: IN MOST CASES THE TARP SHOULD NOT BE WIDER THAN THE WIDTH BETWEEN THE MOUNTING BRACKETS!.
  • RETENTION BOW IN PICTURE IS OPTIONAL!!!!! Search for ATP1010 Retention Bow.
Check Stock

Ace Screws 3'' Wagon Wheel Plate ''FLATAss™'' (1,000pc), Roofing Insulation Plates, Goes with Self Tapping Screws into Metal and Wood Decks, Corrugated Roofing, Commercial, EPDM, TPO, (ACE-PLT-3INIW)

  • ...ains a total of 150 white self tapping screws in 5 sizes, and 30 pieces for each size, sufficient quantity to satisfy your various daily use and replacement demands.
  • Warm note: if these truss head screws get loosen during use, it is mainly caused by the compression of the supporting surface, the radial force of the bolted connection, or the initial loosening.
Check Stock

Affordable Glider Dog Sled Kit

  • Great lightweight top of the line sled for everyone who always wanted to try dog sledding.
  • Sold as a Kit with All Parts Included. Wood components are made of White Ash and left unvarnished. Holes are predrilled and all hardware is included. Plastic Components are also predrilled and ready for assembly. All you need is a Phillips Screw Driver and a 7/16" Wrench.
  • Can handle 400 pounds of basket weight plus a driver and is good for teams of 1-10 dogs.
  • The bolted design allows for the same great flexibility and maneuverability. Push on the handle in either direction and skis tilt for a turn or to hold the side of a hill. The bolted design also allows for easier modification or replacement of parts.
  • Length = 8' Brush Bow to Ski Tails, Height = 36" Ground to Handle Bar,Weight = 29 lbs. fully assembled. Foot Treads = 1-1/2" Wide 18" Long Seat = 40" Long 17" Wide. Brake = Aluminum Bar Brake/Drag Brake Combo.
Check Stock

Kalog Single Handle Freestanding Tub Filler Floor Mount Bathtub Faucet with Handheld Shower (Brushed Gold)

  • Floor mounted, Include all the installation hardware. Come with 1/2 thread hot & cold waterlines. High and stable tripod base design, three-legged bracket to bolted the faucet to the floor.
  • 360 Degree Swivel Spout, Handheld Shower with 59"(150cm) stainless steel hose for great flexibility and explosion proof will help to rinse down the tub or rinse off after a bath, very convenient to clean. And easy-clean nozzles are key feature of handheld Shower, can offer you a good experience of shower..
  • High and stable tripod base design, three-legged bracket to bolted the faucet to the floor.
  • Neoperl flow perlator for smooth water flow.
  • Ø35mm Ceramic Cartridge with CUPC Certificate.
Check Stock