Categories

Best Control Module

FOXWELL NT530 for Volvo Multi-System OBD2 Diagnostic Scanner Read Erase Error Codes

  • Upgraded version of the NT520 PRO scanner with improved hardware. Compatible with both OBDI and OBDII vehicles.
  • Service Features: Battery Reset, Injector Coding, TPMS, SRS, EPB, Brake Deactivation, Service Reset, Steering Angle Sensor (SAS) Calibration, DPF Regeneration, ABS Bleeding, BCM/SIR Setup, TPS/TBA (Throttle Body Alignment), etc..
  • Multi-System Diagnosis: Engine, Automatic Transmission, ABS, Airbag, Immobilizer, Climate Control, Fuel Pump Control Module, Fuel Injection Control Module, All-Wheel Drive Control, VG transfer case Module, Electronic Selector Module, Body Control Module, Digital Radio, Standard Radio, Drivers Door Module, HVAC, Instrument Cluster, Seat Memory Module, Theft Deterrent, Amplifier, Central Gateway, Immobilizer, etc..
  • Advanced functions such as Actuation, Adaption and Programming.
  • Expandable up to 5 car brands - Free Online Updates. One year warranty..
Check Stock

TUPARTS Engine Cooling Fan Control Relay Module Fits for 2011-2016 Volvo S60 2007-2015 Volvo S80 2008-2010 Volvo V70 2010-2013 Volvo XC60 2008-2013 Volvo XC70

  • FIT VEHICLES – Engine Cooling Fan Control Relay Module for 2011-2016 Volvo S60 2007-2015 Volvo S80 2008-2010 Volvo V70 2010-2013 Volvo XC60 2008-2013 Volvo XC70.
  • Interchange Part Number – 1331402 13752 12 1437591 1488905 1671530 940004101.
  • NOTICE-To confirm that this part fits your vehicle,please enter your vehicles Year, Make, Model in the Compatibility Table(on the top of the page)before purchasing.
  • HOW TO WORK – The water and antifreeze mixture (engine coolant) in the radiator is normally cooled by air forced through the radiator as you drive the vehicle. When the vehicle is not moving, air is not flowing through the radiator, so a cooling fan is used to draw air through the radiator, thus removing heat from the engine.
  • EASY INSTALLATION – Step 1: Check the fan control module. Step 2: Locate the fan control module. Step 3: Unplug the connectors for the fan control module. Step 4: Removing the Fan control module. Step 5: Installing the new fan control module. Install the new fan control module in place of the one that was removed..
Check Stock

MOCW 9378815 15-72548 599-007 AC Heater Control Panel Climate Control Module Switch Without Rear Window Defogger for 1996-1999 Chevy Truck GMC C1500 C2500 C3500 K1500 K2500 K3500 Truck 16231175

  • 【OEM Part Number】-The AC Heater Control Panel Replace OEM Part Number: 16231175, 16238895, 16240115, 9378815, 599-007, 15-72548. Please check OEM part number and compatibility before purchase it to ensure you buy the correct item..
  • 【High Quality Material】-The Air Conditioning Control Panel made of high quality and durable material. Advanced design meets exceptional, OE-level standards..
  • 【Easy Installation】-HVAC Control Module Direct Replacement, bolts to the stock steel front bumper with no drilling or alteration of the bumper..
  • 【Fitments】-Replacement for 1996-1999 Chevy C1500/K1500 Truck HVAC Control Module.
  • for 1996-2000 Chevy C2500/K2500 Truck HVAC Control Module.
  • for 1996-2002 Chevy C3500/K3500 Truck AC Heater Control Panel..
  • 【Fitments】-Replacement for 1996-1999 GMC C1500/K1500 Truck HVAC Control Module.
  • for 1996-2000 GMC C2500/K2500 Truck HVAC Control Module.
  • for 1996-2002 GMC C3500/K3500 Truck AC Heater Control Panel..
Check Stock

Razor MX500 and MX650 Control Module - OEM Razor 36 Volt Controller for MX500 (V21+), MX650 (V14+) Dirt Rocket and Razor EcoSmart Electric Scooter

  • Authentic Razor 36 Volt 30 Amp Controller for the MX500, MX650 and Eco Smart. The control module is version specific. See below if it is a match for your Razor Product..
  • Razor Control Module for the Razor MX500 Dirt Rocket (Versions 21 and up)..
  • Razor Control Module for the Razor MX650 Dirt Bike (Versions 14 and up)..
  • Razor Control Module for the Razor EcoSmart Electric Scooter..
Check Stock

DJI Part 14 Command Unit for Ronin-S Gimbal

  • The Ronin S/SC pan/tilt control module is equipped with a display screen and five-dimensional buttons. It integrates pan/tilt setting functions such as motor, working mode and control settings, and can directly use the creative functions. It is easy to set the Ronin S without a mobile device. /SC Parameters and control PTZ shooting..
  • Use the screws on the body of the pan/tilt control module to install only the Ronin-S ports on either side. After installation, turn on the Ronin-S power and the gimbal control module can work..
  • Colossal photography: Set the relevant parameters according to the camera type and select Quick Start, then set the start point and end point of the shooting, and the camera will start shooting after startup. The screen displays the number of shots and the completion progress..
  • Time-lapse photography: Set the relevant parameters according to the camera type and select quick start, and then set the start and end points of the shooting. If the shooting point is delayed, the start and end positions are the same.
  • if the shooting trajectory is delayed, the start and end positions are different. The camera will start shooting after booting up..
  • You will receive: Ronin S/SC PTZ control module*1.
Check Stock

SainSmart USB 4 Channel Relay Automation (5V)

  • NOYITO 2-Channel Micro USB Relay Module is equipped with a stable USB to serial port chip and a microcontroller. It can use the serial port debugging software to send serial commands on the computer to control the opening and closing of the 2-channel relay..
  • Onboard high performance microcontroller chip, CH340 USB control chip.With power LED indicator and relay status LED.On-board 2-channel 5V, 10A/250VAC, 10A/30VDC relay, long relay life, can work 100,000 times continuously..
  • Module with overcurrent protection and relay diode freewheel protection..
  • NOYITO 8-Channel Micro USB Relay Module ASIN：B09RGTSHHW.
  • NOYITO 4-Channel Micro USB Relay Module ASIN：B09RGVQXXT.
Check Stock

Painless Performance 80132 Single Pole, Double Throw Relay, 40 Amp

  • ★ The 8-channel relay module is equipped with transistors, diodes and optocouplers to switch higher loads safely, reliably and with little power. The module is also equipped with generously dimensioned relays in order to be able to reliably carry out many switching processes..
  • ★ 5V 8-channel relay module, each relay requires 70mA for switching (switching capacity AC: max. 250V / 10A.
  • ★ 5V 8-channel relay module can be controlled directly with a microcontroller Raspberry Pi, Arduin, 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL logic, etc..
  • ★ The relay acts as a switch that responds to a signal from the Arduin. Because of this, it is widely used in IoT projects to control lights and other electronic devices..
  • ★ Application: MCU control, PLC control, industrial area, smart home.If you need this relay, you can buy it directly. If there is a problem during use, you can contact us at any time to refund or replace it..
Check Stock

FN848 NEW Dell PowerConnect 6224F 24-Port Layer 3 Gigabit Ethernet Fiber Switch

  • 3-port CX-4 10GbE copper module (supports 10Gb connections only).
  • 2-port 10GBASE-T 10GbE copper module (supports 1/10Gb connections).
  • Features: Auto-negotiation for speed, duplex mode and flow control.
  • Supports DCB requirements including PFC (802.1Qbb), DCBx, iSCSI TLV 2.2, iSCSI Optimization.
  • FCoE FIP Snooping (FCoE Transit), single-hop.
Check Stock

Logitech USB Unifying Receiver - 2 Pack

  • Applications: This device can be wildly used to wireless remote control,wireless audio,somatosensory devices, RFID, NFC, smart grid, smart home, etc..
  • NRF24L01 Wireless Transceiver Module with 125 Communications channels, multi-point communication and frequency hopping to meet the communication....
  • NRF24L01 wireless transceiver module built-in 2.4GHz antenna, small size, 15x29mm (including antenna).
  • it can be directly connected to a variety of....
  • The operating voltage of the wireless module is generally 3.3v, while the ordinary 51 microcontroller is 5v. This module is convenient to shop....
  • NRF24L01 Socket Breakout Adapter with NRF24L01 Wireless Transceiver Module.
Check Stock

DORHEA 5PCS TM1637 0.56\ 4 Bits Digital LED Display Module with Clock Display 0.36 inch Common Anode Red Digital Tube Board with Cable for Arduino Raspberry Pi DIY Kits

  • The module is a 12 foot with a clock point four common anode tube (0.36 in.) display module driver IC is TM1637 driver IC TM1637, only two signal lines can make the MCU control 4 8 digital tube..
  • Display device is a total of 4 red LED word tube. Digital tube 8 grayscale adjustable. Control interface level can be 5V or 3.3V..
  • 4-digit LED display module with LED brightness adjustable and clock point, can be used to display decimal, letters and so on, suitable for uses in induction cooker, micro-wave oven and small household electrical appliance..
  • Total 4 pins (GND, VCC, DIO, CLK), GND to ground, VCC for the power supply, DIO for the data input and output pins, CLK for the clock signal pin..
  • The Positioning holes in this LED Display Module 4 Bits has 4 M2 screws positioning hole diameter is 2.2mm and the positioning of the module is easy to install with easy to achieve the inter-module combination..
Check Stock

Aideepen 5PCS DFPlayer Mini Mp3 Player Board Module Voice Decode Board Support TF Micro SD Card U Disk Audio Music

  • 【Upgrade】This is a MP3 Player Audio Voice Module, can be connected directly to the speaker.GD3200B chip replacement old YX5200 (Compatibility....
  • Supported Sampling Rates (kHz):8/11.025/12/16/22.05/24/32/44.1/48.
  • 24 -bit DAC output, support for dynamic range 90dB , SNR support 85dB..
  • The DFPlayer perfectly integrates hard decoding module, which supports common audio formats such as MP3, WAV and WMA. Besides, it also supports TF....
  • This Module with battery power supply, speaker, keypad can be used alone, or through the serial port control, as the Arduino UNO or any....
  • A variety of control modes, I/O control mode, serial mode, AD button control mode.-->If you need any questions, please feel free to contact us..
Check Stock

Honeywell Lynx Touch L5210 Home Automation/Security Alarm Kit with WiFi and Zwave Module

  • Kit Includes LYNX Touch 5210 Control Panel with Transformer and Battery Backup (3) 5815 Slim Door/Window Transmitters, (1) 5834-4 Four-button Wireless Keyfob & (1) 5800PIR-RES Wireless Motion Detector.
  • Integrated Z-Wave Support via L5100-ZWAVE Z-Wave Control Module (Included) for up to three thermostats (HVAC system or battery powered) with 1°F and 0.5°C set points Four door locks - Jammed locks reported to Honeywell Total Connect Remote Services 40 devices (lights, switches and lamp modules) 20 scenes 20 rules (event-based actions) 20 schedules (time-based actions) Sunrise/sunset lighting control Randomized lighting control.
  • Wi-Fi via L5100-WIFI Wi-Fi IP Communication Module (Included) for L5210 IEEE 802.11 B/G/N radio Supports alarm reporting Supports two-way voice LYNX Connect app supports up to four mobile iOS and Android devices. Internet Central Station Communication with L5100-WIFI or ILP5 Module.
  • Control Panel Dimensions (approx) 6.1" H x 8.5" W x 1.71" D (15.5cm H x 21.6cm W x 4.4cm D).
  • **PAID MONTHLY SERVICE REQUIRED FOR HONEYWELL'S TOTAL CONNECT REMOTE SERVICES**.
Check Stock

Electric Skateboard ESC Kit, 10S 36V Single Drive ESC Substitute Control Mainboard with Remote for DIY Electric Skateboard Longboard

  • Made of high quality chip and electronic components, single drive design can offer excellent and stable performance..
  • The solid structure of mainboard can greatly lengthen the service life. With remote receiver module, so it supports remote control..
  • The well-organized circuit board is easy to install, but needs professional skills..
  • This electric longboard skateboard control system has EMP control module with remote module, it can do as ESC do..
  • With over-voltage, under-voltage, overheating, over-current​ protection, safe and reliable to use, supports speed control, easy to use. With a LED indicator that displays signal status, speed modes, battery percentage..
Check Stock