Justrite 7250330 AccuFlow 5 Gallon, 11.75\ OD x 17.50\ H Galvanized Steel Type II Blue Safety Can With 1\ Flexible Spout
- Large ID zone permits user labeling of contents to avoid misuse.
- Stainless steel flame arrester for exceptional corrosion protection – reliably dissipates heat to prevent flashback ignition.
- Long 3-1/2" (88mm) length arrester allows safe, secure placement of gas nozzle.
- Gasoline, Gas-Oily Mixture, Kerosine, Diesel.
- Ergonomic offset fill port with comfort lift lever makes filling easier than ever Easy-to-use Safe-Squeeze trigger for accurate control of liquid flow.
- Self-closing lid controls vapors and spills.
Check StockB/M Stainless Steel Chimney Spark Arrestor Rain Cap for 2.36inch/6cm Stove Pipe
- Fire resistance: The top of the fire resistance tube is closed and there are mesh holes around it to prevent some sparks from flying out. The enclosed top also ensures that rainwater does not flow into the fireplace from the furnace pipe when it rains or snows..
- With 3 Fixed Rings: There are 3 rings at the bottom of the flame arrester, and you need to prepare 3 resistant hot wire fixed. Installed after the flame arrester will not worry about the wind weather..
- Thickened Stainless Steel: Straight tube thickness of 0.5mm. Stainless steel material can be very good rust resistance..
- Tight Connection: Elbow and straight pipe (not included) are tightly connected and can be used together..
- Suitable Size: Straight tube length is about 10.31in/26.2cm, and the diameter 2.36in/6cm..
Check StockOmni Directional 5G 4G LTE 2.4GHz 5.8GHz WiFi Hotspot Cellular Antennas Outdoor High Gain 10dBi Wideband 698-6000MHz Antenne for Routers/Modem/Signal Boosters
- Higher Gain :10dBi.Wide Frequency Band : 698-6000MHz.Include 800MHz,850MHz,900MHz,1800MHz,1900MHz ,wifi 2.4ghz 5.8ghz bands ,etc ..
- Support All Operator :Verizon, AT&T, T-Mobile, Telus, Bell Canada, Rogers, DigiCel,etc .Work for routers, modems and signal booster from CalAmp, Cisco, Cradlepoint, Digi, MoFi, Netgear, Novatel, Pepwave, Proxicast, Sierra, SureCall, weBoost, Wilson, ZTE,HUAWEI ,etc ..
- Use skills:Any antenna is heavily dependent on the surroundings.To achieve better results you may have to move around your hotspot and antenna(height and location of the installation)until you determine a sweet spot that gives you the best rewards.You must take into considerations, antenna hight, location,building clearance, line of sight,etc..
- Lightning arestor:If you mount the 4g antenna on roof or high, and you are in a lightning-prone area,it is recommended to install a lightning arrester.if you need lightning arrester or LMR400 cable,you can visit my Amazon store and order..
- It is just plug and play ,don't need any setting up..
Check Stockmankk 4 String PV Combiner Box IP65 Waterproof Solar Combiner Box with Circuit Breaker Lightning Arreste Solar Connector and 15A Rated Current Fuse for On/Off Grid Solar Panel System PV-BOX-4X
- Product model: Solar panel combiner box, waterproof grade IP65, equipped with independent fuse, high voltage arrester, DC circuit breaker, with 4 series Solar connection lines, code lock.
- Product parameters: photovoltaic box size: 17x23x11.5cm/6.7"x9"x4.5".
- Performance: The combiner box is sturdy shell. rainproof, pressure-resistant, and flame-retardant.
- high-voltage arresters provide lightning protection.
- 15A fuses, good current limiting characteristics, and breaking High ability. 63A Breaker also has overvoltage and overcurrent protection, which can cut off and connect the load circuit, provide short-circuit fault protection. Simple wiring, Suitable for any conventional surface, can be easily compatible with any brand of solar panels..
- Application: Photovoltaic array combiner box, used for grid-connected/off-grid solar power generation system, solar panel connector system. When used in conjunction with solar panels, it supports normal operation of 12V, 24V, 48V systems;.
- Packing: 1 Pcs solar panel combiner box, 1 Pcs lock, 4 Pcs mounting buckles + 4 Pcs screws.
Check StockJustrite 12751 2 Gallon Capacity, 12.00\ O.D x 14.75\ H Size Laboratory Cans for Corrosives
- Spring Closing Cap, Wide Mouth Opening with Stainless Steel fittings and flame arrester.
Check StockJustrite 12754 5 Gallon Capacity, 12.00\ O.D x 20\ H Size Laboratory Cans for Corrosives
- Natural Translucent HDPE , Spring Closing Cap.
- Wide Mouth Opening with Stainless Steel fittings and flame arrester.
Check StockJustrite 08300 2\ Npt Brass End of Drum Brass Bung Vent
- Operating Valve Opens At 5 PSIG Internal Pressure.
- Permits 4 Or More GPM Flow through Standard 3/4" Faucet.
Check StockDELTA LA302 COMM LIGHTNING ARRESTER DELTA LIGHTING ARRESTOR
- DEL LA302 COMM. LIGHTNING ARRESTER DELTA LIGHTING ARRESTOR.
Check StockGenExhaust for Champion 3500/3200W & 3100/2800W Inverter Generator 1 Exhaust Extension Hardware only
- The exhaust stub will need to be bolted onto the generator's stock muffler..
- The existing spark arrester can remain in place..
- Illustrated instructions will be provided..
Check StockJustrite 27601 1 Gallon, 9 3/8\ x 5 ½\ Size Dip Tanks
- Type 1 safety cans meet OSHA and NFPA 30 standards (UL listed, FM approved).
- Spring loaded, self-closing cap prevents spillage.
- Free flow double mesh metal flame arrester dissipates heat to prevent flashback ignition.
- Ergonomic handle for easy and comfortable pouring.
- Green is for oil-based fuel storage, 5 gallon capacity.
Check StockJustrite 7150310 Type I Galvanized Steel Kerosene Safety Can with Funnels Value Packages, 5 Gallon Capacity, Blue
- Precision arrester screen stops flashback ignition to reduce fire risks.
- Long length for safe insertion of gas nozzle.
Check StockGenExhaust for Champion Generator 3-Hole Round #90 Cover Plate 1-1/2" Exhaust Extension Hardware only
- The exhaust stub will need to be bolted onto the generator's stock muffler..
- The existing spark arrester will need to removed..
- Installation instructions will be provided..
Check StockGenExhaust for Champion 3500/3200W & 3100/2800W Inverter Generator 1 Silicone tubing Exhaust Extension 5 Foot Length.
- The exhaust stub will need to be bolted onto the generator's stock muffler..
- The existing spark arrester can remain in place..
- Installation instructions will be provided..
Check Stock