Categories

Best Current Probe

Circuit Breaker Finder Find Breakpoints, Automotive Circuit Tester with 75CM Test Lead, Electrical Wire Tracer Find Short Circuits, Circuit Tracer with Earphone & Handbag, Electrical Tester

  • ...ith the assistance of its auxiliary ground lead..
  • 【Activate and Test Components In/Out of Vehicle’s Electrical System&Poor Ground Contact Testing】Power circuit probe tester could activate components in and out of the vehicle’s electrical system, test and check the components if defective or not, or if rating current of component is higher than that of the circuit tester. For some components, the negative terminal is required to be well grounded to cope with the flow of large currents, this circuit tester is a good tool to test their grounding..
  • 【13FT Long Extension Cable&LED Light Prompt&Buzzer Warning&Highly Sensitive Probe&Clips with Strong Bite】The cable length of the circuit tracer is about 4m(13ft) which allows you access and test any electrical system easily. The LED indicator and buzzer warning can help you clear problems at a glance. Test light adopts advanced high sensitivity probe, which provides you quick and accurate detection. Its clips with strong bite force which not easy to fall off, providing you better experience..
  • 【Quick Self-Test & Overload Protection】Before you test a circuit or component, the test light can perform a quick self-test to ensure your tool is in good condition. Equipped with overload protection, when th....
Check Stock

Fluke 3000 FC GM Wireless General Maintenance System Multimeter

  • Wireless general maintenance system kit with a digital multimeter, voltage modules, and flexible current module and probe for measuring AC and DC voltage and current, continuity, resistance, diode test, capacitance, and frequency.
  • Modules can be connected to a test point, and results can be viewed up to 20 meters away on the multimeter.
  • Kit includes a 3000 FC series wireless multimeter.
  • A3001 FC wireless iFlex AC current module.
  • The Fluke 3000 FC Series Wireless Multimeter with the Fluke Connect app has all the essentials for convenient test and measurement troubleshooting.
Check Stock

Hantek 6254BE Digital oscilloscope 250MHz Bandwidth Automotive Oscilloscopes Car-Detector 4 Channels 1Gsa/s USB PC Osciloscopio

  • ⚡【AC/DC amp clamp meter】 Hantek AC/DC Current amp Clamp probe with bnc for oscilloscope, 20kHz Bandwidth, 1mV/10mA, 65A.
  • ⚡【Multifunction】It is a transducer which allows your multimeter to measure current data and enable your oscilloscope to measure the current waveforms..
  • ⚡【BNC Probe】if connect to an oscilloscope by BNC type connector, you're able to observe the current waveforms.
  • ⚡【Application】1.Power circuit measurement and malfunction analysis.
  • 2.Motor drive of frequency converter (or other electronics) measurement.
  • 3.Power electronics equipments measurement..
  • ⚡【What you will get】1*AC/DC Current clamp CC-65,1*English Manual..
Check Stock

Diode Check

  • 【Easy-to-use multi-function probe tester】The main functions of this power circuit probe tester include voltage and polarity test, continuity test, signal circuit test, current test, circuit breaker protection, relay test, injector test and cleaning, component activation and testing, poor ground testing, tracking and locating shorts, etc. It beeps to indicate the result while testing and is the most versatile and practical dedicated circuit repair test tool its users have ever had..
  • 【Best Electrical Tester】This electrical tester can supply power to electrical components, with reverse connection protection circuit, it is an advanced test tool for positive and negative line judgment. It shortens the diagnostic time of all 6 to 40 volt vehicle electrical systems, and is suitable for DC 6-40v cars, motorcycles, trucks, buses, construction vehicles, ships, tractors, mining vehicles and other vehicles that use DC circuits..
  • 【Quick Self Test & Relay Test & Circuit Breaker Protection】GODIAG GT101 circuit tester has quick self test function, which can ensure the tester is in good condition before use. The GT101 Probe Tester Kit can quickly detect whether t....
Check Stock

Autel MaxiSys MSOAK Oscilloscope Accessory Kit Compatible with The MaxiFlash VCMI MSUltra MS919 & MP408 Support 65A/650A AC/DC Clamp HT Extension Lead Battery Clip with Carrying Case

  • The current clamp measures a maximum current of 65A with a frequency up to 20 KHz. It works with jaws that open to allow clamping around an electrical....
  • Includes 65A AC/DC Current Clamp, 650A AC/DC Current Clamp, Coil on Plug Probe, HT Extension Lead (2pcs) and Battery Clip (2pcs).
  • COP Probe can catch the ignition waveform of automobile engine easily. The ignition waveform is a window, through which we can see what happened in....
  • Compatible with the MSULTRA, MS919 & MP408.
Check Stock

Hantek CC-65 AC/DC Current Clamp Meter Transducer for Digital Multimeter Oscilloscope with BNC Type Connector

  • Hantek amp clamp AC/DC frequency range: Up to 20 kHz.
  • hantek cc65 Effective Measurement Range: 20mA to 65A DC.
  • The oscilloscope current probe is with Accurate circuit measurement and suitable for DSO.
  • Hantek CC-65 amp clamp is Friendly in use: turn on, clamp it over a conductor, and get a reading.
  • The current probe is with Output: BNC connector.
Check Stock

Female Led Relationship Guide: How to Be a Femdom and Have the Perfect Female Domination Domestic Discipline Marriage or Relationship

  • 【Easy-to-use multi-function probe tester】The main functions of this power circuit probe tester include voltage and polarity test, continuity test, signal circuit test, current test, circuit breaker protection, relay test, injector test and cleaning, component activation and testing, poor ground testing, tracking and locating shorts, etc. It beeps to indicate the result while testing and is the most versatile and practical dedicated circuit repair test tool its users have ever had..
  • 【Best Electrical Tester】This electrical tester can supply power to electrical components, with reverse connection protection circuit, it is an advanced test tool for positive and negative line judgment. It shortens the diagnostic time of all 6 to 40 volt vehicle electrical systems, and is suitable for DC 6-40v cars, motorcycles, trucks, buses, construction vehicles, ships, tractors, mining vehicles and other vehicles that use DC circuits..
  • 【Quick Self Test & Relay Test & Circuit Breaker Protection】GODIAG GT101 circuit tester has quick self test function, which can ensure the tester is in good condition before use. The GT101 Probe Tester Kit can quickly detect whether t....
Check Stock

allsun AC/DC Current Mini Clamp Meter Probe Tester Handheld Digital Electrical Clamp Multimeter CAT III Max.Input 400A/600V 50Hz-60Hz LED

  • 〖Quick and Accurate AC/DC Amp Clamp Meter〗 is based on Hall Effect technology and is designed to be used in conjunction with multimeter for ac and dc current measurements..
  • 〖Max. Jaw Opening〗The Clamp measures the AC current in a conductor up to 33mm without interrupting the circuit, Max. Conductor Size: ∅ 28mm..
  • 〖Power/Low Voltage Indication〗When the battery's voltage is enough, the LED lights green. When the battery's voltage is less than about 7.5V, the LED lights red indicating that the battery is not high enough and should be replaced immediately..
  • 〖Multifunctional & Easy to use〗Range Switch, Used to turn on/ off the Current Probe as well as to select the desired,range, ZERO Button, AC/DC Button, AC/DC Button..
  • 〖Handheld Electrical Tester〗AC/DC Current Probe Digital Clamp Multimeter, it's suitable for the electrical repair,quality assurance.
Check Stock

Goupchn Back Probe Kit 30PCS Banana Plug to Copper Alligator Clip Automotive Test Leads Set with Alligator Clips, Wire Piercing Probes, 15PCS 30V Back Probe Pins for Car Repairing Diagnostic 5 Colors

  • Back probe test leads are copper flexible wires. Alligator clips are made of copper alloy material. Wire Length: 3.3ft. Rated current: 5A. Banana Plug: 4mm..
  • Five colors back probes are made of stainless steel and can be easily measured at three different angles. The stainless steel needle is only 0.07mm. It can be easily penetrated to measure when it is non-destructive. Three different probe angles can meet your various testing needs..
  • Wire piercing probes can be easily connected with the 4mm banana plug test leads. Perfect for wire piercing. No need to strip off the cables and no damage to the cables. Textured non-slip design enhances your comfort. High reliability and long service life. Probe length: 20mm. Voltage: 30V..
  • The tail of the alligator clips can be perfectly connected with the 4mm banana plugs. 5 colors make it easy to distinguish them during testing. Maximum opening: 15mm. Current Voltage: CATII 300Vac/15A..
  • Function: 30PCS multifunction back probe kit can be used not only for automotive diagnostics, testing and repairing, but also in physics laboratories, schools, homes and industries. Probes can easily insert into automotive connectors and use on harness connectors, fuel injectors and automotive sensors..
Check Stock

Fluke 374 FC 600A AC/DC TRMS Wireless Clamp Meter

  • Connect your meter to your smartphone with fluke connect measurements.
  • Read measurements on your phone at a safe distance, wearing less ppe while your meter takes all the risks.
  • Record results directly to your phone and the cloud.
  • 600 A AC and DC current measurement and 2500 A AC current measurement with (optional) iflex flexible current probe.
  • True RMS voltage and current for accurate measurements on non linear signals.
Check Stock

AUTOOL Power Circuit Probe Kit 6-24V Automotive Circuit Tester with Auto Electrical System Testing Functions (Digital Voltage Tester/Multimeter/Short Finder/Battery Tester/Power or Ground Supply)

  • ... and activate components in or out of the vehicle electrical system. Press button to “Positive”side with LED lighting RED. Conact the probe tip to positive terminal of tested component to active the component. If LED turns to GREEN with buzzer, stop testing and check the component if defective or not, or rating current of component is higher than that of this tester..
  • 【Widely Applicable】The car circuit tester is suitable for the diagnosis of all 6V to 24V automotive electrical systems and can work well on cars, trucks, boats, trailers, motorcycles, and airplanes. The portable and ergonomic design of the automotive power circuit probe is convenient for you to use in narrow areas.
  • the 4-meter extension cord is helpful for mobile maintenance work.
  • the clip with strong bite force is not easy to fall off, providing you with a better experience..
  • 【High Quality】The power circuit probe is equipped with overload power-off protection. If the current or load is too large during the power distribution process or When the current exceeds 7A, it will automatically disconnect to protect the battery and give a buzzer warning. With its short-circuit protection, you can test for bad ground contacts instantly. The insulation material used in this electrical t....
Check Stock

Amprobe UAT-620 Underground Utility Locator Kit with Clamp

  • ...pole or the circuit is open, and the green light is on when the probe tip is in contact with the negative pole or the circuit is in a continuous state..
  • [Component Test & Diode Test] Contact the probe tip to the positive terminal of the tested component to active the component. It can detect whether there is a large current flowing through the element and whether the negative electrode of the detection element is well grounded. Quickly test diode assembly operation and determine if circuits are opened or continuous. When the grounding is good, the green light will be on and a "beep" will sound..
  • [Current Overload Protection & Locating Short Circuits]: When the current is overloaded, the car circuit tester machine will automatically open circuit protection and emit a "beep" sound to reduce unnecessary losses and make our products durable. If LED light green with buzzer, short circuit or overloading component appears in this side. Following the wire in the direction of the short can help you find the location of the short..
  • [Practical DiagnosticTool] The 4m extra-long cable enables you to easily and conveniently inspect the entire circuit system of the car. This is a trustworthy and reliable circuit tester, ideal for novice and professional use. To ensure....
Check Stock

Milwaukee 2235-20 400 Amp Clamp Meter

  • 400A MAX AC/DC CURRENT RANGE: Reads both AC and DC current. With 9 functions it’s the perfect meter for the professional electrician.
  • MORE ACCURATE: Equipped with true RMS accuracy this clamp meter won’t leave you guessing weather your readings are correct.
  • HIGH SAFETY RATING: Feel safe on the job knowing Southwire’s clamp meter is CAT III 600V safety rated.
  • BUILT-IN NON-CONTACT VOLTAGE DETECTOR: Helps identify where live voltage may be present before working on electrical installations or troubleshooting.
  • CONVENIENT THIRD-HAND TEST PROBE HOLDER: The clip on the back of the clamp meter allows you to hold a test lead in one hand and the meter and the other test lead in your other hand making the testing process easier.
  • BUILT IN WORK LIGHT: The built-in work light is an extra convenience feature that allows visibility even in dimly lit areas.
  • WHAT’S INCLUDED: Carrying case, clamp meter, test leads, type K temperature probe with banana plug adapter, AAA batteries and instruction manual.
Check Stock