Categories

Best Differential Impedance

Micsig 700V 100MHz High Voltage Differential Probe kit 3.5ns Rise Time 10X/100X Attenuation Rate Oscilloscope Probe Kit Accessory DP10007

  • Widely Used: The attenuation rate is 10X/100X, widely used in any brand of oscilloscope..
  • Maximum differential test voltage (DC+ACPK-PK): 70V (10X), 700V (100X). You can safely measure floating voltages up to 700V and have a bandwidth up to 100 MHz..
  • Easier and Safer Use: High voltage differential probes sample high impedance isolation between input and output to protect person safety. Power supply USB DC 5V output, more portable while Oscilloscope has USB interface..
  • Versatile Kit: All 6 pieces with three different connectors help to test various on different occasions, including 2 alligator clips, 2 hook clips and 2 pincer clips..
  • Applications: Floating Measurements, Switch-Mode Power Supply (SMPS), Motor Drive Design, Power Device Testing & Evaluation, Power Converter Testing & Design..
Check Stock

Bridgold 20pcs TL082 082 Linear Integrated Circuit General Purpose Dual J-FET Operational Amplifier，DIP-8

  • Wide Common-Mode and Differential Voltage Ranges.
Check Stock

Analog Discovery Systems Kit: USB Oscilloscope & Logic Analyzer

  • Two-channel USB digital oscilloscope, spectrum analyzer, and network analyzer (±25V, differential, 14-bit, 100MS/s, 30MHz+ bandwidth).
  • Two-channel arbitrary function generator (±5V, 14-bit, 100MS/s, 12MHz+ bandwidth).
  • 16-channel digital logic analyzer, pattern generator, and protocol analyzer (3.3V CMOS and 1.8V or 5V tolerant, 100MS/s).
  • Two input/output digital trigger signals for linking multiple instruments (3.3V CMOS).
  • Additional instruments including a data logger, impedance analyzer, and power supplies.
Check Stock

ADT-Link R44SF / R24SF M.2 NVMe SSD Extension Cable Solid State Drive Riser Card Support M2 to PCI Express 3.0 X4 PCIE Full Speed 35G/BPS(R24SF 10CM)

  • Wire advantages: Using the German patent imported wire, using the Lotes connectors which imported from Taiwan, high frequency support PCIe 3.0 X16 8G/bps stable transfer..
  • Cable length: Our wire has a low impedance, the cable below 60cm can be stable at PCIe3.0 full speed reading and writing..
  • Differential signal without hole design, there is no problem of signal attenuation interference in a parasitic capacitance and parasitic inductance, there will be no more CAF micro short circuit, cable is durability..
  • PCB use high frequency low resistance of materials with high quality, PCB using high TG board, copper thickness thicken to 1oz, gold finger plating enough gold, Good conductive performance, can reduce oxidize higher impedance caused by the crash blue screen..
  • R24SF ,Connector 1: PCIe x4 ,Connector 2: M.2 NVMe SSD.
Check Stock

Juried Engineering TL064CN TL064 Quad Low-Power JFET-Input Operational Amplifier Op Amp Breadboard-Friendly IC DIP-14 (Pack of 5)

  • Typical Supply Current: 200 µA (Per Amplifier), Latch-Up-Free Operation, High Slew Rate: 3.5 V/µs Typical.
  • Wide Common-Mode and Differential Voltage Ranges, Low Input Bias and Offset Currents.
  • Common-Mode Input Voltage Range Includes VCC+, Output Short-Circuit Protection.
  • High Input Impedance: JFET-Input Stage, Internal Frequency Compensation.
Check Stock

Diamond Audio MICRO4V2 4-Channel 600 Watts RMS Class D Amplifier

  • Ultra-compact, high density aluminum alloy chassis provides superior thermal stability | Four layer, glass epoxy circuit board for enhanced performance and reliability | Full Range Class D amplifier technology | Bridgeable for high power operation (CH1+CH2/CH3+CH4) | Balanced differential inputs for superior noise rejection.
  • Input sensitivity from 200mV to 10V accepts Line (RCA) and Speaker level input | Input selector switch (2 CH / 4 CH) | Selectable auto-turn-on mode: Signal Sensing (VOX), 12V Remote (REM) and DC offset (DC) | Fully variable, 12dB per octave, electronic crossovers | Built-in BTR Port (MICRO-USB) to connect our optional Bluetooth receiver-controller | Illuminated logo.
  • RMS Power Rating - RMS Power (2Ω): 150W x 4 | RMS Power (4Ω): 80W x 4 | Bridged (mono 1Ω): N/A | Bridged (mono 2Ω): N/A | Bridged (mono 4Ω): 300W x 2 | Topology: Full Range Class D Power Supply | Power Supply: Full PWM | Power Supply Threshold: 10.0VDC - 17.0VDC | Idle Current: (0.7A).
  • Distortion - THD 4 (1KHx @ 4Ω): 0.5% | S/N Ratio (A weighted @1W): -85dBA | S/N Ratio (A weighted @FP): -101.1dBA | Input Sensitivity - Low Input Level....
Check Stock

Rockford Fosgate T1500-1bdCP Power 1,500 Watt Class-bd Constant Power Amplifier Renewed

  • The Power T1500-1bdCP mono amplifier featuring Constant Power, is truly the best of the best and delivers 1500 Watts of POWER.
  • Proprietary Constant Power amps are the most powerful on the market, delivering up to 25% more power across all impedance loads (1000 Watts x 1 @....
  • Highly efficient Class bd produces max power with minimal strain on the vehicle's electrical system. Our full chassis amp (2.14” x 8.14” x....
  • Balanced differential RCA pass-thru outputs, On-board Punch EQ with +18dB boost @ 45Hz and 24dB/octave Butterworth crossover make the T1500-1bdCP an....
  • Famous Rockford Fosgate build quality insures that the T1500-1bdCP will handle everything you throw at it! Full 2-year parts and labor warranty when....
Check Stock

Juried Engineering TL084CN TL084 Quad High Slew Rate JFET-Input Operational Amplifier Op-Amp IC Breadboard-Friendly DIP-14 (Pack of 10)

  • Low Power Consumption: 1.4 mA/ch Typical.
  • Low Input Bias Current: 30 pA, Typical Low Input Offset Current: 5 pA Typical, High Slew Rate: 13 V/μs Typical.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% Typical, Wide Common-Mode and Differential Voltage Ranges, Common-Mode Input Voltage Range Includes VCC+.
  • High Input Impedance: JFET Input Stage, Latch-Up-Free Operation.
  • Example Applications: Tablets, White goods, Personal electronics, Computers.
Check Stock

Juried Engineering TL072IP TL072 Dual Low-Noise JFET-Input Operational Amplifier Op Amp Breadboard-Friendly IC DIP-8 (1 Piece)

  • Wide Common-Mode and Differential Voltage Ranges, Low Input Bias and Offset Currents.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% (Typical), Low Noise Vn = 18 nV/√Hz (Typical) at f = 1 kHz.
  • High-Input Impedance: JFET Input Stage, Internal Frequency Compensation, Latch-Up-Free Operation.
  • High Slew Rate: 13 V/µs (Typical), Common-Mode Input Voltage Range Includes VCC+, Example Applications: Motor Integrated Systems: UPS, Drives and Control Solutions: AC Inverter and VF Drives, Renewables: Solar Inverters, Pro Audio Mixers, DLP Front Projection System, Oscilloscopes.
Check Stock

Taidacent THS4131 Fully Differential Input/Output Low Noise Amplifier Module Single Ended to Differential Single Ended Input Double Ended Output

  • Name: THS4131 Fully Differential Amplifier Size: 45mm X 34mm Supply Voltage Range: 5V Single Supply ±15V Dual Supply.
  • This module can implement single-ended to differential, single-ended input, and double-ended output. Has high performance, low noise, wide power supply voltage range and other advantages..
  • The THS413x consists of a true fully differential signal path from input to output. This design produced excellent common-mode noise suppression wells that improved total harmonic distortion..
  • Chip features High performance 150 MHz - 3 dB bandwidth (VCC = ±15V) 51V/us slew rate -100dB third harmonic distortion (250kHz) 2. Low noise 1.3 nV/vHz Input Reference Noise Differential input/cent output Balanced Output Suppresses Common Mode Noise Reduce second harmonic distortion from dry differential output.
  • Wide supply voltage range VCC-5 V Single Supply to ±15V Dual Supply ICC (SD) = 860 u A Shutdown Mode (THS4130) Chip application Single-ended to differential conversion Differential ADC Driver Differential antialiasing Differential transmitters and receivers Output Level Translator.
Check Stock

Rockville Pair RKL65MBW 6.5" 700W Marine Boat Speakers W/Led+Black/White Grilles

  • ..., Dyno Certified RMS Power Ratings: 2 Ohm: 120 Watts x 4 + 500W x 1 1% THD+N, 4 Ohm: 80 Watts x 4 + 300 Watts x 1 1% THD+N. Peak: 2 Ohm 480 Watts x 4 + 2000 Watts x 1, 4 Ohm: 320 Watts x 4 + 1200 Watts x 1, Channels 1-4 are Class “AB” and Channel 5 is class “D”, Fully Adjustable 12dB / Octave Crossover with Differential Circuitry, Low Pass Filter: (CH3-CH4)40Hz –4KHz /(CH5)50Hz –250Hz..
  • Features of RMWK4: RockvilIe RMWK4 4 AWG Gauge Waterproof Marine/Boat Amplifier Wire Installation Kit, 20 ’ Translucent, Twisted Pair, High Quality, Tinned-OFC Flexible PVC RCA Cable, 18’ 4 Gauge High Current, Low Impedance, Clear Flexible Power Cable with 3’ Black Poly Woven Mesh to better resist chemicals in the battery compartment, 18’ 4 Gauge High Current, Low Impedance, Light Blue, Flexible Ground Cable, 25’ 16 Gauge Tinned-CCA, White, Non-Transparent Resin PVC, Flat Speaker Cable.
Check Stock

Rockford Fosgate T1500-1bdCP Power 1,500 Watt Class-bd Constant Power Amplifier

  • The Power T1500-1bdCP mono amplifier featuring Constant Power, is truly the best of the best and delivers 1500 Watts of POWER.
  • Proprietary Constant Power amps are the most powerful on the market, delivering up to 25% more power across all impedance loads (1000 Watts x 1 @ 4-Ohm or 1500 Watts x 1 @ 2-Ohm or 1500 Watts x 1 @ 1-Ohm).
  • Highly efficient Class bd produces max power with minimal strain on the vehicle’s electrical system. Our full chassis amp (2.14” x 8.14” x 14.91”) is optimized for use with subwoofers in cars/trucks.
  • Balanced differential RCA pass-thru outputs, On-board Punch EQ with +18dB boost @ 45Hz and 24dB/octave Butterworth crossover make the T1500-1bdCP an impressive POWER house.
  • Famous Rockford Fosgate build quality insures that the T1500-1bdCP will handle everything you throw at it! Full 2-year parts and labor warranty when purchased from an authorized Rockford Fosgate reseller.
Check Stock

Juried Engineering TL074CN TL074 Quad Low-Noise JFET-Input Operational Amplifier Breadboard-Friendly IC DIP-14 (1 Piece)

  • The TL074 Quad JFET-input operational amplifiers incorporate well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit.
  • Low Power Consumption, Wide Common-Mode and Differential Voltage Ranges, Low Input Bias and Offset Currents.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% (Typical), Low Noise Vn = 18 nV/√Hz (Typical) at f = 1 kHz.
  • High-Input Impedance: JFET Input Stage, Internal Frequency Compensation, Latch-Up-Free Operation.
  • High Slew Rate: 13 V/µs (Typical), Common-Mode Input Voltage Range Includes VCC+, Example Applications: Motor Integrated Systems: UPS, Drives and Control Solutions: AC Inverter and VF Drives, Renewables: Solar Inverters, Pro Audio Mixers, DLP Front Projection System, Oscilloscopes.
Check Stock