Categories

Best Display Module For Aircraft

MEGA 2560 Starter Kit Ultra (100% Arduino IDE Compatible) w/ Battery Holder, Sensors, Modules, Resistor kit and Components (no Supply)

  • ...Sensor HC-SR501 -Distance measurement module HCSR04 -Sound sensor detector module with programmable threshold -LM35 temperature sensor -Tilt detector module -Servo SG90 motor -Stepper motor (5V) -Motor driver module for stepper motor ULN2003.
  • 5V Active Buzzer -5V Passive Buzzer -LCD 1602 16 characters * 2 lines -LED Display Driver MAX7219 -LED Matrix Display of 8*8 -7 Segments Display 1 digit -7 Segments Display 4 digits -Simple Relay Module - Infrared Remote Control 38kHz - 38kHz Infrared decoder receiver (type 1838) - Infrared phototransistor (Flame sensor) - Infrared LED - Light sensor (Photoresistor).
  • -10 * LEDs 5mm Diffused RED -10 * LEDs 5mm Diffused GREEN -10 * LEDs 5mm Diffused YELLOW -5 * LEDs 5mm Ultrabright WHITE diffused -3 * LEDs 5mm Red / Green / Blue Diffused RGB -Shift Register (Series to Parallel IC) 74HC595 - NPN Transistor BC547 - PNP Transistor BC557 - Adjustable Knob Resistor 1kOhm (Potentiometer) - Adjustable Knob Resistor 10kOhm (Potentiometer).
  • - Resistor Pack 1/4W 1% accuracy, with 10pz of each value: 100, 220, 330, 470, 1K, 2K2, 4k7, 10K, 22K, 47K, 100K, 220K, 1M - 40-pin header 2.54 mm -40-pin header at right angle 2.54mm -5 * Capacitors for bypass tantalum 0.1uF -5 * Jumpers for header.
Check Stock

Ximimark 1PCS 5V 12864 LCD Display Module 128x64 Dots Graphic Matrix LCD Blue Backlight

  • 12864 LCD Display Module 128x64 Dots Graphic Blue Color Backlight.
  • This product is a LCD display module with blue backlight, small and light appearance, suitbale for copiers, fax machines, laser printers, industrial test equipment, networking.
  • Package included： 1PCS x 5V LCD Display Module 128x64 Dots Graphic Matrix LCD 12864 Blue Backlight New.
  • If You Are Not Satisfied with Your Purchase for Any Reason, Please Feel Free To Contact Us at the Buyer Center or Support Email, 24/7 Quick Reply..
Check Stock

DORHEA 5PCS TM1637 0.56\ 4 Bits Digital LED Display Module with Clock Display 0.36 inch Common Anode Red Digital Tube Board with Cable for Arduino Raspberry Pi DIY Kits

  • The module is a 12 foot with a clock point four common anode tube (0.36 in.) display module driver IC is TM1637 driver IC TM1637, only two signal lines can make the MCU control 4 8 digital tube..
  • Display device is a total of 4 red LED word tube. Digital tube 8 grayscale adjustable. Control interface level can be 5V or 3.3V..
  • 4-digit LED display module with LED brightness adjustable and clock point, can be used to display decimal, letters and so on, suitable for uses in induction cooker, micro-wave oven and small household electrical appliance..
  • Total 4 pins (GND, VCC, DIO, CLK), GND to ground, VCC for the power supply, DIO for the data input and output pins, CLK for the clock signal pin..
  • The Positioning holes in this LED Display Module 4 Bits has 4 M2 screws positioning hole diameter is 2.2mm and the positioning of the module is easy to install with easy to achieve the inter-module combination..
Check Stock

POWERUP F-22 Raptor Bundle- Smartphone Controlled Airplane, Foam F-22 Kit, & Accessory Kit- Perfect STEM Gift for Kids, Teens, & Adults- Fun Outdoor Toy

  • ... POWERUP 4.0 RC module. This foam kit is perfect for DIY lovers and is easy to assemble with instructional videos attached to the packaging. The Accessory Kit includes landing gear and materials necessary for an F22 build..
  • UNIQUE FLIGHT- Easy to fly and maneuver, this model kit truly embodies the superiority of the aircraft it is modeled after. Its weight and design make it a controllable and slow-flying plane. When it’s in the sky it flies and looks just like an F22!.
  • ICONIC AIRPLANE- Our F22 Raptor kit is licensed by Lockheed Martin and modeled after their most iconic F22 Raptor aircraft. It is carefully designed to mimic the innovative aerodynamic properties of the aircraft, leading to unique flight performance..
  • BUILT IN USA- Designed and built by Flite Test, a leading company in the RC Flight space, the F22 Raptor Model Kit is laser printed onto Maker Foam. This foam is created by Flite Test and made in the USA. It is created for DIY projects and used for building RC airplanes..
  • STEM PROJECT- This RC Airplane module and foam kit are a perfect bundle for a STEM or aviation enthusiast. The project includes a 2-hour build time and endless hours of flight. We offer a variety of kits to use with your POWERUP 4.0 and encourage you to create your own! C....
Check Stock

FDSF Diy In12 In-12 Nixie Tube Pcba Kit Digital Clock Beautiful Gift,No Tubes

  • 2.12/24 hour module: Click "Up" key to change.
  • 3.Sleep module. Long Press "UP", while no display , into sleep module(22:00~07:00 no display. 07:00~22:00 display). Display all "0"number,out of sleep module..
  • 1.Set : Long Press "Down" key into setting . Click "Up","Down" to select , and Long Press "Down" key to finish..
  • 4.Set back color: Click "Down" to change color. when color refresh that means it is into change color automatic (every day change one color),or color is fixed..
Check Stock

Basic 16x2 Character LCD - RGB Backlight 5V

  • DRIVER IC: The module driver IC is for AIP650 (compatible for TM650), as well as supports multiple display characters..
  • 4 DIGIT 7 SEGMENT: The digital tube display module is designed for 4 digit 7 segment, with stable and reliable performance..
  • CONTROL INTERFACE: With 4 pins, SDA is bidirectional data line, SCL is clock line, GND is for ground line, and VCC is power supply..
  • COMPACT STRUCTURE: The LED digital tube module is exquisite and compact, which can be flexibly used in a variety of situations..
  • WIDE APPLICATION: This module is suitable for Raspberry Pi 3 B+ 4, for DIY electronic devices, toy cars and instrumentation etc..
Check Stock

QWinOut ARF/PNP Full Set Hexacopter DIY Drone Kit Tarot 690mm Frame with 750KV Motor GPS PIX 2.4.8 32 Bit Flight Controller (ARF)

  • Tarot FY690S Full Carbon Aircraft Frame 3K Folding Hexacopter 690mm FPV TL68C01: Uses Toray carbon fiber 3K woven CFRP plate and 3K carbon fiber hollow tubes of pure carbon fiber ( non- 3K glassy carbon tubes ) full CNC machining . Design standards higher than similar products , the entire chassis weighs only 600 grams . S version with ?16MM new multi-axle motor mounts, new brushless ESC bit back , can be directly tied to use..
  • PX4 PIX 2.4.8 Flight Controller Integrate PX4FMU PX4IO Safety Switch Buzzer 4G SD: – Advanced 32 bit CortexM4 ARM high performance processor, can run RTOS NuttX real time operating system.
  • – Integrated backup power supply and failure backup controller.
  • redundant power input and fault transfer function.
  • RadioLink AT10 2.4Ghz 10CH RC Transmitter with R10D Receiver PRM-01 Voltage Return Module: Multiple function remote control system,including helicopter,airplane and slider three type flying machine and five models,cover almost every popular model.   3.5 inch colorful screen 320×480 resolution,clear display menu and graphs.   E....
Check Stock

Revell U.S.S. Enterprise

  • Build your own replica of the largest vessel ever built with this 102-piece model kit.
  • Kit includes complete hull or water line option, 30 ship-borne aircraft, detailed superstructures, rockets, radar antennas, US Navy decals, display stand.
  • Detailed flight deck, island, fan tail, and anti-aircraft missile mounts.
  • Includes: 30 aircraft - A-4 Skyhawk, RA-5C Vigilante, A-6E Intruder, and F-4 Phantom, and display stand.
Check Stock

Key Display for AVR 8-Bit Digital LED Tube 8-Bit TM1638 Module

  • DRIVER IC: The module driver IC is for AIP650 (compatible for TM650), as well as supports multiple display characters..
  • 4 DIGIT 7 SEGMENT: The digital tube display module is designed for 4 digit 7 segment, with stable and reliable performance..
  • CONTROL INTERFACE: With 4 pins, SDA is bidirectional data line, SCL is clock line, GND is for ground line, and VCC is power supply..
  • COMPACT STRUCTURE: The LED digital tube module is exquisite and compact, which can be flexibly used in a variety of situations..
  • WIDE APPLICATION: This module is suitable for 3 B+ 4, for DIY electronic devices, toy cars and instrumentation etc..
Check Stock

Dogfight Air Attack Combat Flight Survival Hero Avion Force: F16 Flight Pilot Jet Fighter Air Attack Adventure Simulator Game 3D

  • Missions: Gameplay Engine with four different fighting missions.
  • Jet Fighters module encounter physical engine war.
  • Realistic controls with smooth gesture movement.
  • Intensified blend on flight simulation and air combat.
  • Warcraft technology with target lock and radar visibility.
  • Dozens Of modern weapons from the enemy, such as aircraft fighter, tank and aircraft carrier..
Check Stock

5 Pieces I2C Display Module 0.91 Inch I2C OLED Display Module Blue I2C OLED Screen Driver DC 3.3V~5V(Blue Display Color)

  • What will you get: there are 5 pieces OLED display module with blue display color, self-illuminated and no need backlight.
  • Power-saving display: the I2c oled display performs better than the traditional LCD display and with lower consumption sicne the IIC (I2C communications) simplifies connections.
  • Please note that these I2C OLED display module comes without pin headers.
  • More details: use compatible with Arduino, ESP8266, ESP32, STM32, etc..
  • Good compatibility: this i2c oled display module is compatitable with Raspberry Pi 4B/3B+/3B/2B/Zero, compatitable with Arduino, also compatitable for ESP8266, ESP32, STM32, etc..
  • Product manual: as shown in the instructions.
Check Stock

4-Digit 7-Segment LED Display Clock Module with TM1637 IC Compatible with Raspberry Pi Arduino (Blue LEDs)

  • [Specifications] This is a basic 4-digit 7-segment Led display clock module, the LEDs are blue..
  • [Compatibility] This clock module uses TM1637 IC, it compatible with Raspberry Pi and Arduino.
  • [Easy to Use] The clock module connected to digital I/O via 2 pins..
  • [Easy to Install] This LED display designed with 4 mounting holes for easy installation..
  • [High Quality] The clock module is made of high quality electronic components, stable and reliable performance.
Check Stock

QWinOut DIY F450 450mm Airframe 2.4G 6CH RC Quadcopter ARF Combo Full Set Drone with GPS APM2.8 Flight Controller (All Parts Included for Ready to Fly, Unassembly)

  • Tarot FY690S Full Carbon Aircraft Frame 3K Folding Hexacopter 690mm FPV TL68C01: Uses Toray carbon fiber 3K woven CFRP plate and 3K carbon fiber hollow tubes of pure carbon fiber ( non- 3K glassy carbon tubes ) full CNC machining . Design standards higher than similar products , the entire chassis weighs only 600 grams . S version with ?16MM new multi-axle motor mounts, new brushless ESC bit back , can be directly tied to use..
  • PX4 PIX 2.4.8 Flight Controller Integrate PX4FMU PX4IO Safety Switch Buzzer 4G SD: - Advanced 32 bit CortexM4 ARM high performance processor, can run RTOS NuttX real time operating system.
  • - Integrated backup power supply and failure backup controller.
  • redundant power input and fault transfer function.
  • RadioLink AT10 2.4Ghz 10CH RC Transmitter with R10D Receiver PRM-01 Voltage Return Module: Multiple function remote control system,including helicopter,airplane and slider three type flying machine and five models,cover almost every popular model.   3.5 inch colorful screen 320×480 resolution,clear display menu and graphs.   Expansion feedbac....
Check Stock