Categories

Best Electrical Disconnect Switches

UGarden String Light Hanging Kit with 170ft Coated Stainless Steel 304 Tension Wire Rope, Outdoor Light Guide Wire kit, String Lights Suspension Kit

  • Wide Applications: these 120V photoelectric switches can be applied to control outdoor area lights, bollard lights, porch lights, patio lights, entrance lights, driveway and sidewalk lighting, street lighting, outdoor lighting, indoor lighting, sidewalk and landscape lighting.
  • Installation Method: model NK-GT electrical light switches can be easily installed on the precision focus lamp, just disconnect the power, put the screw wire of the switch into the hole on the outside of the lamp, then tighten the rubber washer and zinc alloy ring nut.
  • For model NK101A and LP-403C, you can follow the installation method in the figure to install.
Check Stock

I LITTON Top Post Battery Disconnect Switch, 12V-24V Solid Brass Knife Blade Master Switch, Power Cutoff Shuoff Switch Kill Switch for Truck Vehicle Marine Car Boat RV ATV (Negative)

  • ✔【Heavy Duty Battery Disconnect Switch】: Durable made of high quality copper and brass, knife blade battery disconnect switch is high conductive and Anti-corrosive. Safe for battery to isolate and secure the electrical system..
  • ✔【Easy & Convenience】: There are 2 switching position for this top post knife battery disconnect switch, On/Off. Lift up the lever: Power Off, Lift down the lever: Power On..
  • ✔【Simple & Effective】: When your vehicle are not in use or stored for a long time, just lift up the lever to cut off the power, the knife blade battery shut off switch will help you to prevent daily electrical leakage from battery..
  • ✔【Wide Application】: Battery Cut Off Switch with a 0.59-0.66 in(15.5mm-17mm) battery negative pole, this top post knife blade battery disconnect switch is widely used for vehicle,trucks,car,RV, marine, boat as well as other electrical equipment..
  • ✔【Buy with Confidence】: It's worry-free purchase since we strongly focus on customers and product quality. We offer "12 months" warranty, and please feel free to contact us if you have any question for this battery disconnect switch..
Check Stock

Carlon B618R-UPC 4-1/4\ Round Box, Old Work, Cubic Inches: 18\

  • Used for extending set back electrical boxes up to 1-1/2-inches, levels and supports wiring device.
  • Automatically levels and supports outlets, switches, GFCIs, and other standard devices.
  • Works with handy boxes and 4-inch square electrical boxes with plaster rings for single switches.
  • Manufactured from 94VO rated flame retardant plastic for safer installations, two hour fire rating.
  • Used for extending set back electrical boxes up to 1-1/2-Inch, levels and supports wiring device.
  • Also used for handy boxes and 4-Inch square electrical boxes with plaster rings for single switches or receptacles.
Check Stock

Genuine Mopar Alternator - 4727865AB

  • Disconnect Jumper Wire, Master Disconnect, QuickCar Disconnect Switches, Each.
Check Stock

WARN 22680 Quick Connect Winch Power Cable Connector Plugs, 1 Pair

  • ...of high-quality PC flame-retardant material, with a fire rating of UL94 v-0, safe, wear-resistant, and compression-resistant, ensuring stability in use in complex and harsh environments.
  • {SILVER COPPER PLATED TERMINAL}: The thicker copper-plated silver of the battery quick connect disconnect set greatly enhances the electrical conductivity, which helps prevent ignition when large current passes, and ensures stable current transmission.
  • the copper terminal of battery quick disconnect kit is convenient for cold pressing, welding, and faster and firmer wiring.
  • {SPECIFICATIONS AND PACKAGING of the BATTERY QUICK CONNECTOR SET } Voltage: 12-36 volts DC.
  • the package contains 6 groups of 6 to 10 battery quick connectors, including 6 connectors, 12 terminal pins, 6 caps, the quantity is enough to meet your different Demand or replacement.
  • {EASY TO INSTALL}: You can quickly install the plugs of these battery quick disconnect connectors, insert the wires into the terminal pins, and then perform welding or crimping. The ends of the connectors are the same, so both ends are suitable for connecting to the power or load side.
  • {WIDE APPLICATION of the QUICK CONNECT PLUG PACK}: Provide a simple and convenient way to connect/disconnect power to winch....
Check Stock

GOGONFLY Battery Disconnect Switch DC 12V 24V Battery Master Isolator Cut Off Power Kill Switch for Marine Car Boat RV ATV Auto Truck Vehicle with 2 Waterproof Key 4 Copper Ring Terminals

  • OPERATION: You will get 1 Battery Disconnect Switches, 2PCS Keys, 1 Waterproof Cover,4PCS Copper Ring Terminals and 4PCS Heat Shrink Tubings. This battery kill switch is used for DC 12V 24 V systems, On/Off 2 position, Continue current: 100A. Intermittent current: 750A (5 min)..
  • DIMENSION: 2 brass terminals: 5/16", 2 mounting holes: 3/16". The base is 2.35” in diameter, the post that holds the key stands up 1 1/4” from the base, and it’s diameter is 7/8”.
  • WATER-RESISTANT: This battery master switch comes with 6 keys and 2 weather covers. The red keys can snug fit to curb battery drain and theft. The black cover can prevent from dust and water, prolong their lifespan.
  • HEAVY DUTY: Copper terminals with stainless steel hex nuts for improved continuity. Rust and corrosion resistant. The keys are made of plastic and fit perfectly on the thumb for ease of use.
  • NO WORRY ABOUT DEAD BATTERY: This keyed battery disconnect switch provides a reliable way to shut down electrical power during maintenance and protect batteries from excessive drain. It also acts as a deterrent for car theft. This battery kill switch can be found in boats, RVs, and some cars.
Check Stock

Nilight 8PCS 12V 20A Round Blue Toggle LED Rocker Switch On-Off Control SPST 3Pins for 12V Car Truck Boat Marine Off-Road Vehicle with 24PCS Wires,2 Years Warranty

  • Perfect Design: Designed to connect and disconnect a DC12V 20A electrical circuit at will, SPST: ON-OFF control.
  • 2 pole design (On/Off), 3rd poles with LED to be connected to earth. Fluorescent lamps will be lighted up when the switch is turned on.
  • Safety Protection: This truck rocker switch control uses copper-plated silver contacts, has good electrical conductivity, and uses high-quality materials and flame-retardant casing for high safety.
  • Widely Application : Suitable for cars, ATVs, UTVs, Wranglers, RVs, off road vehicles, trucks, boats, marines, electronics modifications, etc. Can also use these on water dispenser, running machine, electromobile and other household appliances modification.
  • Easy Installation: Round on-off switch is easy to install, which is just direct setup, and no additional work required, our switch comes with a keyhole slot to prevent unwanted rotation.
  • Package Includes: 8 x Blue Round Toggle LED Switches.
Check Stock

weideer Momentary Rocker Switch 12V Reverse Polarity with Red LED ON/Off/ON 6 Pin DPDT Waterproof Automatic Reset Boat Motor Control RV Jack Switch with Jumper Wires KCD4-223-JT-W-X-R

  • Rocker Switches house a button for operation that can be pressed on either end like a seesaw to connect or disconnect an electrical circuit. They are often used as ON/OFF switches on the main power supplies for electronic devices. A maintain switch changes its position when actuated and will remain in the position until actuated again. Stays / Maintains / Latched / Lock/ Locked/ Locking in position placed..
  • 15 amps at 250 VAC and 20 Amps At 125 VAC or 20 Amps At 12 V DC and 10 Amps at 24 Volt DC. Also make sure you are using a switch and wires sufficient to handle the power that you are carrying. In higher draw applications, a relay may be needed. Always use a fast blow fuse of rated amperage. Use terminals of good enough grade to handle the amperage in switch to avoid heat and damage..
  • 8 inch wires With 1/4" female connectors attached. Hole size is 7/8" X 1-1/16" 22mm X 27mm. 6 Pin prong Terminal. Can be used as a forward reverse switch..
  • Light weight construction.Double Throw Double Pole Two Position. DPDT is equivalent to two SPDT switches. It routes two separate circuits, connecting each of two inputs to one of two outputs. The position of the switch determines the number of ways in which each of the two contacts can be routed. They can connect two ....
Check Stock

AUTOOL Power Circuit Probe Kit 6-24V Automotive Circuit Tester with Auto Electrical System Testing Functions (Digital Voltage Tester/Multimeter/Short Finder/Battery Tester/Power or Ground Supply)

  • 【Why Need It】The circuit breaker finder is mainly used to test the on-off condition of the automobile electrical system under the 6-24v DC voltage. When the fuse is blown due to a short circuit, using this circuit tester can help you quickly and accurately find the faulty wire and its fault point..
  • 【Multi Functional】Automotive electric system is test for continuity. Test for polarity of a voltage. Check switches, relays and the on-off of diodes, fuses and circuits . Test for polarity of electric cables and plugs. Track and locate short circuits. Test for bad ground contacts.Do not use on AC voltage..
  • 【Easy To Use】The power circuit probe can be used to test and activate components in or out of the vehicle electrical system. Press button to “Positive”side with LED lighting RED. Conact the probe tip to positive terminal of tested component to active the component. If LED turns to GREEN with buzzer, stop testing and check the component if defective or not, or rating current of component is higher than that of this tester..
  • 【Widely Applicable】The car circuit tester is suitable for the diagnosis of all 6V to 24V automotive electrical systems and can work well on cars, trucks, boats, trailers, motorcycles, and airplanes. The portable and er....
Check Stock

Sigma Engineered Solutions, Gray Sigma Electric 14250 1/2-Inch 3 Hole 1-Gang Box

  • (Pack of 2) 1 Gang extending electrical boxes. Used for extending electrical boxes up to 1-1/2-inches.
  • Automatically levels and supports outlets, switches, GFCIs, receptacles and other standard devices.
  • Works with handy boxes and 4-inch square electrical boxes with plaster rings for single switches.
  • Manufactured from 94VO rated flame retardant plastic for safer installations, two hour fire rating.
  • Compliant with 2008 NEC Article 314.2. Manufacturer limited lifetime warranty.
Check Stock

ORCISH Battery Quick Connect Disconnect Electrical Plug 2-4 Gauge 175 Amps for Recovery Winch or Trailer (White)

  • Wide applications: the battery quick connector provides simple and convenient method for connect disconnect power to a winch or other electrical device such as remote battery chargers, power inverters, solar setups, trailers, or for any other purpose requiring a high-current, quick-disconnect connector.
  • Package comes with 6 sets 6-10 gauge battery quick connector, including 6 connectors, 12 terminal pins, 6 caps, enough quantity to meet your different needs or replacement.
  • Quality material: the battery quick connector plug is made of sturdy PC fire-retardant material with fitted rubber boot covers to protect against dust, moisture, have long service time.
  • Easily installation: you can install these battery cable quick connector disconnect plug quickly, insert the wires into the terminal pins, and then solder or crimp them, connector ends are identical, so either ends are suitable for connection to the power or load side.
  • Stable working environment: there are 12 terminal pins made of red copper coated with silver have strong electrical conductivity and reduce the resistance to ensure stable voltage and current.
Check Stock

Nilight 5PCS LED Lighted Rocker Switch 12V Blue LED Illuminated ON Off Toggle Switch 30A 3Pin SPST Oval Shaped Switch 12mm Hole for Automotive Car Truck RV Motorcycles Marine Boats 2 Years Warranty

  • Features: This truck rocker switch control uses copper-plated silver contacts, has good electrical conductivity, and uses high-quality materials and flame-retardant casing for high safety. Equipped with output short circuit, overload & polarity reverse protection. Up to 10000 times of ON/OFF operating life span.
  • Perfect Design: Designed to connect and disconnect a DC 12V 30A electrical circuit at will, SPST:(single pole single throw), ON-OFF control.
  • 2 pole design (On/Off), 3rd poles with LED to be connected to earth. LED on the switch will illuminate when the switch is turned on..
  • Widely Used: The 12v rocker switch mainly be used in car, ATV, UTV, SUV, wrangler, RV, off road vehicle, truck, boat, yacht & electronics modification, etc. Available for upgrading most wiring harnesses to control LED light bar, LED work lights, fog lamps, headlights, taillights & auxiliary lamps, etc.
  • Easy Installation: Mounting Hole Size: 0.43‘’(11mm).Rocker On-off switch is easy to install, which is just direct setup, and no additional work required, our switch comes with a keyhole slot to prevent unwanted rotation.
  • Package Includes: 5 x Blue Rocker Toggle LED Switches.
Check Stock

ASI GAX61 Disconnect Switch, Door Mount, Round, Red/Yellow Handle

  • When used to convert the DIN rail mount disconnect switch, pair this handle with one of these Shaft Extensions - GAX7055, GAX7070, GAX7090, GAX7150, GAX7200, GAX7300 (sold separately).
  • Fits GA Series Disconnect Switches - door mount and DIN rail mount (sold separately).
Check Stock