Best Embedded Processor Module

PC Interface Controller

  • 【One-year after-sale warranty】The PWM to voltage module converts PWM digital signals to 0 to 10V analog signals. It can be used to switch the signal interface of PLC or other industrial control board. Adjust the output voltage by adjusting the PWM duty cycle. The module is small in size and easy to apply in different places.003cbr003e.
  • Using MCU embedded technology. Easy to operate, can be fine-tuned by potentiometer.003cbr003e.
  • Select the PWM signal input level range by short circuit. The module is small, easy to carry and easy to use.003cbr003e.
  • (current greater than 100mA),PWM signal receiving frequency range: 1KHZ-3KHZ.
  • When power on for the first time, it is best to do a calibration and debugging: find a signal with a 50% duty cycle and connect it to PWM and GND. Jumper caps set the corresponding voltage range. When the frequency is 1KHZ-3KHZ, use a multimeter to measure the two ports of VOUT and GND. At this time, the meter displays about 5V. Adjust the potentiometer on the board so that the multimeter displays 5.00v.003cbr003e.
Check Stock

waveshare for Raspberry Pi Pico Evaluation Kit B Include Pi Pico Board with Pre-Soldered Header,1.14inch RGB Color LCD, 10DOF IMU Sensor Module,Dual GPIO Expander,Breadboard

  • Raspberry Pi Pico Evaluation Kit inlclude Raspberry Pi Pico with pre-soldered header ,1.14inch LCD Display Module,10-DOF IMU Sensor Module,Dual GPIO Expander ,830 Quality Breadboard etc.
  • Raspberry Pi Pico Board,a tiny, fast, and versatile microcontroller board,Built Using RP2040 Microcontroller Chip Designed By Raspberry Pi.
  • 1.14" LCD Display Module for Pico ,Embedded ST7789 Driver, Using SPI Bus.
  • 10-DOF IMU Sensor Module,an IMU sensor expansion module specialized for Raspberry Pi Pico. It incorporates sensors including gyroscope, accelerometer, magnetometer, baroceptor, and uses I2C bus for communication..
  • Dual GPIO Expander for Pico,Two Sets Of Standard Raspberry Pi Pico GPIO Male Headers.
Check Stock

Zyyini TPM 2.0 Module, 12Pin LPC TPM 2.0 Encryption Security Module Replacement Part, 12Pin TPM 2.0 Remote Card Compatible for Windows 11

  • Support: TPM module supports for Windows 7 64 bit, for Windows 8.1 32/64 bit, for Windows 10 64 bit, the actual performance may vary depending on your system configuration..
  • Keep Encrypted: Without this key, the content on the user's PC will remain encrypted and protected from unauthorized access..
  • Standalone Crypto Processor: The TPM is a standalone crypto processor that connects to the motherboard's daughter board. The TPM securely stores encryption keys that can be created using encryption software..
  • Scope of Application: TPM2.0 encryption security module is suitable for Windows 11 motherboard. Some motherboards require a TPM module inserted or an update to the latest BIOS to enable the TPM option..
  • Memory Space: The standard PC architecture reserves a certain amount of memory for system use, so the actual memory size will be smaller than the specified amount..
Check Stock

waveshare Original Raspberry Pi Compute Module 4 IO Board for All Variants of Compute Module 4,with Real-Time Clock Dual MIPI DSI/CSI Interfaces,USB Connectors

  • The Compute Module 4 IO Board is a companion board for all variants of Raspberry Pi Compute Module 4(supplied separately). It is designed for use both as a development system for Compute Module 4 and as an embedded board integrated into end products..
  • The Compute Module 4 IO Board is designed to allow you to create systems quickly using off-theshelf parts such as HATs and PCIe cards, which might include NVMe, SATA, networking, or USB. The major user connectors are located along one side to make enclosures simple..
  • Connectors: Standard Raspberry Pi HAT connectors with PoE support. Standard PCIe Gen 2 x1 socket. Various jumpers to disable specific features, e.g. wireless connectivity, EEPROM writing..
  • RTC : Real-time clock with battery socket and ability to wake Compute Module 4 Video: 2 x MIPI DSI display FPC connectors (22-pin 0.5 mm pitch cable) Camera: 2 x MIPI CSI-2 camera FPC connectors (22-pin 0.5 mm pitch cable).
  • USB: 2 x USB 2.0 connectors. Micro USB socket for updating Compute Module 4. Ethernet: Gigabit Ethernet RJ45 with PoE support..
Check Stock

DORHEA 3Pcs ESP32 Development Board WiFi + Bluetooth Microcontroller Dual Cores ESP-32 ESP-32S Board ESP-WROOM-32 CP2102 Chip 38Pin Narrow Version 2 in 1 Dual Core Low Power Consumption ESP-32S

  • The esp32s module has 38 pins and has more features than a 30-pin module, narrower width, compatible with breadboard.
  • ESP32 is a WiFi+Bluetooth chip developed. It is designed to provide access network functionality for embedded products..
  • ESP32s development board support Lua program, easy to develop, support of three modes: AP, STA and AP + STA..
  • NodeMCU-32S is based on the ESP-32S module. The platform uses many open source projects , this module is safe, reliable, and scalable to a variety of applications..
  • NodeMCU-32S includes firmware that can run on ESP32 Wi-Fi SoC chip, and hardware based on ESP-32S module..
Check Stock

10 inch Android 11 Tablets, HAOVM P10 Android Tablet, Octa-Core Processor, 3GB RAM 512GB Expand Storage 8.0MP Camera, 6000mAh Battery 10.1\ IPS HD Display, Wi-Fi, Type C, GPS, FM, Touchscreen Tablets

  • POWERFUL PROCESSOR AND BLISTERING PERFORMANCE -- The octa-core processor with frequency of up to 1.6 GHz and 3GB RAM gives you higher performance than quad-core processor while consuming less power, making the devices capable and efficient.Its operating system is Android OS. Its speed supports the smoother multimedia operation than any other tablet on the market. It is powered by a 64-bit octa-core CPU processor, Get rid of unexpected ads and download apps from Google Play without bloatware..
  • VIBRANT 10 INCH IPS DISPLAY -- HAOVM 10.1-Inch Android Tablet also has a classy IPS display with intricate detailing and vibrant colors.The 10.1 inch android tablet adopts a 2.5D curved glass IPS screen. The advanced polarizing filter and IPS technology allows awesome viewing experience from all angles, especially for visible in outdoor or dark conditions. The eye protection mode enables you to reduce eye strain and helping preserve your natural sleep pattern when using the tablet at night..
  • EASY AND FAST ENTERTAINMENT -- HAOVM P10 offers great connectivity options through the in-built 5G wifi and Bluetooth version 5.0 provides double transfer speeds and 4 times of communication distances than Bluetooth 4.2 devices. It's equipped with 5MP front and 8MP rear camera....
Check Stock

SparkFun MicroMod LoRa Function Board - 1W 915M30S LoRa Module Frequency Range: 900 - 931MHz Transmit Power 28.5 - 30dBm (max) Modulation LoRa, FSK, GFSK, MSK, GMSK, OOK Antenna Impedance: 50Ω

  • The 1W LoRa MicroMod Function Board adds LoRa capabilities to your MicroMod project. It is intended to be used in conjunction with a MicroMod processor board and a MicroMod main board, which provides the electrical interface between a processor board and the function board(s)..
  • Utilizing the 915M30S LoRa module from EBYTE, which is a 1W (30dBm) transceiver based around the SX1276 from Semtech. There is a robust edge mount RP-SMA connector for large LoRa (915MHz) antennas.
  • with modification, a U.FL connector is also available. We've successfully tested a 12 miles line-of-sight transmission with this module (user results may vary)..
  • Board Features: M.2 MicroMod Edge Interface, Keyed Screw Slots, RP-SMA Antenna Connector, Configurable U.FL Antenna Connector. MicroMod Peripherals Used: 5V Power.
  • 1W 915M30S LoRa Module Features: Based on SX1276 chipset from Semtech.
  • modulation: LoRa, FSK, GFSK, MSK, GMSK, OOK.
  • Data Rate: FSK: 1.2 - 300kbps, LoRa: 0.018 - 37.5kbps.
  • Note: A MicroMod Processor, Main Board, and antenna are not included with this MicroMod LoRa Function Board. These parts will need to be purchased separately.
Check Stock

DWEII 2 Pack GPS+BDS Dual-Mode Module Flight Control Satellite Positioning Navigator, ATGM336H Replacement NEO-M8N NEO-6M for Arduino

  • Application areas: Car positioning in navigation.
  • Mobile phones, tablet PCs, handheld devices.
  • 2PCS ATGM336H Chip GPS+BDS Beidou dual-mode positioning navigation module.
  • The ATGM336H-5N series module is a generic term for the 9.7 * 10.1-size high-performance BDS / GNSS constellation positioning navigation module family.
  • Excellent positioning and navigation functions,support single-system positioning of BDS/GPS/GLONASS satellite navigation systems,and any combination of multi-system joint positioning,and support QZSS and SBAS systems.
Check Stock

3 Channel 4K Dash Cam with SD Card Built in GPS 4K+2K Front and Rear,1440P+1080P+1440P Three Way Triple Car Camera Dash Camera for Cars Night Vision Parking Mode

  • ...ute or collision, the information provided by GPS module will become effective evidence to protect your legitimate rights and interests. Note: Please contact us to get the dedicated GPS player to view the GPS information..
  • 【Starvis Infrared Night Vision】The car dvr is based on Sony Starvis 335 sensor and NOVATEK processor. F1.8 aperture and HDR tech offer a significant increase in light throughout and WDR technology, the license plate and road signs can be clearly recorded even at night..
  • 【24 Hours Parking Mode】With built in 300mAh battery, the dash camera features a parking mode. When the car is parked, it is able to automatically turn on and record an urgent video once detecting any collision and vibrations..
Check Stock

ViewSonic PS750W 3300 Lumens WXGA HDMI Interactive Ultra Short Throw Projector

  • VERSATILE PROJECTOR: Complete, all-in-one interactive projection solution with embedded camera and interactive curtain module for immersive and....
  • BIG SCREEN PROJECTION: Ultra short throw lens projects up to 115-inches from 1-feet 11-inches in 3300 lumens.
  • LONG LAMP LIFE: Dynamic Eco-mode allows the lamp to shine bright for up to 7,500 hours.
  • FLEXIBLE CONNECTIVITY: Supports most media players, PCs, Macs, and mobile devices with input options such as HDMI, USB, Ethernet Lan and more.
  • INCLUDED IN THE BOX: PS750W WXGA Projector, Wall Mount, Interactive Curtain Module, 2x Interactive Pens, Power Cable, VGA Cable, and Remote Control.
Check Stock

NOYITO Voltage to Current Module 0-10V to 0-20mA

  • NOYITO Voltage to Current module, 0-2.5V ,0-3.3V,0-5V,0-10V,0-15V,0-24V voltage signal conversion to 0-20mA or 4-20mA current signal output, by adjusting the voltage to adjust the size of the current. Can be used to generate the signal source, valve adjustment, inverter control, PLC debugging, instrumentation test, LED test, analog transmitter.003cbr003e.
  • Implement the industry standard voltage (0-2.5V ,0-3.3V,0-5V,0-10V,0-15V,0-24V) into an industry standard current (0-20mA, 4-20mA)., linear output, the output signal can be directly connected to the AD converter, with the AD function with the microcontroller connection.003cbr003e.
  • Using single-chip embedded technology. The module is small and easy to use in different places.003cbr003e.
  • Easy to use, can be fine-tuned by potentiometer.003cbr003e.
  • Module working voltage: DC12-24V . 【Please read the product pictures on the left side of the page for the wiring diagram of the product.】003cbr003e.
  • 【Manufacturer's One-year After-sale Warranty】.
Check Stock

BUD Industries BB-32623 Plate Mounted Breadboard-6 Terminal Strip 11\ L x 8.8\ W x 0.3\ H, Gray

  • ...s to 1Mbps ? CAN-Bus isolation converter insulation voltage: DC 1500V.
  • Modbus Features ? Modbus slave support function code: 03H, 04H, 06H, 16H ? Support Modbus RTU or TCP ? Support heartbeat and timeout interrupt function ? The working port is fixed, the node address can be set.
  • Hardware Features ? High-speed 32-bit processor ? Embedded hardware watchdog timer ? Power supply voltage: DC 24V ? Maximum current: 40mA ? Electrostatic discharge immunity level: contact discharge ± 2KV, air discharge ±15KV ? Surge immunity level: ± 1KV ? Operating temperature range: -40 ? ~ +85 ? ? Operating humidity range: 5% to 95% RH ? Electrical fast transient burst immunity level: ± 1KV.
  • Working mode Trace mode When Modbus master writes corresponding address data of Modbus with a 06 instruction.If the data changes,it will trigger the corresponding data transmission of CAN. Timer mode Users can set interval time in "Send Timer.
Check Stock

Optical Fingerprint Module, R307 Optical Fingerprint Module Read Sensor Access Control Presence Recognition Device, Fingerprint Reader

  • ♦ 【FUNCTION】 -The R307 optical fingerprint module integrates a fingerprint algorithm chip with functions such as fingerprint input, image processing, feature extraction, template generation, template storage, fingerprint comparison (1: 1) and fingerprint search (1: N)..
  • ♦ 【APPLICATION】 -The fingerprint reader can perform secondary development and be embedded in various end products, eg Eg .: Access control, presence, safe, car door locks..
  • ♦ 【FEATURE】 -Low power consumption, low cost, small size, excellent performance..
  • ♦ 【HIGH PRECISE】 -Professional optical technology, precise module manufacturing technology..
  • ♦ 【500 DPI】 -Good image processing ability, can successfully capture images at 500 DPI resolution..
Check Stock