Categories

Best Frequency Module

PC Interface Controller

  • 【One-year after-sale warranty】The PWM to voltage module converts PWM digital signals to 0 to 10V analog signals. It can be used to switch the signal interface of PLC or other industrial control board. Adjust the output voltage by adjusting the PWM duty cycle. The module is small in size and easy to apply in different places.003cbr003e.
  • Using MCU embedded technology. Easy to operate, can be fine-tuned by potentiometer.003cbr003e.
  • Select the PWM signal input level range by short circuit. The module is small, easy to carry and easy to use.003cbr003e.
  • (current greater than 100mA)，PWM signal receiving frequency range: 1KHZ-3KHZ.
  • When power on for the first time, it is best to do a calibration and debugging: find a signal with a 50% duty cycle and connect it to PWM and GND. Jumper caps set the corresponding voltage range. When the frequency is 1KHZ-3KHZ, use a multimeter to measure the two ports of VOUT and GND. At this time, the meter displays about 5V. Adjust the potentiometer on the board so that the multimeter displays 5.00v.003cbr003e.
Check Stock

Logitech USB Unifying Receiver - 2 Pack

  • Applications: This device can be wildly used to wireless remote control,wireless audio,somatosensory devices, RFID, NFC, smart grid, smart home, etc..
  • NRF24L01 Wireless Transceiver Module with 125 Communications channels, multi-point communication and frequency hopping to meet the communication....
  • NRF24L01 wireless transceiver module built-in 2.4GHz antenna, small size, 15x29mm (including antenna).
  • it can be directly connected to a variety of....
  • The operating voltage of the wireless module is generally 3.3v, while the ordinary 51 microcontroller is 5v. This module is convenient to shop....
  • NRF24L01 Socket Breakout Adapter with NRF24L01 Wireless Transceiver Module.
Check Stock

Audio-Technica Instrument Condenser Microphone (ATM350U)

  • you want it – the gooseneck won’t flop around no matter how aggressively you move the instrument as you play. The microphone’s cardioid polar pattern isolates the instrument by reducing side and rear pickup, and the switchable 80 Hz high-pass filter on the in-line power module helps control undesired low-frequency noise. The system also includes an AT8468 violin mount with hook-and-loop fastener and a protective carrying case. Features: Low-profile mic design for minimum visibility Crisp, clear, well-balanced microphone response, even at high SPLs Cardioid polar pattern reduces pickup of sounds from the sides and rear, improving isolation of desired sound source Unmount universal clip-on mount attaches securely to instrument bell and provides excellent shock resistance for the microphone Rugged Unmount 5" gooseneck rigidly holds its shape, keeping microphone accurately positioned even during aggressive play In-line power module is equipped with a switchable 80 Hz high-pass filter to control undesired ambient noise Interchangeable elements available for hyper cardioid and omnidirectional polar patterns Included violin mount with hook-and-loop fastener provides an additional mounting option Specifications: Element: Fixed-charge back plate, p....
Check Stock

High Frequency Transducer, Bandwidth Mixing Board Mixer Module -10dBm for Quadrature Modulation for Base Station for HF VHF Receiver

  • 【Important Data】: SSB noise figure (NF) of 9.75 dB--Input IP3: 28.5 dBm--Input P1dB: 13.3 dBm--Typical LO drive: 0 dBm--Power conversion gain of 1.8 dB.
  • 【Wild Used】: This 5V double balance up and down frequency mixer module is widely used for cellular base station receivers, Radio link down converters, Broadband block conversion, Instrumentation.
  • 【Low Power】: Our 130mA 50 Ohms Balun coil coupling frequency conversion mixer features adjustable bias for low power operation, so you can trust and use this RF mixer inverter with confidence.
  • 【Wonderful Components】: This 5V ADL5801 double balance up and down frequency mixer module is equipped with exposed paddle, 4mm x 4mm, 24-lead LFCSP package, so it will be an ideal choice for you.
  • 【Size】: Power supply: DC+5V@80mA(anti-reverse connection protection.)--RF_IN/RF_LO input frequency range: 10-6000Mhz--Input and output impedance: 50 ohm--Type:Input Balun coupling, Input/output Balun coupling(Optional)--Weight: Approx.15g/0.5oz.
Check Stock

RF Oscillator Module, VCO 515MHz-1150MHz Voltage Controlled RF Oscillator Frequency Source Broadband Oscillator Module

  • [Strong compatibility]:For Yaesu FT-817/857/897 and other models for temperature-compensated crystal components, fully compatible with the original TCXO-9..
  • [High stability]:he frequency is 22.625MHz, which can improve the stability of the machine after replacing the original crystal. It is superior to the original module in different environments..
  • [High cost performance]:The price is only 15% of the original module, and the cost performance is extremely high..
  • [Effect is remarkable]:Actual test the frequency of the crystal is observed with a high-precision frequency meter. The original crystal frequency is deflected with a fire-baked , but this temperature-compensated crystal has no obvious change, and the effect is remarkable..
  • [Simple operation]:Turn off the power of the machine, open the cover of the machine, find the position where the temperature compensation crystal is installed. You need to unplug the ordinary crystal of the machine, then insert it according to the stitching of the machine. After installation, you can start using it without any settings..
Check Stock

High Speed Comparator High Speed Frequency Meter Front Shaping Comparator for Low-Voltage Applications Conversion Circuit

  • LOW VOLTAGE APPLICATIONS -- The input common mode range is better than the swing input, which is very suitable for low voltage applications..
  • APPLICATION -- Digital module can be used for wide voltage range and periodic signal shaping..
  • FRONT END ADJUSTMENT -- Used as a front end conditioning module in time domain measurements for frequency and phase difference..
  • PARAMETER -- The input voltage is 10 to 1000mV, the input frequency is about 200MHz DC, and the input impedance is 50 ohms..
  • RAIL TO RAIL OUTPUT -- The output level mode is rail to rail output, which can directly drive TTL / CMOS level..
Check Stock

Spectrum Analyzer USB 35-4400M Signal Source RF Frequency Domain Black Analysis Tool with Tracking Source Module Industrial Supplies

  • RF Frequency Domain Analysis Tool. Sweep Bandwidth: 33mHz---4400mHz.
  • Turn on the tracking source output bandwidth 33mhz---3000mhz.
  • Made of fine quality material, the Spectrum Analyzer has a long service life. Small and portable, high accuracy.
  • Signal Source Spectrum Analyzer. Software used on the computer side: NWT4.11.09 version.
  • Computer operating system: Winxp, Win7, Win10.
  • 35-4400M Signal Tracking Source Module is an RF frequency domain analysis tool.
  • Signal Tracking Source Module with Shell. Sweep Step: ≥33-68.75mHz/125Hz, 68.75-137.5mHz/250Hz, 137.5-275mHz/500Hz, 275-550mHz/1kHz,....
Check Stock

ALMOCN 4 Set 433MHz RF Wireless Transmitter and Receiver Kit High Frequency Super Regenerative Transceiver Module for Arduino Raspberry pi

  • Great influence on the antenna module reception, preferably connected to the 1/4 wavelength of the antenna, typically 50 ohm single conductor. The....
  • Wireless Transmitter Modules allow your Arduino to wirelessly comunicate with other arduinos, or with radio frequency (RF) controlled devices that....
  • Antenna position has also affected the reception of the module, the installation, the antenna as possible straight away from the shield, high....
  • Frequency used to receive, decode and oscillation resistor should match with the transmitter..
  • Application:Usually used for remote control systems, such as Remote control rolling gates, smart car, smart home, etc..
Check Stock

2PCS DC-DC Boost Converter, DC-DC 3.3V-13V to +15V/-15V Positive Negative Dual Step-Up Converter Board

  • This boost converter module can convert DC 3.3V~13V to DC ±15V..
  • The boost converter module can output positive and negative voltages..
  • Working Frequency: 400kHz, and the power module is automatically raised and lowered..
  • The boost converter module can be widely used as power supply for for ADC, DAC, LCD, and etc..
  • Maximum Input Current: 1.8A, Maximum Output Current: +Vo 600mA,-Vo 120mA, Quiescent Current: 3-4mA.
Check Stock

Synthrotek, Erica Synths Swamp DIY Kit

  • The SWAMP is a random CV and audio generator inspired by the famous Wiard Wogglebug module..
  • External audio input routed to ring modulator..
  • Clock input and output to sync the module to your modular system.
Check Stock

DGZZI 50pcs Blue 5mm Pitch PCB Mount Screw Terminal Block Connector for Arduino (20pcs 2 Pin + 15pcs 3 Pin + 15pcs 4 Pin)

  • Application: crystal oscillator, IC socket, DIY PCB universal board, Dupont wire, digital tube, buzzer, Arduino UNO board, PIC programming unit, AVR ATMEL programming unit, connector suite, USB TO TLL module, power module, LCD module, RS232 TO TLL module..
  • Package includes: 20 x 2 Pin Screw Terminal Block + 15 x 3 Pin Screw Terminal Block + 15 x 4 Pin Screw Terminal Block.
Check Stock

TECHTOO WiFi Antenna 2.4GHz 10 dBi for Wireless Router - Security IP Camera - USB Card Adapter - PCI PCIe Cards - Range Extender - PC Desktop - Drone - Signal Booster (RP-SMA 1-Pack)

  • ...ter GPS module cable, GSM module cablem WLAN 2.4GHz module cable, WLAN 5.8Ghz module cable, Digital apploance, Dual band ghz mini antennas for long wwan wifi booster gaming omnidirectional wifi antenna.
  • NOTE: Only Use for M.2 (NGFF) Interface, Do Not Use for MINI pcie Interface (please look the Picture), 2.4/5G Dual Frequency Internal High Gain WiFi Antenna mhf4 Jack pigtail cable extension directional extender cable antenna replacement kit for wireless module & bluetooth wifi cards.
  • Frequency Range: DC up to 6GHz (VSWR: 1.3 max. at 0.1~3GHz.
  • VSWR: 1.4 max. at 3~6GHz) ( option: 1.2Ghz 2.4Ghz 3Ghz 6Ghz 8Ghz 12Ghz 18G... ) Rated Voltage: AC 60v Contact Resistance: 20m ohm max.(Signal) and 10m ohm max.(Ground) Withstand Voltage: AC 200V Insulation Resistance: 500M ohm Min./DC 100V density.
  • Also work for intel 9260ngw ax200ngw 7260hmw and the Jetson Nano Module M.2 wifi card with MHF4 connector.killer ax1650 broadcom asus wifi modem internal cards alfa eplacement antenna cables for remoto control wifi hotspot wifi security camera antenna with mhf4 connectors.
Check Stock

Abovehill 12V Wireless RF Remote Control Relay Switch Universal 1-Channel 315MHz Receiver with 1 Transmitters for Garage Door Openers, Cars, LED Lights & More

  • ...e control distance of the open space is 30 meters, which will reduce the control distance in the case of interference or wall blocking. The specific situation is determined according to the site..
  • [Wireless Remote Control Module] It is a single-channel control module with a working voltage of 12V DC and an operating frequency of 315mhz. It can directly drive DC0-30V/80-250VAC load, and the relay can withstand up to 10A.Remote control uses 12V 23A dry battery(No battery)..
  • [Wireless Remote Control Module] Its coding type is fixed code and learning code. The control mode is three modes: jog, self-lock and interlock. Delivery defaults to jog mode. If you need to switch to self-locking or interlock mode. You need to change the contacts labeled “L” and “T” on the back of the receiving module..
  • [Wireless Remote Control Module] It also has learning and deletion capabilities. The operation is very simple and detailed in the product description..
  • [Wireless Remote Control Module] A wide range of applications, from simple home remote control to autonomous control, such as windows, entrances, garage doors, alarm systems, lifting equipment, etc. Note: If you encounter any problems, please send us an email and we will be here to help you. Thank you..
Check Stock