Categories

Best High Temperature Solenoid Valves

Bennett V351HPU1 Hydraulic Power Unit - 12 Volt

  • Compact powerhouse that creates hydraulic pressure to lower and raise the trim tabs.
  • Employs two solenoid valves to direct the flow of fluid to the actuators.
  • Solenoid valves lock tightly to secure the tabs in place.
  • Lexan cover protects electrohydraulic unit from occasional wash down and translucent reservoir allows fluid check at a glance.
Check Stock

AOMAG 3/8" Electric Solenoid Valve 12V DC, VITON Gasket, Air, Gas, Fuel Normally Closed

  • ....) - The solenoid’s magnetic field with directly moves the plunger and close the orifice for any fluid or gas flow. Only opens while energized..
  • -NEW- Re-engineered low power coil with up to 50% less heat generation. The valve starts as 19W and as it heat up to operating temperature power reduces to approx. 10-13W..
  • 1/4" NPT (USA National Pipe Thread). Commonly used standard pipe thread in US...
  • PLEASE NOTE: This valve is NOT a continuous duty valve and should NOT be in continuous use for more than 6 hours in a single cycle.
  • to do so will shorten the life of the valve and may cause the core of the valve to burn out. If you need a continuous duty valve for your project please search for our AOMAG Motorized Ball Valves..
Check Stock

Hunter Wand Wi-Fi Module for X2 Outdoor Irrigation Controller

  • PRO-HC Indoor Wi-Fi enabled for simple and fast connection to the internet. External Plug-In Transformer.
  • Full-functioning controller with touchscreen, also fully accessible via Android or iPhone app..
  • Large terminal strips and wiring compartment. Dedicated master valve/pump start.
  • Pro-HC controllers continuously monitor the electrical current flowing to your solenoid valves. If the current is too high or too low, Hydrawise will....
  • Daily schedule adjustments, based on local weather data, monitor past, current and forecasted temperature, rainfall, humidity, and wind speed..
Check Stock

1\ HEAVY DUTY HIGH FLOW IN-LINE COMPRESSED AIR PRESSURE REGULATOR 180 CFM

  • CO2 pressure regulator has two valves to independently measure flow rate and remaining CO2 tank contents (CO2 tank sold separately).
  • Valves have dual-scale readings in psi and kg/cm.
  • Needle valve flow control provides precise flow adjustment and measurement.
  • Includes flow regulator, needle valve, electronic solenoid, and bubble counter.
  • NOTE:Kindly refer to the Regulator Set Up Procedure provided as a PDF manual in the product description section.
Check Stock

RKX AC Compressor Control Solenoid Valve Compatible with Audi and Volkswagen Compressors made by Sanden PXE16 PXE14 MK5 MK6 B8 TDI

  • Highest quality control valve available GUARANTEED! Our valves feature premium quality materials and craftsmanship. All valves undergo rigorous quality testing and inspections. Our valves are manufactured in an ISO 9001, IATF 16949 certified facility..
  • PLEASE PHYSICALLY CHECK YOUR COMPRESSOR BEFORE ORDERING The manufacture used several suppliers for the AC compressor! This solenoid is only compatible with Sanden PXE16 PXE14 compressors held in with a snap ring and are visually identical..
  • Please note this is a new updated valve and may be longer than the valve found in your compressor. It is 100% compatible with the short style valve..
  • Compatible with Audi and Volkswagen vehicles from 2006 + including Jetta and Golf TDI. The OEM and other aftermarket brand solenoid have an EXTREMELY high failure rate! Will cause intermittent / no AC issues.
  • THIS IS VALVE IS SECURED INTO THE COMPRESSOR BODY USING A SNAP RING. If your valve is held in with a bolt please see our other listing. This part is only compatible with Sanden compressors. If you compressors is manufactured by another company please check our other listings..
Check Stock

Dyrabrest Stainless Steel Filter Housing 300PSI Shell heavy duty for 10” Filter 1/2\ NPT Water Filter Housing

  • 【Filter Housing】This is a heavy duty, 300 psi filter housing for dirt, rust, scale, taste/odor or other contaminants..
  • 【Material】Stainless steel is very corrosion resistant. High-quality 304 stainless steel with excellent abrasion resistance..
  • 【Durability】The filter housing max operating temperature 97℃..
  • 【Application】Suitable for water filtration throughout the house, kitchen sink or commercial use. Also suitable for industrial fluid handling..
  • 【Feature】It is especially suitable for applications where solenoid valves are used and water hammers frequently occur. Suitable for high flow rates and minimum pressure drops..
Check Stock

1/4\ NPT Brass Electric Solenoid Valve 12V DC Normally Closed VITON (Standard USA Pipe Thread). Solid Brass, Direct Acting, Viton Gasket Solenoid Valve by AOMAG

  • VITON GASKET- Viton is a space age material that is very chemically inert. As such, it is commonly used with gasoline, kerosine and other organic solvents. Some companies sell solenoid valves with NBR gasket and advertise gasoline use. DO NOT USE NBR gasket for gasoline (it will corrode the gasket and can cause serious gasoline leak and accident or fire). If you intend on using a valve for gasoline, use only VITON gasket..
  • ISO/OEM/ODM/CE and1 year warranty. DIRECT ACTING and Normally Closed Valve (N.C.) - The solenoid’s magnetic field with directly moves the plunger and close the orifice for any fluid or gas flow. Only opens while energized..
  • -NEW- Re-engineered low power coil with up to 50% less heat generation. The valve starts as 19W and as it heat up to operating temperature power reduces to approx. 10-13W..
  • 1/4" NPT (USA National Pipe Thread). Commonly used standard pipe thread in US...
  • PLEASE NOTE: This valve is NOT a continuous duty valve and should NOT be in continuous use for more than 6 hours in a single cycle.
  • to do so will shorten the life of the valve and may cause the core of the valve to burn out. If you need a continuous duty valve for your project please search for our AOMAG Motorized Ball Valves..
Check Stock

Tailonz Pneumaitc 1/4 inch NPT 12V/24V/110V/220V Way Normally Closed Electric Solenoid Air Valve 2V025-08

  • 【Model】2V025-08 Solenoid Valves（2 Way Normally Closed ）.
  • 【Size】DC24V/1/4''NPT（Please air in the direction of the arrow above the product）.
  • 【Temperature Range/Pressure Range】 0-140°F.
  • 【Feature】2v025-08 has high precision pilot head, up to 5 times/second response speed, suitable for a wide range of, responsive, smooth work, high-speed use without jam..
  • 【About Fittings】In each product, we provide 1/4 Push to connect fittings, you don't need to buy again, just insert 1/4 "or 6mm tubes..
Check Stock

1/4inch DC 12V 2 Way Normally Closed Electric Solenoid Air Valve

  • .WIC Valve is compatible with SMC valves. Has two holes in the bottom and can be mounted in any position..
  • .2ACK Series valve is a Zero differential solenoid valve which can be operated at 0 PSI (Vacuum)..
  • .Comes with a ED 100% encapsulated coil which suitable to operate in continuous service and constant energized..
  • .This solenoid valve has one G1/4" inch DN8 inlet and one G1/4" inch DN8 outlet port. Valve stays close when the coil is de-energized- and it opens when energized..
  • .1/4inch DC 12V 2 Way Normally Closed Pneumatic Aluminum Electric Solenoid Air Valve WIC Valve 2ACK series 2-way normally closed solenoid valve is to control On/Off of air and inert gas..
Check Stock

3/4\ Brass Electric Solenoid Valve,  110V Air Valve Normally Colsed for Water Air Gas Fuel Oil 2W-200-20

  • High quality 3/4inch Brass Electric Solenoid Valve： Constructed of industrial grade brass, this valve is corrosion resistant, more conducive for welding, optimal for higher temperature projects, and can be used with gasoline, diesel fuel, kerosene oil, natural gas, air etc.  .
  • Normally closed electric solenoid valve: 2 way solenoid valve,Model: 2W-200-20.
  •   3/4" NPT port,   Working temperature range: -5 ℃~80 ℃.
  •  Operating  Pressure: MIN.0kg/cm - MAX.10kg/com  .
  • This solenoid valve 110v was manufactured with a VITON seal,two-way inlet and outlet ports with standard female thread NPT connectionsm and heat and oil resistant Viton gasket.   .
  • Applicable Irrigation Controls (garden, Farm,etc.), Liquid Controls ( Pipeline, Artificial River Etc. and Air Controls ( Lab, Factory, Etc.) -3/4 inch Brass Electric Solenoid Valve Also known as110v solenoid valve,electric solenoid water valve,brass liquid solenoid valve. .
  • This valve comes with a ONE YEAR WARRANTY. If the valve does become defective within the first year of purchase, We will gladly replace it..
Check Stock

Benefast VTEC Solenoid Spool Valve w/Timing Oil Pressure Switch & Gasket Compatible with Honda Accord CR-V Element Civic Acura RSX Acura TSX Replacement# 15810-RAA-A01 15810-RAA-A03

  • The VTEC (Variable Valve Timing and Lift Electronic Control) system increases the amount of intake valve lift for increased power. It accomplishes this by turning a control solenoid 'ON' to allow oil pressure into the VTEC control passages to apply pins that will lock the intake rockers. When the oil pressure is present, the pressure switch signal will go high. When the control solenoid is turned 'OFF', the oil pressure is dumped and the oil pressure switch signal will go low..
  • If the pressure switch signal is not logical for the commanded state of the control solenoid, a DTC will set and the PCM will go into a 'fuel-cut' mode limiting engine rpm and performance. The PCM simply doesn't 'know' what the state of the intake valves are, so you end up with the symptoms you describe..
  • This VTEC Solenoid Fits for the Following Vehicles: Honda Accord 2003-2007, Honda Civic 2002-2005, Honda CR-V 2002-2009, Honda Element 2003-2011, Acura RDX 2002-2012, RSX 2002-2006, Acura TSX 2004 2005 2006 2007 2008..
  • Customers can find the product you need accurately according to the OE number. Replacement part number: 15810-RAA-A01, 15810-RAA-A02, 15810-RAA-A03, 15810-PNE-G01, 917-224, 917224, 15810RAAA01, 15810RAAA03, 15810RAAA02, 15810PNEG01..
Check Stock

Mcdonnell & Miller Flow Switch, 1 in SPDT FS4-3

  • Working Temperature: -10 to 50 Degrees Celsius.
  • Tip: The max switching current of the contact is 0.5A. Generally, it should be used together with small relay. Excessive current will burn the contact. Cannot directly control AC contactors, solenoid valves, alarms, pumps, and various lights..
  • What is in the package: 2pcs M16 Water Level Sensor.
Check Stock

28250-P6H-024 Transmission Dual Linear Shift Solenoid Gasket For Honda Acura Accord Odyssey Prelude Pilot 1998-2003 Replace 28250P6H024

  • ✔【Ideal replacement】：A bad solenoid cannot effectively control the flow of transmission fluid, causing delays or unexpected friction between the shift gears. This solenoid is comparable in fit, form and function to the original part, exactly OEM design to replace your defective solenoid.
  • ✔【Compatible with】Fits for 1998-2002 Honda Accord 4 Cyl, 1998-2007 Accord 6 Cyl, 1998-2006 Odyssey, 2003 2004 2005 2006 2007 Pilot, 97 98 99 00 01 Prelude | 1998-1999 Acura 2.3 CL, 1998-1999 Acura 3.0 CL, 2001-2003 Acura 3.2 CL, 1999-2003 Acura 3.2 TL, 01-02 Acura MDX.Please check the part number to compare whether it suits your car before you purchase..
  • ✔【Transmission Shift Solenoid Replace OEM】 : 28250-P6H-024, 28250P6H024..
  • ✔Package include: 1 x Linear Solenoid + 1pcs gasket +3pcs O-rings.
  • It is consisting of a spring loaded plunger wrapped with a coil of wire, and design to open or close valves in the valve body to permit transmission fluid to enter..
  • ✔【Product Warranty】: 12-Month Warranty: If the torque converter solenoid fails, stops working or any other problems, you can rely on our service of carefree REPLACEMENT or REFUND..
Check Stock