Categories

Best Ic Module

LCD Display Module - 2.8 Inch TFT SPI Serial Port LCD Touch Panel Module ILI9341 240x320 5V/3.3V(带触摸最少9个IO驱动)

  • With PCB board (including power supply IC, touch IC, SD cardcage) compatible 5110 interface.
  • At least 4 IO driver are needed (without touch) , at least 9 IO driver are needed( with touch).
  • This 2.8-inch LCD module uses ILI9341 drive chip to drive 240*320 dot , with 240*320 resolution.
  • The module is equipped with voltage stabilized IC to support 3.2v /5V power supply.
  • 2.8 inch color screen, support 65K color display, and the display is colorful.
Check Stock

DORHEA 5PCS TM1637 0.56\ 4 Bits Digital LED Display Module with Clock Display 0.36 inch Common Anode Red Digital Tube Board with Cable for Arduino Raspberry Pi DIY Kits

  • The module is a 12 foot with a clock point four common anode tube (0.36 in.) display module driver IC is TM1637 driver IC TM1637, only two signal lines can make the MCU control 4 8 digital tube..
  • Display device is a total of 4 red LED word tube. Digital tube 8 grayscale adjustable. Control interface level can be 5V or 3.3V..
  • 4-digit LED display module with LED brightness adjustable and clock point, can be used to display decimal, letters and so on, suitable for uses in induction cooker, micro-wave oven and small household electrical appliance..
  • Total 4 pins (GND, VCC, DIO, CLK), GND to ground, VCC for the power supply, DIO for the data input and output pins, CLK for the clock signal pin..
  • The Positioning holes in this LED Display Module 4 Bits has 4 M2 screws positioning hole diameter is 2.2mm and the positioning of the module is easy to install with easy to achieve the inter-module combination..
Check Stock

CatXQ Smart Ring for iOS Android | 2 Health Stones,6 RFID Cards,128G Wireless USB Flash Disk,Digital Business Card,Share Social Media | Ceramic Ring for Men Women - M

  • CatXQ Smart Ring:Built-in NFC module Easily Share Digital Business Card, Social Media (Facebook,Instagram,Twitter,Youtube,TikTok),can realize virtual call,Scene notification,Memo sharing and other featured cloud services..
  • CatXQ Smart Ring:Built-in IC and ID modules,6 smart cards can be simulated at the same time (Access Card,Elevator Card,Time card,Parking Card,Membership Card,Shopping Card and Other RFID Cards),the read-write process of ic/id card module is the same as ordinary cards.within the sensing range of the ic/id module,it can be authorized or copied by the corresponding dedicated read-write devicel..
  • CatXQ Smart Ring: Built-in 128G Wireless USB Flash Disk,Use ring touch to transfer any files, and each ring has exclusive 128GB storage space..
  • The Smart Ring can be set as a trigger for the intelligent scene of MI Home Smart Devices..
  • We provide 24-hour after-sales service. If there is a problem with the product,or you can't operate it. Please do not hesitate to contact us..
Check Stock

LCD Touch Panels Touchpanel Analog For DOGXL160 (EA TOUCH160-1)

  • ♛ The Display Module is 5V compatible, use with 3.3V or 5V logic.
  • ♛ The Display Module can support analog S P I and hardware S P I.
  • ♛ The Display Module is designed with one socket for sd card.
  • ♛ With P C B plate (including power supply IC, SD), compatible with 5110 interface.
  • ♛ This is a new 2.8 inch serial S P I color display module without touch function.
Check Stock

CatXQ Smart Ring Compatible with iOS Android,2 NFC Safe Quick Trigger Instruction (Phone/Location/SOS),Support Simulation of 4 ID/IC Smart Cards,Waterproof,Ceramic Ring for Men Women (Size:9)

  • CatXQ Smart Ring:Built-in IC and ID modules,4 smart cards can be simulated at the same time (Access Card,Elevator Card,Time card,Parking Card,Membership Card,Shopping Card and Other RFID Cards),the read-write process of ic/id card module is the same as ordinary cards.within the sensing range of the ic/id module,it can be authorized or copied by the corresponding dedicated read-write devicel..
  • CatXQ Smart Ring:The Built-in NFC module can realize virtual call,Scene notification,Business card sharing,Memo sharing and other featured cloud services..
  • CatXQ Smart Ring Compatible with IOS (XS,XR,XS Max,11 series,12 series,13 series) and Android,.
  • Smart Ring Size: No.8 (Perimeter 57.1 mm), No.9 (Perimeter 60 mm), No.10 (Perimeter 62.8 mm),No.11 (Perimeter 66 mm),No.12 (Perimeter 70 mm),it does not require battery charging , it has IP68 grade waterproof and dustproof,it is anti-abrasive, no fading, no deforming,suitable for all occasions..
  • We provide 24-hour after-sales service. If there is a problem with the product,or you can't operate it. Please do not hesitate to contact us..
Check Stock

CatXQ Smart Ring Compatible with iOS Android,2 NFC Safe Quick Trigger Instruction (Phone/Location/SOS),Support Simulation of 4 ID/IC Smart Cards,Waterproof,Ceramic Ring for Men Women (Size:11)

  • CatXQ Smart Ring:Built-in IC and ID modules,4 smart cards can be simulated at the same time (Access Card,Elevator Card,Time card,Parking Card,Membership Card,Shopping Card and Other RFID Cards),the read-write process of ic/id card module is the same as ordinary cards.within the sensing range of the ic/id module,it can be authorized or copied by the corresponding dedicated read-write devicel..
  • CatXQ Smart Ring:The Built-in NFC module can realize virtual call,Scene notification,Business card sharing,Memo sharing and other featured cloud services..
  • CatXQ Smart Ring Compatible with IOS (XS,XR,XS Max,11 series,12 series,13 series) and Android,.
  • Smart Ring Size: No.8 (Perimeter 57.1 mm), No.9 (Perimeter 60 mm), No.10 (Perimeter 62.8 mm),No.11 (Perimeter 66 mm),No.12 (Perimeter 70 mm),it does not require battery charging , it has IP68 grade waterproof and dustproof,it is anti-abrasive, no fading, no deforming,suitable for all occasions..
  • We provide 24-hour after-sales service. If there is a problem with the product,or you can't operate it. Please do not hesitate to contact us..
Check Stock

1024 P/R 5VDC 10mm Diameter Hollow Shaft Incremental Rotary Encoder

  • This is the "momentary" variety of the touch sensor - touch and it turns on, release and it turns off..
  • Positive and negative can be used as a touch surface,can replace the traditional touch button..
  • Four M2 screws positioning holes for easy installation.Module can be installed in such as surface plastic, glass of non-metallic materials..
  • In addition to the thin paper ( non-metallic ) covering the surface of the module , as long as the correct location of the touch , you can make hidden in the walls, desktops and other parts of buttons..
  • The module is based on a touch-sensing IC (TTP223B) capacitive touch switch module. In the normal state, the module output low, low power consumption.
  • When a finger touches the corresponding position, the module output high, if not touched for 12 seconds, switch to low-power mode..
Check Stock

4-Digit 7-Segment LED Display Clock Module with TM1637 IC Compatible with Raspberry Pi Arduino (Blue LEDs)

  • [Specifications] This is a basic 4-digit 7-segment Led display clock module, the LEDs are blue..
  • [Compatibility] This clock module uses TM1637 IC, it compatible with Raspberry Pi and Arduino.
  • [Easy to Use] The clock module connected to digital I/O via 2 pins..
  • [Easy to Install] This LED display designed with 4 mounting holes for easy installation..
  • [High Quality] The clock module is made of high quality electronic components, stable and reliable performance.
Check Stock

DSD TECH HM-19 Bluetooth 5.0 BLE Module with CC2640R2F Chip Compatible with iOS Devices

  • Original HM-19 module, DSD TECH brand guarantees and we accept refund without any excuse..
  • Bluetooth 5.0 BLE Module: The main IC is CC2640R2F from TI,Compared to the Bluetooth 4.0 module, this module has a faster transfer rate and a larger MTU..
  • Fully compatible with HM-11,HM-17, if you are using HM-11 or HM-17 now, you can quickly upgrade your board to Bluetooth 5.0 BLE..
  • DSD TECH offers a free app that lets you quickly integrate this module into your project.Please search "DSD TECH Bluetooth" in Google Play and the Appstore..
  • DSD TECH back this HM-19 Bluetooth 5.0 BLE module with ONE Year WARRANTY and lifetime technical support. If you meet any question, please contact us, we will fix your issue within 24 hours.
Check Stock

Sound Module, Support Any Format Recording Module 10 Second Recording Easy To Use for Record Video

  • Sound sensor module have small volume and low output noise, the fixed gain is 20dB, support 3.3v and 5v.
  • Low power consumption of sensor is easy to control, more stable and more efficient.
  • The sound sensor is suitable for assembly, and installed on various small equipment like microphone and robot.
  • Microphone sound sensor module possess small size, more stable performance and simpler installation.
  • This module uses professional microphone amplifier IC, which possess high sensitivity.
Check Stock

DGZZI 50pcs Blue 5mm Pitch PCB Mount Screw Terminal Block Connector for Arduino (20pcs 2 Pin + 15pcs 3 Pin + 15pcs 4 Pin)

  • Application: crystal oscillator, IC socket, DIY PCB universal board, Dupont wire, digital tube, buzzer, Arduino UNO board, PIC programming unit, AVR ATMEL programming unit, connector suite, USB TO TLL module, power module, LCD module, RS232 TO TLL module..
  • Package includes: 20 x 2 Pin Screw Terminal Block + 15 x 3 Pin Screw Terminal Block + 15 x 4 Pin Screw Terminal Block.
Check Stock

SunFounder Reader Module Kit Mifare RC522 Reader Module with S50 White Card and Key Ring Compatible with Arduino Raspberry Pi

  • The RF IC Card module design the circuit of card read by using the original Philips MFRC522 chip.
  • Easy to use, with pin header. The module can be directly loaded into the various reader molds..
  • Applicable for the user who need to design or manufacture the RF card terminal..
  • Module Interface: SPI， Data transfer rate: Maximum 10Mbit/s..
  • Power Voltage : 3.3V,Operating frequency: 13.56MHz..
Check Stock

ICC/Intervox MEU-65PD-02-704, Microphone; 100 to 12000 Hz; 2 V; 0.5 mA (Max.); 6 mm x 5.2 mm; -70 dB

  • The sound sensor is suitable for assembly, and installed on various small equipment like microphone and robot.
  • Microphone sound sensor module possess small size, more stable performance and simpler installation.
  • Sound sensor module have small volume and low output noise, the fixed gain is 20dB, support 3.3v and 5v.
  • Low power consumption of sensor is easy to control, more stable and more efficient.
  • This module uses professional microphone amplifier IC, which possess high sensitivity.
Check Stock