Horiba 9096001700 Plastic Body PH Electrode
- Modular design makes it suitable for use with output modules, sensors and remote transmitters.Compact structure, easy to install.Intuitive clear reading, high reliability, measuring accuracy is ±1%.High-definition displays show both instantaneous and cumulative flow.Can be widely used to measure diesel, kerosene, gasoline, etc..
- This digital turbine flow meter has modular design, high accuracy, compact size and stable performance. Easy to replace and maintain internal components. Suitable for use with output modules, sensors and remote transmitters..
- Malfunction and solution:The flow meter is not accurate. 1. The method of field calibration is not correct. Calibrate again. 2. The flow rate on the meter is below the lowest. Increase the flow rate. 3. The flow meter is blocked by the dry liquid. Take out the impeller and clean it carefully and make sure the impeller turns freely..
- 4. The impeller is wrapped by the sealing material. Remove the meter and make sure the impeller turns freely. 5. Too close to the impeller. Install properly 6. Too close to the motor or electronic noise environment.
- The meter can not calibrate. 1. Circuit board is break down. Replace the circuit board. 2. Button is fail to press. Replace the circuit board..
Check Stock
CGOLDENWALL Turbine Flow Meter Digital Fuel Flowmeter with FNPT Inlet/Outlet, 1inch Flow Meter for Water Diesel Kerosene Gasoline, 2.5-26GPM /9-100LPM (1 inch)
- FLOW METER: the 1 inch flow meter can read instantaneous flow rate, single cumulative flow and total cumulative flows. But it has minimum flow rate requirment, if the flow rate of the tested liquid is lower than 2.5 gal/min, the readings will be inaccurate..
- TECHNICAL PARAMETERS：① diameter of water inlet: 32mm.
- ③ the flow speed requirenment for tested liquid: 2.5~26 gal/min.
- ⑥ max temp of tested liquid: 158°F/70°C.
- MULTIPLE UNITS: the flow meter provide 4 meauring units for option, which are liter, gallon, pint and quart. The unit defaults to gallons, if the unit is not gallons, please refer to the user manual to change the unit to the needed one..
- NOT WATER PROOF: the flow meter is not water proof, please keep the display from water during use, to avoid chip damage. We upgraded The flowmeter has been upgraded from never-sleep model to auto-sleep model, which automatically dims the screen when no liquid is flowing through it..
- WIDE APPLICATION: The turbine flow meter can used for measuring the water, gasoline, diesel, kerosene, methanol and other low-corrosive, non-viscosity liquids. If there is any problem, please contact us in time..
Check StockRAINPOINT Water Meter Water Flow Meter for Garden RV Hose Measure Gallon or Liter Water Consumption Fits 3/4-inch Outdoor Hoses and Faucets
- HELPS CONSERVE WATER >>This portable water meter measures water consumption and water flow rate. With large LCD display allows you quickly know about....
- SENSITIVE & ACCURATE >> This water flow meter is equipped with a built-in hall sensor, Accuracy up to 1/10th Gallon, Measurement Tolerance > RAINPOINT hose water meter monitors not only the current singular watering volume and accumulative total water consumption, but....
- SIMPLE & FAST CONNECTION >> The hose flow meter comes with 2 quick connectors and can be easily connected to any standard 3/4’’ garden hose,....
- EASY TO USE >> The LCD screen of this water hose meter is big enough to be easy to read and displays water usage in gallons or liters. One button....
Check StockForney 85364 MIG Gas Flow Meter and Regulator, MIG/TIG Welders
- Combination of regulator and flow meter as one single stage piston design unit.
- Provides accurate regulation of gas flow.
- Impact resistant machined brass body, polycarbonate flow tube and outer cover.
- Features regulator and flow meter in one unit.
- Provides accurate regulation of gas flow designed for MIG and TIG applications.
Check Stock
CGOLDENWALL Handheld Ultrasonic Flowmeter Clamp on Flow Meter Portable Liquid Flow Meter with S1+M2 Transducers for Copper/PVC Pipe DN15-700mm 1/2-28\ ((Old or New Panel))
- S1+M2 TRANSDUCERS: Easy to setup the transducers on the pipe and enter the required information in the control unit.No need to destroy the pipeline and stop production during the measurement process.S1(DN15-100mm, 1/2-4"), M2(DN50-700mm, 2-28").
- DIGITAL DISPLAY: The Ultrasonic Flowmeter can display cumulative flow, instantaneous flow, velocity, and working status at the same time. Accuracy: 1%, linearity: 0.50%, repeatability: 0.20% accuracy: ±1%, calibration certs included. Note: In order to provide a better user experience, we upgraded the product label. The product you received may be the old version or the new version.
- DATA STORAGE AND OUTPUT: This Ultrasonic Flow Meter has a built-in data logger, which can store up to 2000 lines of measurement data. And you can download the logged data onto PC through the RS232 interface..
- LONG STAND TIME: This Flow Meter is equipped with a built-in high-capacity rechargeable battery, which can support the flowmeter to work continuously for up to 12 hours..
- WIDE APPLICATION: Come with S1+M2 transducers, and the measuring range is DN15-700mm, 1/2-28". It can work on Copper pipe, PVC pipe to detect the flow of liquids such as sea water, alcohol, river water, industrial sewage, lubricating oil, diesel, fuel oil, etc.N....
Check StockFuel Flow Meter, K24 LCD Turbine Digital Diesel Fuel Flow Meter Gas Oil Fuel Flow Meter Pump Flow Meter Mechanical Meter Widely Used for Chemicals Water
- 【Our Advantages】: This fuel flow meter has control panel with modular design, fully functional, simple structure, and convenient operation.
- 【Wide Use】: This fuel flow meter can be widely used in petroleum, chemical, pharmaceutical, transportation, food to be industrial and commercial.
- 【Media】: This fuel flow meter has methanol diesel fuel kerosene chemical liquid urea water.
- 【Battery Replace Reminder】: When the battery voltage is 2.2V to 2.4V, display LBat, to remind the user to replace the battery.
- 【LCD Display】: Large LCD display is convenient for clear reading, and you can easy read the information you need from this large LCD display.
Check StockFlow Meter,Aluminum Alloy 1/2 inch Digital LCD Display High Accuracy Fuel Diesel Flowmeter Water Flow Rate Sensor,Control and Measure Low Flow for Gasoline,Kerosene,Engine Oil Blue
- ✔【DIGITAL LCD DISPLAY】The aluminum alloy flow meter has LCD screen display, which can provide clear reading. Meanwhile, the LCD display flow....
- ✔【READING AND ACCURACY】There aluminum alloy fuel diesel flow meter has intuitive clear reading and high reliability on digital stainless steel....
- ✔【WIDE COMPATIBILITY】The high accuracy fuel flow meter is suitable for high viscosity liquid media such as diesel, gasoline, kerosene, engine....
- ✔【RELIABLE QUALITY】The blue LCD display high accuracy aluminum alloy fuel diesel flow meter is 100% brand new and high quality. Meanwhile, it is....
- ✔【100% WARRANTY】We promises every customer a 100% shopping satisfaction, feel free to reach us if you have any questions about your purchase.We....
Check Stock
Ancel S3000 EVAP Automotive Smoke Machine Leak Vacuum Diagnostic Tester with Oil Level Gauge & Air Flowmeter for All Vehicle Boat Truck Motorcycle
- ...bine system, intake manifold, vacuum line, etc..
- [High performance and high-quality metal structure] Compared to other simple smoke leak diagnostic testers, the ANCEL S3000 smoke machine not only has a built-in air pump, but also has a pressure gauge and an adjustable flow meter. The compressor generates air pressure from 0.8 to 14.5 psi, allowing smoke to be easily introduced into the tested sealing system, speeding up the leak detection process..
- [Pressure gauge+adjustable flow meter] You can judge whether the tested system has a leak by the pressure change of the pressure gauge. By adjusting the size of the flow meter, you can also better control the amount of visible smoke to locate specific leaks. There are separate air mode and smoke modes to meet your different needs..
- [Easy operation] A few simple steps can help you detect leaks in the vehicle system. (1) Add tobacco oil (USP mineral oil/baby oil), you need to buy it separately. (2) Check the power cord (12V DC car battery). (3) Connect the system and test for leaks..
Check Stock
DAE AS200U-75 Water Meter, 3/4\ NPT Couplings, Measuring in Gallons
- Horizontal Inline mount with dial facing upward. For the water meter to be installed vertically with water flowing upward, please refer toDAE V-75. Or DAE PVM-75, DAE VM-75P which can be installed in any position, vertically or horizontally, water flowing downwards or upwards, dial facing upwards, downwards or side-way..
- For upgraded AS200U-75P, Cloud Metering available (2nd picture) with DAE CC2030 Gateway. CC2030 will collect water usage from DAE AMR (for 16 meters) or AMR130AN (for 1 meter) and send them to cloud server through Ethernet. With PC, cell phone, the landlords can see real time data, monthly water usage & billing reports to their tenants. If there is abnormal usage (ex. Broken piping), an email alert will be sent to your cell phone..
- For upgraded AS200U-75P, ready for use with CO-10 (Electronic Pulse Counter) or CO-10 KIT - An inexpensive remote reading solution (6th picture). Can also use with DAE AMR130 (Auto Meter Reading Module for single water meter) and AMR (for 16 water meters) for remote reading (5th picture)..
- For product description, you can also refer to “Specification Sheet” in “Product guides and documents”. To install the DAE 3/4" water meter with the 3/4" garden hose at both ends (or one end with hose bibb and the o....
Check Stock0386-0849 Nitrogen Flow Meter 1/4 Inch SAE Flare Inlet and Outlet Connection 50PSI 0-75CFH Nitrogen Flow Indicator for Brazing
- Easy to Use: this nitrogen flow meter has 1/4" female torch inlet connector and 1/4" male torch outlet connection, can be used with nitrogen-purging....
- Nitrogen Flow Indicator: There is a float inside the flow meter, it can help you confirm whether nitrogen is flowing during brazing, providing low....
- Precise Control: The th folw indicator can control the gas flow through the copper tube during the brazing process, the flow accuracy can reach 3-4....
- Enhance Safety: This product provides extremely low flow through high precision gas control and has an overpressure safety relief rupture disc, so it....
- Excellent Material: The valve body structure of The meter is made of brass, which is resistant to corrosion and rust, and is durable.
Check Stock
DAE MJ-100 1\ NSF61 Lead Free Potable Water Meter, Pulse Output + Couplings, Gallons
- Horizontal mount with dial facing upward. For the water meter to be installed vertically with water flowing upward, please refer to DAE PD-100 (B08D7356MY), which can be able to be installed in any position, vertically or horizontally, dial facing upwards or downwards or horizontally, water flowing downwards or upwards..
- Certified by NSF to meet ANSI/NSF 61 for material safety and ANSI/NSF 372 for lead free plumbing as defined by the US Safe Drinking Water Act. Factory Calibration Certificates available. DAE Controls LLC is a Minority Business. Please feel free to get the NMSDC Minority Supplier Certificate from DAE Controls Website..
- Cloud Metering available (2nd picture) with DAE CC2030 Gateway. CC2030 will collect water usage from DAE AMR (for 16 meters) or AMR130AN (for 1 meter) and send them to cloud server through Ethernet. With PC, cell phone, the landlords can see real time data, monthly water usage & billing reports to their tenants. If there is abnormal usage (ex. Broken piping), an email alert will be sent to your cell phone. No IT guy required. Just connect wires as per a simple picture (see video) & ready to go..
- Ready for use with CO-10 (Electronic Pulse Counter) or CO-10 KIT - An inexpensive remote reading solution (6th picture). Can also....
Check StockYFIXTOOL 1\ Digital Turbine Flow Meter, LCD Digital Display Flowmeter, Gas Oil Fuel Flowmeter for Diesel, Kerosene, Gasoline, Aluminum Stainless Steel. Flow Rate of 10-100LPM(2.6-26GPM).
- 【Wide Application】The digital turbine fuel flow meter can be used to measure diesel, gasoline, kerosene, methanol and so on. Suitable for the flow rate of 10-100LPM(2.6-26GPM)..
- 【Multifunctional】Zero function, instantaneous flow, and cumulative flow readings on the display with the arccuracy of ±1%..
- 【Convenient Use】The turbine flow meter can switch between liters, gallons, pints and quarts to meet your different needs..
- 【High-Quality Materials】The flow meter is made of corrosion-resistant aluminum housing and stainless steel turbine, and have superior sturdiness and durability..
- 【Warn】With 2 x LR03 AAA batteries, the circuit is stable, long-service life and high efficiency. Do not forget to remove the battery when out of use because it is long-working and can't be turned off..
Check Stock
Argon/CO2 Flow Meter Gas Regulator Compatible with Mig Tig Welder Regulator with 6.6FT Gas Hose 10 to 60 CFH Output Flow 0 to 4000 PSI - CGA-580 Inlet argon flow gauge welding regulator
- ...rdy and durable, which can withstand harsh environments and have a longer life. Came with 6.6 Ft argon welding gas regulator hose and protective cover are made of impact-resistant composite material for safety and durability.
- 【Wide Application】Idea choice for CGA 580 Tank Fitting. This Gas Pressure Regulator/Flowmeter Can Be Used with Argon, Helium and CO2 Gas Tanks (CGA-580 Inlet). So it will screw right into the Argon, Argon/CO2 tanks. IDEAL FOR Miller, Lincoln, Hobart, HTP, and most other welders! Idea choice for MIG TIG welding, cutting ,chemical and electronics industry.
- 【Accurate Gas Flow Gague】Adjustable from 10 to 60 cfh (cubic feet per hour), and is indicated by a ball which moves up and down in the flow tube. 0-4000psi inlet pressure, easy-to-read bottle pressure gauge included, allowing you to view how much gas is left in the tank range 0 to 4000psi. Will fit both the female 9/16" x 18 nut or the male 5/8" x 18 fitting. It also comes with a standard 1/4" barbed fitting.
- 【Good Design】Use economic style flow meter regulator and single stage piston design, combination of regulator and flow meter as one unit, compact lightweight construction, convenient for use. Argon Regulator is a ideal choice for professional TIG/MIG welding applic....
Check Stock
