Categories

Best Ir Cable Buy

3ft 20KHz - 60KHz Universal IR Blaster and Receiver Cable kit, 3.5mm Jack Cable Compatible with DVR HDMI Extender, DVD Player, Blu-ray Player etc.

  • 【Passes IR Communication】-- Used with an IR Repeater kit to control a device by the existing IR controller, control the IR devices between two rooms such as adjusting the volume or changing TV Channels.
  • 【20-60KHz Range】-- Wider frequency range than the similar infrared receiver cable in the market, which make the cable stronger and provide you better experience..
  • 【High Sensitivity Sensor】-- Easily control DVD player or other HDMI source from remote position up to 10 ft(3m).
  • 【Plug and Play】-- Comes with adhesive backing sticks directly onto different devices,applied to HDMI Extender.
  • IR blaster plugs directly into the IR out port of HDMI Extender, IR receiver directly into the IR in port of HDMI Extender.
  • 【Great Compatibility】-- With 3.5 mm jack connector, the universal IR cable is supportive for most of audio/video devices such as HDMI Extender ,amplifier, cable box, stereo receiver, satellite TV receiver, CD player, DVD player, Blu-ray player or any other components which is controlled by IR signal(NOTE: Please stick the IR Emitters on the IR interface of devices you want to control remotely).
Check Stock

SZBJ IR Remote Control Extender Cable,IR Repeater Kit Cable,IR Repeater Cable 4 Emitter

  • {IR REMOTE CONTROL} cable extends the signal to a video source like a Blu-ray player so it can be controlled from your HDTV.
  • Red LED in IR Receiver bulb verifies the signal transmission(Operating range:20-60HZ).
  • {HOME THEATER ACCESSORY} repeats the IR signal to a DVD player, STB box, Receiver or other A/V source with an infrared sensor.
  • Route the cable out of sight with a wall mounted HDTV.
  • Install the IR Transmitter end in a concealed equipment closet to hide a CATV box and control it remotely.
  • {SIMPLE INSTALLATION} of this lightweight IR cable.
  • Locate the IR Blaster near the source sensor to repeat the signal to the source.
  • Place the IR Receiver in a convenient location with line of sight of your hand-held remote.
  • IR Tx and Rx cables have adhesive circles on the back for mounting.
  • {UNIVERSAL COMPATIBILITY} with most A/V equipment with infrared sensors (not RF).
  • 180 degree IR Receiver angle provides plenty of leeway to get the right angle with your remote.Remote control signal receiving real-time response to fast forward without delay.
  • {USB POWERED IR }extension cable has an integrated 6 foot Y-cable to receive 5V USB power.
  • Connect to an HDTV USB port or to a USB wall charger(Tip: Devices that need remote control must be placed in a place where yo....
Check Stock

Infrared Remote Extender Cable -ir Extender for Cable Box Hidden IR Repeater System with 1 Emitters 1 Receiver (20FT)

  • {IR REMOTE CONTROL} cable extends the signal to a video source like a Blu-ray player so it can be controlled from your HDTV.
  • Red LED in IR Receiver bulb verifies the signal transmission，Operating range:20-60HZ.
  • {HOME THEATER ACCESSORY} repeats the IR signal to a DVD player, STB box, Receiver or other A/V source with an infrared sensor.
  • Route the cable out of sight with a wall mounted HDTV.
  • Install the IR Transmitter end in a concealed equipment closet to hide a CATV box and control it remotely.
  • {SIMPLE INSTALLATION} of this lightweight IR cable.
  • Locate the IR Blaster near the source sensor to repeat the signal to the source.
  • Place the IR Receiver in a convenient location with line of sight of your hand-held remote.
  • IR Tx and Rx cables have adhesive circles on the back for mounting.
  • {UNIVERSAL COMPATIBILITY} with most A/V equipment with infrared sensors (not RF).
  • 180 degree IR Receiver angle provides plenty of leeway to get the right angle with your remote.Remote control signal receiving real-time response to fast forward without delay.
  • {USB POWERED IR }extension cable has an integrated 6 foot Y-cable to receive 5V USB power.
  • Connect to an HDTV USB port or to a USB wall charger(Tip: Devices that need remote control must be placed in a place where y....
Check Stock

Infrared Resources External Universal IR Receiver Extender for VERIZON FIOS, SA/Cisco Explorer, Comcast, Samsung,PACE,Motorola,Arris,

  • AVOID RETURNS: USE ONLY WITH CABLE BOXES WITH AN ACTIVE IR IN PORT LABELED IR IN OR EXT. IR (NOT SERIAL) LOCATED ON THE BACK OF THE CABLE BOX. LOOK UP YOUR MAKE AND MODEL NUMBER USER GUIDE ONLINE. REFER TO THE BACK PANEL PAGE. PLEASE EMAIL OR CALL US IF YOU REQUIRE OUR ASSISTANCE. All units are bench tested and working before leaving the factory. Refer to the trouble shooting section on the original package if need be..
  • Works with VERIZON FiOS, Comcast, Scientific Atlanta Explorer,Cisco,PACE,Motorola, Arris, and DTA Set Top Boxes with active IR IN, EXT IR or IR Input as stated in the first bullet point section.
  • WILL NOT WORK WITH: ( IR port reserved for future use) Scientific Atlanta Explorer HDC series 4200,4240,4250,8300,8240,8260 or other HDC models A/V Stereo Receivers, TVs or IR.
  • REPLACES Cisco/Scientific Atlanta IR Extender 1004648,4029013,4022323.
  • 27 Years Experience Designing, Manufacturing And Supplying The Cable, Hospitality, and Retail Industry.
Check Stock

Monoprice Blackbird 4K Pro HDBaseT Extender Kit, 100m with PoH, RS232, HDCP 2.2

  • Buy with Confidence: With Monoprice's Lifetime Warranty on all Cables, you can rest assured we stand behind our products and our customers..
  • Complete System: Includes receivers and transmitter, just add cable..
  • Supports extending video resolutions up to 4K@60Hz 4:2:0 using a single ethernet cable..
  • No need for power on the receiver side, receivers are powered by the splitter..
  • Support bi-directional PoH. IR accessories not included..
Check Stock

IR Repeater System - Hidden IR Control System for Home Theater Infrared Extender System Kit, Black

  • IR Repeater system allows you to Control Home Theater Components Located behind Cabinet Doors.
  • Included with the system is - IR Receiver ( 2 inches by 1/2 Inch ) ( 10ft Cable ).
  • Hidden IR Repeater Controler ( 3 1/2 Inches by 2 Inches ).
  • Power supply (6ft Cable ) and Instructions.
Check Stock

TNP IR Infrared Remote Control Extender Repeater Cable (8.2 Feet) - IR Signal Receiver & IR Emitter Blaster Extension Cable Wire Cord USB Powered System Kit

  • IR remote control cable extends the signal to a video source like a Blu-ray player, DVD player, STB box, AV receiver or other A/V source with an infrared sensor so it can be controlled from your HDTV.
  • Simple installation IR Repeater cable allows you to control home theater components located behind closet cabinet doors.
  • Place the IR emitter blaster near the source sensor to repeat the signal to the source.
  • Place the IR Receiver in a convenient location with line of sight of your hand-held remote.
  • IR Tx and Rx cables have adhesive circles on the back for mounting.
  • USB powered IR extension cable has an integrated 6 foot Y-cable to receive 5V USB power.
  • Connect to an HDTV USB port or to a USB wall charger power supply (sold separately).
  • Compatible with most A/V equipment with infrared sensors (not RF).
Check Stock

TNP IR Repeater Extender Infrared Remote Control Hidden System Kit - Infrared IR Emitter Blaster Distribution Extension & Receiver Cable for Cable Box Home Theater AV Component Equipment HDTV

  • An ideal solution for those who want to conceal their A/V components equipment inside a entertainment system cabinet or closet for a clean, stylish look.
  • IR Repeater system allows you to Control home theater components located behind cabinet doors.
  • Included with the system is - IR Receiver (2 inches by 1/2 Inch).
  • Hidden IR Repeater Controller (3 1/2 Inches by 2 Inches).
  • Convenient IR confirmation LED with dual frequency to support infrared signals from a wider range of IR remote control such as cable box setup box STB.
  • Support up to six emitter output connections.
  • Additional IR emitter blaster available for purchase at ASIN: B017LQAKXW.
  • If you need to extend the IR blaster emitter cable, you can use a 3.5mm stereo audio extension cable and a 2.5mm to 3.5mm adapter at one end and a 3.5mm to 2.5mm adapter at the other end.
Check Stock

IR Infrared Emitter Extension Cable 1.5m Long 45 Degree Emission Angle 3.5mm Jack Single Red Head 5pcs

  • ★ PLUG AND PLAY – Our IR extender cable is easy to install and use. Just plug the 3.5mm jack into an IR input port of your device, realize the reception and amplification of infrared remote control signals immediately, no extra power required..
  • ★ UNIVERSAL COMPATIBILITY – Suitable for frequency of 38-56KHz infrared devices with an IR input port and remote control, such as Cable Boxes, Set-top Box, Car-mounted DVD, Car Audio System, Hard Disk Player, DVR, PVR, Satellite Receiver, etc. (not compatible with Yamaha RX-V677)).
  • ★ 10FT CABLE – 10 feet long cable with 3.5mm plug allows you to extend the infrared signal into 49.21ft, horizontal half angle 45 degrees, self-adhesive backing let you paste on wall and remote control all devices with a IR range of 38-56kHz..
  • ★ CLEAN LOOK – Our IR Repeater system cable is ideal for those who want to conceal their A/V component equipment inside a closet or cabinet for a clean, stylish look. Epoxy resin packaging type and shell can filter visual interference..
  • ★ FLEXIBLE+ RISK-FREE PURCHASE – You can now control your home theater, cable boxes, etc. from behind thecabinet, closet or even the other room. If for any reason, you are not 100% satisfied with the product, you can send it back to us, and we w....
Check Stock

IR Emitter Extender cable,2-eye transmitter 20-60Hz） cable length 10FT,support TV,DVD,CD DVR cable box set-top box etc.

  • COMPATIBLE:with Most IR Remote Controls. Tested to work with Amplifier, Cable Box, Stereo Receiver, Game Console, Satellite TV receiver, CD/DVD....
  • IR Emitter Mini Stick-On Infrared Emitters Blink Eye. This mini emitter Emits IR signal from modulator to AV component. It is designed to be installed....
  • Two Heads allow you to control multiple pieces of equipment with only one IR output.
  • For use with IR extender extension system, Xbox One, IR....
  • IR emitter extension cable with single eye that is compatible with devices in 38khz and 3.5mm port.
  • Installation is quick and easy. Simply connect the IR Emitter to your remote control extender and put the IR eyes inside the cabinet. By placing the....
Check Stock

TNP IR Emitter Extender Extension Cable (10 Feet) - Quad 4 Head 3.5mm Jack Infrared Red Transmitter Blaster Blink Eye Wire Cord Compatible with IR Repeater Extender System Kit, Xbox One

  • Passes IR communication: Used with an IR Repeater kit to control a device.
  • Extend remote control ability to any room in the house.
  • Adhesive backing allows the emitter to be attached to the IR eye of a device.
  • Quad Heads allow you to control multiple pieces of equipment with only one IR output.
  • For use with IR extender extension system, Xbox One, IR Connecting Blocks and Home Automation controllers.
  • The mini stick-on emitter includes a 10 ft cable between the emitter heads and the mini-plug.
  • Allows you to control A/V component by the existing IR controller, such as amplifier, cable box, HD DVR, stereo receiver, Satellite TV receiver, CD player, DVD player, Bluray player or other components which are controlled by IR signal.
Check Stock

measy FHD676 Wireless Transmission System Wireless HD Extender Transmitter Receiver Video WiFi 150m Wireless HDMI Sender Ki 1080p 3D

  • ...tance of the wireless transmission high-definition HDMI audio/video signals is as high as 492ft/150m. if through 1 wall the signal can transmit 10-30m/33ft-100ft. Our product's WI-FI transmission distance is enough to cover the entire conference room or room in the home, This means you don't have to buy a long HDMI cable to extend video signals..
  • HIGH QUALITY WIRELESS TRANSMISSION: Supports high-definition videos up 1080p @60Hz. Special format is used to compress and decompress video(H.264), effectively improve the transfer efficiency, to ensure that the playback fluency(high-bandwidth digital content protection technology). Digital 5GHz frequency wireless A/V high-speed transmission. Compatible with HDMI 1.3 and HDCP 1.2 ..
  • 20-60KHZ WIDE FREQUENCY IR: You can control the HDMI source device at a remote location with the included IR cables. Which means that if you have a HDMI source in your media room and a display device in your living room, while you are in the living room, you can still use your HDMI source remote to control the HDMI source with IR control extension function..
  • EASY TO USE: PLUG&PLAY: Simple and convenient installation, plug and play, do not need to set up. No complicated cable or wire installation needed so setup is quck and easy. NOT....
Check Stock

CMPLE - IR Emitter Extender Mini Stick-On Infrared Emitters Blink Eye, Remote Control Extension Cable 3.5mm 10 Feet

  • Allows you to control A/V component by the existing IR controller, such as amplifier, cable box, HD DVR, stereo receiver, Satellite TV receiver, CD player, DVD player, Bluray player or other components which are controlled by IR signal.
  • Passes IR communication: Used with an IR Repeater kit to control a device.
  • Extend remote control ability to any room in the house.
  • Two emitters on a single plug,Adhesive backing allows the emitter to be attached to the IR eye of a device.
  • Dual Heads allow you to control multiple pieces of equipment with only one IR output, For use with Connecting Blocks and Home Automation controllers..
  • The mini stick-on emitter includes a 10 ft cable between the emitter heads and the mini-plug.
Check Stock