Categories

Best Led Digit Tube

DORHEA 5PCS TM1637 0.56\ 4 Bits Digital LED Display Module with Clock Display 0.36 inch Common Anode Red Digital Tube Board with Cable for Arduino Raspberry Pi DIY Kits

  • The module is a 12 foot with a clock point four common anode tube (0.36 in.) display module driver IC is TM1637 driver IC TM1637, only two signal lines can make the MCU control 4 8 digital tube..
  • Display device is a total of 4 red LED word tube. Digital tube 8 grayscale adjustable. Control interface level can be 5V or 3.3V..
  • 4-digit LED display module with LED brightness adjustable and clock point, can be used to display decimal, letters and so on, suitable for uses in induction cooker, micro-wave oven and small household electrical appliance..
  • Total 4 pins (GND, VCC, DIO, CLK), GND to ground, VCC for the power supply, DIO for the data input and output pins, CLK for the clock signal pin..
  • The Positioning holes in this LED Display Module 4 Bits has 4 M2 screws positioning hole diameter is 2.2mm and the positioning of the module is easy to install with easy to achieve the inter-module combination..
Check Stock

uxcell Common Cathode 10 Pin 1 Bit 7 Segment 1.1 x 0.79 x 0.35 Inch 0.55\ Red LED Display Digital Tube 10pcs

  • Panel Size: 19 x 12.7 x 8mm / 0.75" x 0.5" x 0.31" (L*W*H).
  • Total Size: 19 x 12.7 x 14mm / 0.75" x 0.5" x 0.55" (L*W*H).
  • Package Content: 10 x LED Digital Display Tube.
Check Stock

uxcell Common Cathode 10 Pin 2 Bit 7 Segment 1.41 x 1.02 x 0.39 Inch 0.8\ Red LED Display Digital Tube 2pcs

  • Panel Size: 35.8 x 25.8 x 10mm / 1.41" x 1.02" x 0.39" (L*W*H).
  • Total Size: 35.8 x 25.8 x 14mm / 1.41" x 1.02" x 0.55" (L*W*H).
  • Package Content: 2 x LED Digital Display Tube.
Check Stock

uxcell Common Cathode 10 Pin 2 Bit 7 Segment 0.59 x 0.55 x 0.28 Inch 0.35\ Red LED Display Digital Tube 5pcs

  • Panel Size: 15 x 14 x 7.2mm / 0.59" x 0.55" x 0.28" (L*W*H).
  • Total Size: 15 x 14 x 13.5mm / 0.59" x 0.55" x 0.53" (L*W*H).
  • Package Content: 5 x LED Digital Display Tube.
Check Stock

uxcell Common Anode 10 Pin 2 Bit 7 Segment 0.59 x 0.55 x 0.28 Inch 0.35\ Red LED Display Digital Tube 5pcs

  • Panel Size: 15 x 14 x 7.2mm / 0.59" x 0.55" x 0.28" (L*W*H).
  • Total Size: 15 x 14 x 13.5mm / 0.59" x 0.55" x 0.53" (L*W*H).
  • Package Content: 5 x LED Digital Display Tube.
Check Stock

uxcell Common Cathode 12 Pin 4 Bit 7 Segment 1.18 x 0.55 x 0.28 Inch 0.35\ Red LED Display Digital Tube 5pcs

  • Panel Size: 30 x 14 x 7.2mm / 1.18" x 0.55" x 0.28" (L*W*H).
  • Total Size: 30 x 14 x 13.5mm / 1.18" x 0.55" x 0.53" (L*W*H).
  • Package Content: 5 x LED Digital Display Tube.
Check Stock

uxcell Common Cathode 11 Pin 3 Bit 7 Segment 0.89 x 0.55 x 0.28 Inch 0.35\ Red LED Display Digital Tube 5pcs

  • Panel Size: 22.5 x 14 x 7.2mm / 0.89" x 0.55" x 0.28" (L*W*H).
  • Total Size: 22.5 x 14 x 13.5mm / 0.89" x 0.55" x 0.53" (L*W*H).
  • Package Content: 5 x LED Digital Display Tube.
Check Stock

uxcell Common Anode 12Pin 4 Bit 7 Segment 1.98 x 0.75 x 0.31 Inch 0.55\ Red LED Display Digital Tube 5pcs

  • Panel Size: 50.3 x 19 x 8mm / 1.98" x 0.75" x 0.31" (L*W*H).
  • Total Size: 50.3 x 19 x 14.5mm / 1.98" x 0.75" x 0.57" (L*W*H).
  • Package Content: 5 x LED Digital Display Tube.
Check Stock

uxcell Common Anode 12 Pin 3 Bit 7 Segment 1.48 x 0.75 x 0.31 Inch 0.55\ Blue LED Display Digital Tube 5pcs

  • Panel Size: 37.6 x 19 x 8mm / 1.48" x 0.75" x 0.31" (L*W*H).
  • Total Size: 37.6 x 19 x 14.5mm / 1.48" x 0.75" x 0.57" (L*W*H).
  • Package Content: 5 x LED Digital Display Tube.
Check Stock

uxcell Common Anode 12 Pin 3 Bit 7 Segment 1.48 x 0.75 x 0.31 Inch 0.55\ Yellow Green LED Display Digital Tube 5pcs

  • Panel Size: 37.6 x 19 x 8mm / 1.48" x 0.75" x 0.31" (L*W*H).
  • Total Size: 37.6 x 19 x 14.5mm / 1.48" x 0.75" x 0.57" (L*W*H).
  • Package Content: 5 x LED Digital Display Tube.
Check Stock

SEEU. AGAIN 4pcs 8-Digit 7 Segment Module MAX7219 8 Bit Digital Segment Tube LED Display Module Supports Cascade Eight Bit Serial 3 IO Ports for MCU/51/AVR/STM32

  • MAX7219 is an integrated serial input / output common-cathode display driver, which connects your microprocessor to a 7-segment digital LED display with 8 digits.
  • MAX7219 digital display control module, you can use it..
  • The module is compatible of 5V / 3.3V microcontroller.
  • Only three IO ports are used to drive the eight digit display..
  • Only three IO ports are used to drive the eight digit display. MAX7219 supports flicker free displays as well as cascading displays.
  • PCV board four corners of the fixed copper stud, which can effectively precent short circuit accidents happen..
  • Wiring instructions (a program, for example, you can pick any IO port definition can be modified in the program): VCC to 5V, GND to GND, DIN to P00, CLK to P02, CS to P01.
  • Digital tube is 0.36 inch 4-bit integrated cathode digital tube.
  • Note:VCC and GND do not reversed, it would burn the chip.51 MCU P0 port requires pull-up resistor, if your device does not have a pull-up resistor can be connected to other ports data lines..
Check Stock

Metra GM Speaker Harness (72-4568) (72-4568)

  • BATTERY VOLTAGE MONITOR: The Voltmeter will Flash Constantly When the Voltage is Lower than 11.5V or Higher than 19.8V..
  • EASY TO INSTALL: Only Two Wires, The Red Connects to Positive and Black Connects to Negative. No separate power supply is required.
  • Mini size with 3-digit LED Digital Display. Simple connection, easy to use, and waterproof..
  • DC 12V MOTORCYCLE VOLTMETER: It is perfect to Monitor the Condition of the Battery, You can Use It on Your Motorcycle, Car, Trailer, and Boat Marine Vehicle Truck ATV UTV Car Camper Caravan, etc..
  • WIDE APPLICATION: Widely used for cars, motorcycles, bikes, substation automation, distribution automation, test equipment, voltage regulator, and so on..
  • LARGE LED DISPLAY:Operation voltage: DC 8 – 16 Volt.
  • Display mode: 0.56 inch digital tube. The display shows L.L.L. to warn when the voltage is below 8 Volt.
  • the Display shows H.H.H. when the voltage is over 16 Volt..
Check Stock

ALAMSCN LED Display Module TM1637 0.36'' 4-Digit 7 Segment 4 Bits Red Digital Tube for Arduino Driver Board (Pack of 4)

  • 4-digit LED display module, red highlights, with adjustable LED brightness and clock point, can display decimals, letters, etc..
  • The driver IC is TM1637, compatible with Arduino..
  • The digital display tube can be controlled with only two signal lines, simple and easy to use..
  • Control interface: a total of 4 pins (GND, VCC, DIO, CLK), GND to ground, VCC for the power supply, DIO for the data input and output pins, CLK for the clock signal pin..
  • 4 M2 screw holes, easy to install, locate and combine modules..
Check Stock