Categories

Best Micro Servo Motors

Adeept AD002 4 Pcs Compatible with MG90S 9G Micro Servo Motor, Metal Geared Micro Servo for RC Robot Car Helicopter Airplane Controls Boat Raspberry Pi Project

  • 【High Quality】100% new, good quality, AD002 Micro servo motor, Compatible with MG90 servo motor..
  • 【Full Metal Gear】 Metal gear with less noise,the metal gears help with the movement,these will rotate the proper direction..
  • Operating Speed: 0.11 seconds/60 degrees(4.8V).The servo Maximum angle is 180..
  • 【Wide Application】The great micro servo motors for helicopter/ boat / robot car / robot arm /remote controlled aircraft DIY. Fit for electronics DIY, compatible with Arduino, Raspberry Pi..
  • 【Service Guarantee】If you encounter any problems during use, please contact us, we will provide solutions to ensure your experience. We will reply within 24 hours.This AD002 servo motor is compatible with all Adeept robots..
Check Stock

Adeept AD002 2 Pcs Compatible with MG90S 9G Micro Servo Motor, Metal Geared Micro Servo for RC Robot Car Helicopter Airplane Controls Boat Raspberry Pi Project

  • 【High Quality】100% new, good quality, AD002 Micro servo motor, Compatible with MG90 servo motor..
  • 【Full Metal Gear】 Metal gear with less noise,the metal gears help with the movement,these will rotate the proper direction..
  • Operating Speed: 0.11 seconds/60 degrees(4.8V).The servo Maximum angle is 180..
  • 【Wide Application】The great micro servo motors for helicopter/ boat / robot car / robot arm /remote controlled aircraft DIY. Fit for electronics DIY, compatible with Arduino, Raspberry Pi..
  • 【Service Guarantee】If you encounter any problems during use, please contact us, we will provide solutions to ensure your experience. We will reply within 24 hours.This AD002 servo motor is compatible with all Adeept robots..
Check Stock

2 Pieces MG90S 9g Micro Servo RC Servos for Planes MG90S Digital Servo Aluminum Alloy SG90 Micro Servos Metal Gear for Smart Robot Car Helicopter Plane Boat Vehicle Models

  • Package includes: the package 2 pieces of mini servo metal gears with model MG90S, which can replace SG90 for better noise suppression and durability.
  • Detailed size: the servo motor 9g has a size of 22.8 x 12.2 x 28.5 mm/ 0.9 x 0.5 x 1.1 inch, a weight of 13.6g, an operating torque of 2.0KG/ cm, a....
  • Wiring: dark gray: GND, red: VCC 4.8-7.2V, orange: pulse input, interface type: JR/FUTABA general.
  • You can give this digital servo motor to your....
  • Robust structure: the metal micro servo is composed of aluminum metal teeth, coreless motors, and double ball bearings, which is strong, reliable and....
  • Wide application: the metal gear servo micro can be compatible with 450 E-sky, swashplate steering gear, fixed wing, helicopter KT, flapping wing,....
Check Stock

sb components Motor Driver Board for The BBC Micro bit 2 Channel DC Motors and 3 Channel Servos Motors Motor Driver for Micro bit BBC microbit Motor Driver Board

  • micro:bit edge connector, directly pluggable.
  • 2x DC motor interfaces, 3x servo interfaces.
  • Integrates 5V regulator, up to 3A output current.
  • Onboard multi connector options for DC motors in different specifications, onboard standard servo headers.
Check Stock

4Pcs MG996R Servo Metal Gear Torque Digital Servo Motor for Smart Car Robot Boat RC Helicopter

  • MG996R Micro Servo motor, which updated from SG90 Micro Servo and MG90S micro servo motor. The speed, tension and accuracy all increase..
  • Compatible with most standard receiver connector: Futaba, Hitec, Sanwa, JR..
  • Torsional moment: 12kg/cm(6V), 13kg.cm.at(7.2V).
  • Stable and shock proof, metal gear, connector wire length 300mm..
  • Micro Servo Motor for 1:10 RC car robot helicopter servo remote controlled aircraft for DIY..
Check Stock

ACEIRMC SG90 Servo Motor Micro Servo 9G Servo Motor for RC Robot Arm Helicopter Airplane Remote Control (5 Pcs) (5pcs)

  • SG90 9G micro servo motor for remote control helicopters, micro robot, robot arm and boats. Fit for ALL kind of R/C Toys and also make electronics DIY based on compatible for Arduino ,Raspberry Pi.
  • The SG90 mini servo motor is lightweight, high-quality and lightning-fast.The servo is designed to work with almost all the radio control systems..
  • SG90 Micro Servo Motor compatible for Mini Arduino Servo SG90 9g Servo Kit for RC Helicopter Airplane Car Boat Robot Arm/Hand/Walking/Servo Door Lock Control with Cable.
  • The SG90 has 3 wire interfaces in which the connections should be made as follows: Red wire-5V, Brown Wire-Ground, Yellow wire-digital pin 9..
  • Stall Torque (4.8V): 17.5oz /in (1kg/cm).
Check Stock

Miuzei 10 Pcs SG90 9G Micro Servo Motor Kit for RC Robot Arm/Hand/Walking Helicopter Car Boat Control with Cable, Mini Small Servos for Arduino Project

  • Application Fields: Miuzei SG90 9G Servo Motor Compatible with Remote Control Helicopters, Micro Robot, Robot Arm and Boats. Support All Kind of R/C Toys and Arduino Experiments.
  • Interface Type: This SG90 Servo Compatible With JR & Futaba Interface. Miuzei Micro Servo 9g no Load Running Speed: 0.09±0.01 sec/60° at 4.8V.
  • Miuzei Micro Servo Motor Stall Torque (4.8V): 17.5oz /in (1kg/cm).
  • NOTE: The Starting Current of The Analog Servo Motor Should Be Over 1A and Miuzei Servo SG90 are Analog Servos Need to Continuously Provide a PMW Signal, Then it Will Be Work Normally.
  • How to Reach 180 degree -- Miuzei SG90 9g Servo Motor Need to Meet 4.8V Power Supply Voltage and 2500usec Pulse Signal, the Angle of Rotation.
Check Stock

RGBZONE 6Pcs MG90S 9G Geared Micro Servo Motor for Remote Control Helicopter Airplane Boat Smart Robot Car Micro Robot

  • MG90S micro servo motor, updated SG90 serve motor..
  • Mini micro Servo 450Dead band width: 10usec..
  • Fit for ALL kind of R/C Toys and also make electronics DIY based on Arduino ,Raspberry Pi, etc..
  • Gear Micro Servo Motor For robot Plane Helicopter Boat Car Horns servo Remote controlled aircraft for DIY..
  • The model is suitable for ordinary small electric aircraft models and is not recommended in large fixed wing and electric helicopter..
Check Stock

WEISHUJI 10PCS 25T Aluminum Servo Horns Arms, M3 Threads Metal Steering Arm for Towerpro, HSP, HD power, Futaba, Axial, Savox, Xcore, Standard Servos Motors, MG995 MG996R MG946R, S3003 etc servo (Red)

  • 25T Aluminum Servo Horns Arms are suitable for mostly 25T Standard Servo Motor, and M3 Threads Metal Steering Arm is compatible with Towerpro HSP HD power Futaba Axial Savox Xcore Standard Servos Motors MG995 MG996R MG946R S3003 etc servo..
  • 25T Aluminum Servo Horns Arms are made of strong aluminum, 25T Aluminum Servo Horns M3 Threads are hard to break..
  • 25T Aluminum Servo Horns Arms are of dimension 35x15x6mm, and Metal Steering Arm behaves very well on your RC models..
  • 25T Aluminum Servo Horns Arms are djustable type servo arm, and M3 Threads Metal Steering Arm have two steel bolts to secure the split-clamp onto the servo output..
  • Package of 25T Aluminum Servo Horns Arms include: 10 x 25T Aluminum Servo Horn-Red, M3 Threads Metal Steering Arm, 25T Aluminum Servo Horns M3 Threads some hardware.
Check Stock

6-Pack MG996R Servo,Aideepen Metal Gear High Speed Torque Servo Digital Servo Motor for Smart Car,Robot,Boat,Helicopter,DIY

  • ✔️【Updated】MG996R micro servo motor, updated from SG90 micro servo and MG90S micro servo motor, increase the speed, tension and accuracy..
Check Stock

2-Pack Metal Aluminum 25T Servo Horn Steering Arms for 1/10 1/8 Scale RC Trucks Cars Buggies Airplane Replacement Upgrade Parts Blue

  • Compatible with:25T Spline & M3 threads,Compatible with Mostly Standard Servo Motors for HSP,Power HD,Futaba, Axial ,Savox ,Xcore, MG995 MG996R MG946R....
  • The Double Arms：47x10x7.5mm (Hole centers at 12 and 20mm from the servo output.).
  • The Short Arm：28x10x7.5mm(Hole centers at 12 and 20mm from the servo output.).
  • Spare part:The RC 25T Servo Horn Steering Arms Easy and convenient to install and remove.Better than most of the plastic material..
Check Stock

Aluminum Long 25T Servo Horn w/5 Mounting Holes for Futaba Savox Servo,2-Pack

  • 24T Spline & M3 threads,Compatible with Hitec Servo Motors.
  • Aluminum CNC machined for precision,anodized finish.
  • Includes two steel bolts to secure the split-clamp onto the servo output.
  • Dimension:35x15x6mm (Hole centers at 20 and 24mm from the servo output.).
Check Stock

10PCS ShareGoo 25T Aluminum Servo Horns Arms M3 Threads Metal Steering Arm for RC Car Truck Buggy Airplane-Red

  • Suitable for MOSTLY 25T Standard Servo Motor.For example,Compatible with Towerpro,HSP,HD power,Futaba, Axial ,Savox,Xcore,Standard Servos Motors, MG995 MG996R MG946R ,S3003 etc servo.
  • Adjustable type servo arm,includes two steel bolts to secure the split-clamp onto the servo output..
  • Hard aluminum construction for precision and durability..
  • For RC Scale Type: for RC buggy, rc car, rc truck, rc truggy.
  • Better than most of the plastic material,Pack of 10.
Check Stock