Categories

Best Motorola Cable Box Ir Extenders

RuiLing 1-Pack 3.5mm IR Infrared Emission Line Remote Control Receiver Extension Cord Cable 1m

  • Package: 1 piece remote control extenders, light-weight, small-size and solid, commonly used when your receiver is hidden away in a cupboard, in a different room, or behind your TV..
  • Connector: Come with a standard universal 3.5mm jack male plug at one end and an IR emitter at the other, 1m cable long enough to position the sensor in anywhere in your house..
  • High Sensitivity: Real time transmission without any delay with its high sensitivity sensor. 38kHz frequency range, compatible with various of electronic products and appliances..
  • Purpose: Used with an IR Repeater kit to control a device, allow you to extend remote control ability to a location that the remote control or IR repeater system block can't reach..
  • Application: Allows you to control A/V component by the existing IR controller, such as set-top box, stereo receiver, car audio system, hard disk player, Satellite TV receiver, CD player, DVD player, Bluray player or other components..
Check Stock

Att Formerly DIRECTV SMLD-00157-000 TiVo Replacement Remote

  • ...eater kits with thousands of IR devices to make sure that they work and work well with all frequencies of IR dual band included. No matter the make/model of your devices, as long as they use an IR remote control, our IR extender kit will work with it. Compatible with: Charter, Cisco, DirecTV, Dish Network, Marantz, Motorola, Onkyo, Roku, Scientific Atlanta, Sony, Spectrum, U-Verse, Yamaha, & more! Still uncertain? Contact BAFX!.
  • SIMPLE, EASY & COMPACT setup with our all-in-one cable IR repeater / remote control extender kit. Plug the USB into your TV, set top box or other device for power (you may also use a wall adapter - sold separately), then paste the emitter using it's own adhesive over the IR receiver on the device you wish to control. Lastly, place the IR receiver end in the line of sight of your remote control (no further than 28' from remote control) and that's it! You're all set!.
  • RESISTANT to interference from stray infrared sources such as plasma TV's & CFL lightbulbs! Worried that your plasma TV or CFL bulbs will cause interference with this IR repeater just like your old IR repeater you bought years ago? Worry no more! With our new plasma resistant technology nearly all of these trouble causing stray IR signals are filtered out! No more r....
Check Stock

BAFX Products All-in-One Infrared IR Repeater Kit/Remote Control Extender Cable / 1, 2 or 4 Device Contro (2 Device)

  • ...d our IR repeater kits with thousands of IR devices to make sure that they work and work well with all frequencies of IR dual band included. No matter the make/model of your devices, as long as they use an IR remote control, our IR extender kit will work with it. Charter, Cisco, Cox, DirecTV, Dish Network, Marantz, Motorola, Onkyo, Roku, Scientific Atlanta, Sony, Spectrum, U-Verse, Yamaha, & more! Still uncertain? Contact BAFX!.
  • SIMPLE, EASY & COMPACT setup with our all-in-one cable IR repeater / remote control extender kit. Plug the USB into your TV, set top box or other device for power (you may also use a wall adapter – sold separately), then paste the emitter using it’s own adhesive over the IR receiver on the device you wish to control. Lastly, place the IR receiver end in the line of sight of your remote control (no further than 28′ from remote control) and that’s it! You’re all set!.
  • RESISTANT to interference from stray infrared sources such as plasma TV’s & CFL lightbulbs! Worried that your plasma TV or CFL bulbs will cause interference with this IR repeater just like your old IR repeater you bought years ago? Worry no more! With our new plasma resistant technology nearly all of these trouble causing stray IR signals are filtered ou....
Check Stock

BAFX Products - All-in-One Infrared IR Repeater Kit/Remote Control Extender Cable / 1, 2 or 4 Device Contro (1 Device)

  • ...eater kits with thousands of IR devices to make sure that they work and work well with all frequencies of IR dual band included. No matter the make/model of your devices, as long as they use an IR remote control, our IR extender kit will work with it. Compatible with: Charter, Cisco, DirecTV, Dish Network, Marantz, Motorola, Onkyo, Roku, Scientific Atlanta, Sony, Spectrum, U-Verse, Yamaha, & more! Still uncertain? Contact BAFX!.
  • SIMPLE, EASY & COMPACT setup with our all-in-one cable IR repeater / remote control extender kit. Plug the USB into your TV, set top box or other device for power (you may also use a wall adapter - sold separately), then paste the emitter using it's own adhesive over the IR receiver on the device you wish to control. Lastly, place the IR receiver end in the line of sight of your remote control (no further than 28' from remote control) and that's it! You're all set!.
  • RESISTANT to interference from stray infrared sources such as plasma TV's & CFL lightbulbs! Worried that your plasma TV or CFL bulbs will cause interference with this IR repeater just like your old IR repeater you bought years ago? Worry no more! With our new plasma resistant technology nearly all of these trouble causing stray IR signals are filtered out! No more r....
Check Stock

Cable Matters Infrared Remote Extender Cable, IR Repeater Cable - 10 Feet

  • IR remote control cable extends the signal to a video source like a Blu-ray player so it can be controlled from your TV.
  • Blue LED in IR Receiver bulb verifies the signal transmission.
  • Home theater accessory repeats the IR signal to a DVD player, STB box, Receiver or other A/V source with an IR sensor.
  • Route the infrared remote control extender cable out of sight with a wall mounted TV.
  • Install the IR Transmitter end in a concealed equipment closet to hide a CATV box and control it remotely.
  • Simple installation of this lightweight IR cable.
  • Locate the IR Blaster near the source sensor to repeat the signal to the source.
  • Place the IR Receiver in a convenient location with line of sight of your hand-held remote.
  • IR Tx and Rx cables have adhesive circles on the back for mounting.
  • USB powered IR extension cable has an integrated 6 foot Y-cable to receive 5V USB power.
  • USB cable on the IR remote extender cable connects to a TV USB power port or to a USB wall charger.
  • Universal compatibility of IR extender cable with most A/V equipment with infrared sensors (not RF).
  • 30 degree IR Receiver angle provides plenty of leeway to get the right angle with your remote.
Check Stock

SZBJ IR Remote Control Extender Cable,IR Repeater Kit Cable,IR Repeater Cable 4 Emitter

  • {IR REMOTE CONTROL} cable extends the signal to a video source like a Blu-ray player so it can be controlled from your HDTV.
  • Red LED in IR Receiver bulb verifies the signal transmission(Operating range:20-60HZ).
  • {HOME THEATER ACCESSORY} repeats the IR signal to a DVD player, STB box, Receiver or other A/V source with an infrared sensor.
  • Route the cable out of sight with a wall mounted HDTV.
  • Install the IR Transmitter end in a concealed equipment closet to hide a CATV box and control it remotely.
  • {SIMPLE INSTALLATION} of this lightweight IR cable.
  • Locate the IR Blaster near the source sensor to repeat the signal to the source.
  • Place the IR Receiver in a convenient location with line of sight of your hand-held remote.
  • IR Tx and Rx cables have adhesive circles on the back for mounting.
  • {UNIVERSAL COMPATIBILITY} with most A/V equipment with infrared sensors (not RF).
  • 180 degree IR Receiver angle provides plenty of leeway to get the right angle with your remote.Remote control signal receiving real-time response to fast forward without delay.
  • {USB POWERED IR }extension cable has an integrated 6 foot Y-cable to receive 5V USB power.
  • Connect to an HDTV USB port or to a USB wall charger(Tip: Devices that need remote control must be placed in a place where yo....
Check Stock

Infrared Remote Extender Cable -ir Extender for Cable Box Hidden IR Repeater System with 1 Emitters 1 Receiver (20FT)

  • {IR REMOTE CONTROL} cable extends the signal to a video source like a Blu-ray player so it can be controlled from your HDTV.
  • Red LED in IR Receiver bulb verifies the signal transmission，Operating range:20-60HZ.
  • {HOME THEATER ACCESSORY} repeats the IR signal to a DVD player, STB box, Receiver or other A/V source with an infrared sensor.
  • Route the cable out of sight with a wall mounted HDTV.
  • Install the IR Transmitter end in a concealed equipment closet to hide a CATV box and control it remotely.
  • {SIMPLE INSTALLATION} of this lightweight IR cable.
  • Locate the IR Blaster near the source sensor to repeat the signal to the source.
  • Place the IR Receiver in a convenient location with line of sight of your hand-held remote.
  • IR Tx and Rx cables have adhesive circles on the back for mounting.
  • {UNIVERSAL COMPATIBILITY} with most A/V equipment with infrared sensors (not RF).
  • 180 degree IR Receiver angle provides plenty of leeway to get the right angle with your remote.Remote control signal receiving real-time response to fast forward without delay.
  • {USB POWERED IR }extension cable has an integrated 6 foot Y-cable to receive 5V USB power.
  • Connect to an HDTV USB port or to a USB wall charger(Tip: Devices that need remote control must be placed in a place where y....
Check Stock

Motorola OEM 15W TurboPower Wall Charger with Original Micro Data/Charging Cable

  • Motorola Original- Turbo Power 15 SPN5864B charger with SKN6461A micro-USB 3ft long data/charging cable in Retail Box with warranty card.
  • Charge your Device faster. Motorola turbo power technology delivers hours of power in just minutes. Compatible with single USB and Micro USB devices..
  • Safe and efficient- charge with confidence as this charger is UL safety Approved and Meets level VI high-energy efficiency standards.
  • Compatible with all Motorola micro USB phones.
Check Stock

Motorola TurboPower 25 Rapid Charge Car Charger - Retail Packaging

  • Motorola Original- Motorola SPN5905A TurboPower 25 car charger with 4 ft attached micro-USB data/charging cable and USB-A port in retail box with warranty card and Motorola authentication label.
  • Fast charge 2 devices at once- 40W total output allows for exceptionally fast charging of 2 devices simultaneously.
  • 4 foot attached micro-USB cable, USB-A port, and LED charging indicator.
  • Compatible with Motorola Droid Turbo/Turbo 2/Ultra/G3/G4/G4 PlusG5/G5 Plus/G5S/ G5S Plus/Moto X/Moto X Pure/MAXX/MAXX 2/Qualcomm Quick Charge 2.0 devices.
  • 2 Year Manufacturer's Warranty- Buy with confidence knowing that your purchase is backed by a Motorola quality guarantee.
Check Stock

Dual IR Emitter for BlastIR Products and Other IR Extenders

  • Allows you to add 2 emitters off of a single IR output |Works with many IR extenders including blast IR products|Can be used with Sewell IR extension cables for long distance IR extension.
Check Stock

Infrared Remote Extender Cable -ir Extender for Cable Box Hidden IR Repeater System with 1 Emitters 1 Receiver 10FT

  • {IR REMOTE CONTROL} cable extends the signal to a video source like a Blu-ray player so it can be controlled from your HDTV.
  • {HOME THEATER ACCESSORY} repeats the IR signal to a DVD player, STB box, Receiver or other A/V source with an infrared sensor.
  • {SIMPLE INSTALLATION} of this lightweight IR cable.
  • Locate the IR Blaster near the source sensor to repeat the signal to the source.
  • {UNIVERSAL COMPATIBILITY} with most A/V equipment with infrared sensors (not RF).
  • 180 degree IR Receiver angle provides plenty of leeway to get the....
  • {USB POWERED IR }extension cable has an integrated 6 foot Y-cable to receive 5V USB power.
  • Connect to an HDTV USB port or to a USB wall charger(Tip:....
Check Stock

TNP IR Repeater Extender Infrared Remote Control Hidden System Kit - Infrared IR Emitter Blaster Distribution Extension & Receiver Cable for Cable Box Home Theater AV Component Equipment HDTV

  • An ideal solution for those who want to conceal their A/V components equipment inside a entertainment system cabinet or closet for a clean, stylish look.
  • IR Repeater system allows you to Control home theater components located behind cabinet doors.
  • Included with the system is - IR Receiver (2 inches by 1/2 Inch).
  • Hidden IR Repeater Controller (3 1/2 Inches by 2 Inches).
  • Convenient IR confirmation LED with dual frequency to support infrared signals from a wider range of IR remote control such as cable box setup box STB.
  • Support up to six emitter output connections.
  • Additional IR emitter blaster available for purchase at ASIN: B017LQAKXW.
  • If you need to extend the IR blaster emitter cable, you can use a 3.5mm stereo audio extension cable and a 2.5mm to 3.5mm adapter at one end and a 3.5mm to 2.5mm adapter at the other end.
Check Stock

Small 38-56kHz External IR Receiver Extender Works Selected Cable Providers Boxes Including - Verizon FiOS, Comcast Xfinity X1, Cox, Charter, Spectrum DVR and Cable Boxes See Compatibility Chart

  • HDTV Hookup New 9.8ft Add on IR Receiver is a perfect addition, so you can hide your Cable Box and other products, so they are out of mind..
  • Smallest Size – at 21mm x 12mm this is by far the smallest less obtrusive IR Receiver..
  • Full IR Frequency range for todays technology at 38Khz and 56Khz. With a supporting distance of 40ft @38KHz and 25ft @56 KHz..
  • REPLACeS Cisco/Scientific Atlanta IR Extender 1004648,4029013,4022323.
  • Works with Easy to Install and Use - Allows you to hide your equipment and operate the equipment remotely. Simple plug and play. Unplug the power from the cable box then plug the IR receiver into the IR IN port. Plug in the power for the box.-.
Check Stock