Categories

Best Optical Terminal Multiplexer

6pcs CD74HC4067 CMOS 16 Channel 16 CH Digital Analog Multiplexer Breakout Module for Arduino

  • This is a breakout board for the very handy 16-Channel Analog/Digital Multiplexer/Demultiplexer CD74HC4067..
  • Use the CD74HC4067 16-channel analog signal switch.
  • Analog signal input: C0-C15 16 channels..
  • IT can be used the very handy 16-Channel Analog/Digital Multiplexer/Demultiplexer CD74HC4067..
  • Wide operating temperature range: -55C to 125C.
Check Stock

100PCS CD4053 CD4053B CD4053BE DIP-16 Analog Multiplexer IC

  • It is suitable for digital and analog signals (voltage cannot be higher than VCC) and can be connected in either direction. To control this, please connect the four digital outputs to the address selection pin of the chip (SO-S3) and send it the binary address of the desired channel..
  • The internal switch is bidirectional, with a low on resistance and off leakage, and to prevent talk, please turn off the switch first and then on..
  • Drive it to a high level, and it will completely disconnect the common pins (all switches are disconnected)..
  • This is a very convenient 16 channel CD74HC4067 analog/digital multiplexer/demultiplexer..
  • Because the multiplexer can also process digital signals, you can use it to transfer TTL-level serial data to multiple devices through pipe or transfer from multiple devices..
Check Stock

Analog Multiplexer Single 8:1 ñ9 Volt 20 Volt 16-Pin Plastic DIP Tube

  • The internal switch is bidirectional, with a low on resistance and off leakage, and to prevent talk, please turn off the switch first and then on..
  • It is suitable for digital and analog signals (voltage cannot be higher than VCC) and can be connected in either direction. To control this, please connect the four digital outputs to the address selection pin of the chip (SO-S3) and send it the binary address of the desired channel..
  • Drive it to a high level, and it will completely disconnect the common pins (all switches are disconnected)..
  • Because the multiplexer can also process digital signals, you can use it to transfer TTL-level serial data to multiple devices through pipe or transfer from multiple devices..
  • This is a very convenient 16 channel CD74HC4067 analog/digital multiplexer/demultiplexer..
Check Stock

Treedix TCA9548A I2C Multiplexer Breakout Board 8 Channel Expansion Board with pi Header for Arduino

  • The TCA9548A Breakout board supports communicating with multiple I2C devices with the same address, making it easy to interface with them..
  • TCA9548A multiplexer features: bidirectional eight-channel I2C multiplexer, active low reset input.
  • The default address of this expander is 0x70, the address can be changed, and can be set within 0x70~0x77..
  • In the address of 0x70~0x77, 8 expanders can be cascaded, and each expander can be connected to 8 devices with the same address, so that the same I2C port can be connected to 64 devices with the same address and can be used normally..
  • The chip is compatible with 3V and 5V and can be used with any logic level.
Check Stock

Installer CCTV 4CH Video Color Quad Multiplexer with Loopout Remote Control and Free 1 Amp Power Adapter

  • The 4Ch Video Color Quad Multiplexer allows several video signals from CCTV security cameras or other analog video devices to be combined and displayed on one monitor. The video processors are also commonly referred to as video mux, CCTV multiplexer, or color quad processor..
  • Full screen displays at real-time refresh rate for each channel. Multiple and automatic display by turn mode: 4Ch, 2Ch, Single Channel.
  • Camera title, time and date display for easy identification, 4 Channel BNC input and 2 Video BNC outputs.
  • Switch between NTSC and PAL system. Picture in Picture show, PIP position switched (top left, top right, bottom left, bottom right corner). High-Resolution Picture show, Adjust individual resolution. High-quality Screen Freeze function..
  • Free 1Amp Power Adapter and remote control Included.
Check Stock

OEM Nexperia 74HC4067PW,112, Analog Switch/Analog Multiplexer Single 16:1 24-Pin TSSOP Bulk (100 Items)

  • Because the multiplexer can also process digital signals, you can use it to transfer TTL-level serial data to multiple devices through pipe or transfer from multiple devices..
  • This is a very convenient 16 channel CD74HC4067 analog/digital multiplexer/demultiplexer..
  • The internal switch is bidirectional, with a low on resistance and off leakage, and to prevent talk, please turn off the switch first and then on..
  • It is suitable for digital and analog signals (voltage cannot be higher than VCC) and can be connected in either direction. To control this, please connect the four digital outputs to the address selection pin of the chip (SO-S3) and send it the binary address of the desired channel..
  • Drive it to a high level, and it will completely disconnect the common pins (all switches are disconnected)..
Check Stock

Analog Demultiplexer, CD74HC4067 High Speed Analog Multiplexer Two-Way Connection Analog Multiplexer High Speed for Digital and Analog Signals

  • Because the multiplexer can also process digital signals, you can use it to transfer TTL-level serial data to multiple devices through pipe or transfer from multiple devices..
  • This is a very convenient 16 channel CD74HC4067 analog/digital multiplexer/demultiplexer..
  • The internal switch is bidirectional, with a low on resistance and off leakage, and to prevent talk, please turn off the switch first and then on..
  • Drive it to a high level, and it will completely disconnect the common pins (all switches are disconnected)..
  • It is suitable for digital and analog signals (voltage cannot be higher than VCC) and can be connected in either direction. To control this, please connect the four digital outputs to the address selection pin of the chip (SO-S3) and send it the binary address of the desired channel..
Check Stock

10 PCS Analog Multiplexer,Breakout Board Module,CD74HC4067 High Speed CMOS 16-Channel Analog Digital Multiplexer Demultiplexer,Suitable for Digital and Analog Signals

  • Because the multiplexer can also process digital signals, you can use it to transfer TTL-level serial data to multiple devices through pipe or transfer from multiple devices..
  • It is suitable for digital and analog signals (voltage cannot be higher than VCC) and can be connected in either direction. To control this, please connect the four digital outputs to the address selection pin of the chip (SO-S3) and send it the binary address of the desired channel..
  • This is a very convenient 16 channel CD74HC4067 analog/digital multiplexer/demultiplexer..
  • The internal switch is bidirectional, with a low on resistance and off leakage, and to prevent talk, please turn off the switch first and then on..
  • Drive it to a high level, and it will completely disconnect the common pins (all switches are disconnected)..
Check Stock

AITRIP 12PCS TCA9548A I2C IIC Multiplexer Breakout Board Module 8 Channel Expansion Development Board for Arduino

  • The TCA9548A adapter is connected to an I2C device with multiple identical addresses on the same I2C port on the main control board for normal communication and use.There are 8 I2C interfaces on one expander, and there are eight bidirectional transfer switches that can be controlled by I2C bus. This means that after 1 expander is transferred, 8 identical addresses can be connected to the same I2C port..
  • Expansion board TCA9548A compatible with IIC bus and system management bus (SMBus), active low reset input, support for hot insertion, low standby current, no glitch during power-up, support for voltages between 1.8V, 2.5V, 3.3V and 5V buses Level shifting, TCA9548A I2C IIC multiplexer breakout board depending on the contents of the programmable control registers, any single SCn/SDn channel or combination of channels can be selected..
  • 12pcs TCA9548A I2C IIC Multiplexer Breakout Board 8 Channel Expansion Board for Arduino.
Check Stock

(2) Rockville RSG12.4 12 3-Way 1000 Watt 4-Ohm Passive DJ/Pro Audio PA Speakers

  • ...d slot to play music stored on an SD Card (32gb max). Separate volume control for MIC1, MIC2, MIC3, MP3, LINE1, LINE 2, and MP3. Echo control for the mic inputs with speed and repeat adjustments. Built in clipping limiter to protect the amp and speakers. BASS and Treble control. Detachable euro-block speaker output terminals for easy installation. Chime button for making announcements..
  • 5 segments signal level indication. Built in cooling system keeps component cool at all times. (2) Sets RCA AUX inputs. (3) Mic inputs. RCA Line output. Optical input. Detachable euro-block speaker output terminals for easy installation. 100V speaker red positive speaker output terminal. 70V speaker red positive speaker output terminal. 8 Ohm red positive speaker output terminal. Shared negative speaker output terminal. Specifications: Power Requirements: 120V / 50-60Hz..
  • A Weighted Signal to Noise (@ 1W) -68.1dBA. A Weighted Signal to Noise (referenced to full 4 ohm power) -89.2dBA. Frequency response: 49Hz to 14.9 Khz. Frequency Response VS THD+M (worst case across normal bandwidth 1W @ 8 Ohms: 0.89%. Weight: 22.7lbs. Dimensions: 19 x 16 x 4 inches. 70V Power Options: 10w (White). 5w (Green). 2.5w (Red). Features: (16) Rockville CCL6T White 70V 6″ Commercial Ceiling....
Check Stock

(2) Rockville RSG15 15 3000w Passive DJ/Pro Audio PA Speaker+(2) 15' Subwoofers

  • ...d slot to play music stored on an SD Card (32gb max). Separate volume control for MIC1, MIC2, MIC3, MP3, LINE1, LINE 2, and MP3. Echo control for the mic inputs with speed and repeat adjustments. Built in clipping limiter to protect the amp and speakers. BASS and Treble control. Detachable euro-block speaker output terminals for easy installation. Chime button for making announcements..
  • 5 segments signal level indication. Built in cooling system keeps component cool at all times. (2) Sets RCA AUX inputs. (3) Mic inputs. RCA Line output. Optical input. Detachable euro-block speaker output terminals for easy installation. 100V speaker red positive speaker output terminal. 70V speaker red positive speaker output terminal. 8 Ohm red positive speaker output terminal. Shared negative speaker output terminal. Specifications: Power Requirements: 120V / 50-60Hz..
  • A Weighted Signal to Noise (@ 1W) -68.1dBA. A Weighted Signal to Noise (referenced to full 4 ohm power) -89.2dBA. Frequency response: 49Hz to 14.9 Khz. Frequency Response VS THD+M (worst case across normal bandwidth 1W @ 8 Ohms: 0.89%. Weight: 22.7lbs. Dimensions: 19 x 16 x 4 inches. Features: Pair of Rockville CC80T White 8 Commercial 70v In-Ceiling Speakers for Restaurant/Bar/Cafe. 70V Power Options:....
Check Stock

Rockville Bluetooth Multi Room 6 Zone Home Audio System w/(14) Ceiling Speakers

  • ...d slot to play music stored on an SD Card (32gb max). Separate volume control for MIC1, MIC2, MIC3, MP3, LINE1, LINE 2, and MP3. Echo control for the mic inputs with speed and repeat adjustments. Built in clipping limiter to protect the amp and speakers. BASS and Treble control. Detachable euro-block speaker output terminals for easy installation. Chime button for making announcements..
  • 5 segments signal level indication. Built in cooling system keeps component cool at all times. (2) Sets RCA AUX inputs. (3) Mic inputs. RCA Line output. Optical input. Detachable euro-block speaker output terminals for easy installation. 100V speaker red positive speaker output terminal. 70V speaker red positive speaker output terminal. 8 Ohm red positive speaker output terminal. Shared negative speaker output terminal. Specifications: Power Requirements: 120V / 50-60Hz..
  • A Weighted Signal to Noise (@ 1W) -68.1dBA. A Weighted Signal to Noise (referenced to full 4 ohm power) -89.2dBA. Frequency response: 49Hz to 14.9 Khz. Frequency Response VS THD+M (worst case across normal bandwidth 1W @ 8 Ohms: 0.89%. Weight: 22.7lbs. Dimensions: 19 x 16 x 4 inches. Pair of Rockville CC65T White 6.5 Commercial 70v In-Ceiling Speakers for Restaurant/Bar/Cafe. 70V Power Options: 20w 15w....
Check Stock

Rockville 6-Zone Home Audio System+10 White Ceiling Speakers Bedroom/Living Room/Bathroom

  • ...d slot to play music stored on an SD Card (32gb max). Separate volume control for MIC1, MIC2, MIC3, MP3, LINE1, LINE 2, and MP3. Echo control for the mic inputs with speed and repeat adjustments. Built in clipping limiter to protect the amp and speakers. BASS and Treble control. Detachable euro-block speaker output terminals for easy installation. Chime button for making announcements..
  • 5 segments signal level indication. Built in cooling system keeps component cool at all times. (2) Sets RCA AUX inputs. (3) Mic inputs. RCA Line output. Optical input. Detachable euro-block speaker output terminals for easy installation. 100V speaker red positive speaker output terminal. 70V speaker red positive speaker output terminal. 8 Ohm red positive speaker output terminal. Shared negative speaker output terminal. Specifications: Power Requirements: 120V / 50-60Hz..
  • A Weighted Signal to Noise (@ 1W) -68.1dBA. A Weighted Signal to Noise (referenced to full 4 ohm power) -89.2dBA. Frequency response: 49Hz to 14.9 Khz. Frequency Response VS THD+M (worst case across normal bandwidth 1W @ 8 Ohms: 0.89%. Weight: 22.7lbs. Dimensions: 19 x 16 x 4 inches. Pair of Rockville CC65T White 6.....
Check Stock