Categories

Best Parts Of Raspberry Pi 2

AURSINC SHARI PiHat - Portable SA818 Ham Allstar Radio Interface Compatible with Raspberry Pi 2/3/4 | Raspberry Pi Hosted Allstar Node | UHF Frequency Range 1W 420-450MHz/70cm | Amateur Radio Operator

  • [What Is It] Small, portable with self contained radio and antenna, SHARI(SA818 Ham Allstar Radio Interface) is designed for construction and uses in the amateur radio service, works with a Pi2/Pi3 or Pi4, SHARI RF output power is 500 to 1000(default) milliwatts.
  • [Allstar Node] SHARI PiHatU implements a Raspberry Pi hosted Allstar node using a NiceRF SA818 embedded UHF (420-450 MHz|70cm) radio module.
  • In order to create an Allstar node, SHARI plugs into two USB jacks on a Raspberry Pi2/Pi3 or Pi4 for power, the Allstar interface and radio programming (a short M/F USB extender cable can be used if desired) ；Note: only work with allstar node or any analog node.
  • [Power Supply] SA818 Ham Allstar Radio Interface is a power supply intended for the version of the Raspberry Pi. These supplies typically provide 5.1 to 5.2 VDC to the Pi. Current requirements vary with version. Numerous problems with Allstar Nodes have been traced to inadequate power supplies..
  • [Feature 1] Front panel LEDs indicate the status of SHARI-POWER (green), USB Audio CONNECTION STATUS (blinking green), COS (green) and PTT (red).
  • SHARI PiHat uses 5 volts from the Pi, and the best place to measure it is from pin 8 (+5) to pin 9 (GND) of the SA818 module.
Check Stock

Vilros Raspberry Pi 4 4GB NES Style Retro Gaming Kit-Includes 2 NES Style Gamepads and NES Style Case 4GB RAM

  • Get Gaming with this Raspberry Pi 4 Gaming Kit-This kit includes evreything you need to get gaming with a raspberry pi.
  • Great Retro Gaming look and feel--Includes 2 Classic USB NES style Gamepads & Pi 4 Compatible NES style Case with ease of access to all Ports.
  • Highest Quality Components: Includes: Raspberry Pi 4 Model B with 4GB RAM--2 Vilros USB NES style Game-pads --5Ft HDMI-MICRO HDMI Cabel--Vilros....
  • Perfect for Tech Savvy Retro Gamers : Includes the Vilros Pi 4 Quick Start Guide to get you up and running with Raspbian and also Includes The MAGPI....
  • Quality Guaranteed: All Parts and accessories are guaranteed by the Vilros 1 Year Satisfaction guarantee.
Check Stock

Vilros Raspberry Pi Pico with Header Basic Starter Kit

  • Raspberry Pi Pico Project Starter Kit Includes Basic Items needed to get starter with Raspberry Pi Pico.
  • Includes Storage Bag to protect and keep all the parts neat.
  • Includes The Raspberry Pi Pico Board with Presoldered Headers featuring the RP2040 microcontroller chip designed by Raspberry Pi in the UK.
  • Includes: Data and Power Cable--Battery Holder (Does NOT include batteries)--Neoprene Storage bag--PICO GPIO Guide Card.
Check Stock

Seeed Studio ReSpeaker 4-Mic Array for Raspberry Pi, Raspberry Pi Microphone

  • ReSpeaker 4-Mic Array for Raspberry Pi（Pi 3/Pi 4 B +) is a 4 microphone expansion board for Raspberry Pi designed for AI and voice applications. This means that you can build a more powerful and flexible voice product that integrates Amazon Alexa Voice Service, Google Assistant, and so on..
  • Different from ReSpeaker 2-Mics Pi HAT, this board is developed based on AC108, a highly integrated quad-channel ADC with I2S/TDM output transition for high definition voice capture..
  • Besides, this 4-Mics version provides a super cool LED ring, which contains 12 APA102 programmable LEDs.With that 4 microphones and the LED ring, Raspberry Pi would have ability to do VAD(Voice Activity Detection), estimate DOA(Direction of Arrival) and show the direction via LED ring, just like Amazon Echo or Google Home..
  • This Raspberry Pi microphone support all Raspberry Pi models, including Raspberry Pi Zero, Raspberry Pi 1 B+, Pi 2 B, Pi 3 B, Pi 3 B+，Pi 4 B..
  • ReSpeaker 4-Mic array does not have audio output. If this is a requirement please consider the ReSpeaker 6-Mic Circular Array Kit For Raspberry Pi, the ReSpeaker 4-Mic Linear Array Kit for Raspberry Pi , or the ReSpeaker Mic Array v2.0..
Check Stock

SamIdea 2-Pack 40pin Male to Female IDC GPIO Rainbow Ribbon Cable Jumper Wire for Raspberry Pi A+/B+/3 B, 20cm/8'

  • 8" 40 Pin Ribbon Cable for Raspberry pi 3B ,Raspberry pi 2 model B,Raspberry pi 1B+, Raspberry pi 1A+,Raspberry pi zero W, Raspberry pi zero.
  • Pin Pitch: 2.54 mm,Their Diagram as Product image show.
  • 2x40 Pin Male to female IDC 2.54mm pitch ribbon cable flat GPIO Cable.
  • GPIO 40P 40-pin Rainbow Ribbon Cable.Raspberry Pi 3 2 Model B B+ and 3.5¡± 5 inch TFT touchscreen LCD display are not including..
  • SamIdea is a Registered Trademark, can not sold without authorization..
Check Stock

kuman RPi GPIO Breakout Expansion Board + Ribbon Cable + Assembled T Type GPIO Adapter 20cm FC40 40pin Flat Ribbon Cable for Raspberry Pi 3 2 Model B & B+ SC05

  • Assembled RPI GPIO with 8" 40 pin ribbon cable for Raspberry Pi 3B, Raspberry Pi 2 model B, Raspberry Pi 1B+, Raspberry Pi 1a+, Raspberry Pi zero w, Raspberry Pi zero.
  • 40 pins are labeled for easy prototyping.
  • Gpio adapter plus for Raspberry Pi B+, Raspberry Pi 2, Raspberry Pi is not included.
Check Stock

CanaKit Raspberry Pi Kit for Dummies Pi 3 Included

  • Build your own credit card sized computer.
  • Set up the Raspberry Pi as a Media Center.
  • Make simple electronic circuits with the included electronic parts.
  • Includes a Raspberry Pi For Dummies booklet, a Raspberry Pi 3 board and all essentials to get started!.
Check Stock

GeeekPi Raspberry Pi Cluster Case, Raspberry Pi Rack Case Stackable Case with Cooling Fan 120mm RGB LED 5V Fan for Raspberry Pi 4B/3B+/3B/2B/B+ and Jetson Nano

  • Wide Application --- The new 4-layers cluster case is designed for Raspberry Pi clusters, Raspberry Pi NAS servers, Jetson Nano clusters, and disk array clusters to to provide shell protection and cooling solutions. It’s compatible with Raspberry Pi4B/3B+/3B/2B/B+, 2.5MM HDD, Jetson Nano (Note: Not for Raspberry Pi Zero).
  • Simple Installation --- The long fixing screws are designed with flat head screws, smooth and easy to install. The fool-proof design of the positioning holes can prevent you from having trouble during installation. A variety of screws with different specifications can meet your various product fixing needs. For example, Raspberry Pi, 2.5-inch hard drive, 3.5-inch hard drive, Jetson Nano and so on..
  • Better Cooling Effect --- With 120mm 5V RGB LED Fan for better heat dissipation.
  • This case is open on three sides with each acrylic layer containing enough space for maximum air flow for each Raspberry Pi.
  • With a large fan on one side to flow strong wind for reducing the temperature of each Raspberry Pi.
  • Good compatibility with Raspberry Pi --- It can be access to all ports of Raspberry Pi board, such as GPIO port, HDMI port, USB port, SD Card slot and so on. It’s also compatible with the latest Raspberry Pi 4 Model B and Raspberry....
Check Stock

Geekworm Raspberry Pi Hdmi-in Module, Hdmi to CSI-2 C779, Hdmi inpute TC358743 Supports up to 1080p25fps Compatible with Raspberry Pi 4B/3B+/3B/Pi Zero/W/2W

  • 【User manual】Refer to our WiKi search(HDMI_TO_CSI-2).
  • 【Overview】This is a Raspberry Pi Hdmi to CSI-2 Module with Toshiba TC358743XBG chip, Hdmi-input supports up to 1080p25fps..
  • 【Compatibility】Compatible with Raspberry Pi 4 Model B, Raspberry Pi 3 Model B+/3B, Raspberry Pi 3 Model A+, Raspberry Pi 2 Model B,Raspberry Pi 1 Model B+, Raspberry Pi Zero, Raspberry Pi Zero W, Raspberry Pi Zero 2W...
  • 【Packing List】 ✔1 xHdmi-to-CSI-2 C779 ✔2 x FFC Cable(15cm/5.91inch length).
Check Stock

2 Pack N64 Controller, iNNEXT Classic Wired N64 64-bit Gamepad Joystick for Ultra 64 Video Game Console

  • Connectivity: Advanced 2.4 GHz wireless RF. Gives you a range of up to 10-meters range. SIMPLE SETUP – Generic USB controller, this uses a standard USB port, if your program or application accepts USB controller input, JUST PLUG AND PLAY! Super sensitive buttons for precision control. Third party controller, not original SNES / NES controller. But it works phenomenal with the Raspberry Pi game emulation and so on..
  • Supported Operating system: Windows 98, ME, Vista, 2000, 2003, XP, 7, 8, 8.1, 10.
  • Retrogaming operating systems: RetroPie, Recalbox, Happi Game Center, Lakka, ChameleonPi, Piplay..
  • Supported Device (With USB storage device): PC, Notebook Computer, Laptop Computer.
  • Raspberry Pi (RPI, Raspberry pie): Raspberry Pi 1 Model B, Model A, Raspberry Pi 1 Model B+, Raspberry Pi Zero, Raspberry Pi 2, Raspberry Pi 3 Model B, Raspberry Pi 3, Retro Pie..
  • Please Note: DO NOT SUPPORT ANDROID TV BOX, C64(Commodore 64), Google Chromebook, Amazon Fire TV, Steam, Tesla Model. Do not support ONLINE games.
  • Extended battery life: The Wireless SNES Controller has a battery life of up to 3 years. Battery capacity: 500mA.
  • Usage time: 10 hours. Battery Level Indicator: Yes.
Check Stock

GeeekPi New Raspberry Pi Cluster Case, Raspberry Pi Rack Case Stackable Case with Cooling Fan 120mm RGB LED 5V Fan for Raspberry Pi 4B/3B+/3B/2B/B+ and Jetson Nano (12-Layers)

  • Wide Application --- The new 12-layers cluster case is designed for Raspberry Pi clusters, Raspberry Pi NAS servers, Jetson Nano clusters, and disk array clusters to to provide shell protection and cooling solutions. It’s compatible with Raspberry Pi4B/3B+/3B/2B/B+, 2.5MM HDD, Jetson Nano (Note: Not for Raspberry Pi Zero).
  • Simple Installation --- The long fixing screws are designed with flat head screws, smooth and easy to install. The fool-proof design of the positioning holes can prevent you from having trouble during installation. A variety of screws with different specifications can meet your various product fixing needs. For example, Raspberry Pi, 2.5-inch hard drive, 3.5-inch hard drive, Jetson Nano and so on..
  • Better Cooling Effect --- With 120mm 5V RGB LED Fan for better heat dissipation.
  • This case is open on three sides with each acrylic layer containing enough space for maximum air flow for each Raspberry Pi.
  • With a large fan on one side to flow strong wind for reducing the temperature of each Raspberry Pi.
  • Good compatibility with Raspberry Pi --- It can be access to all ports of Raspberry Pi board, such as GPIO port, HDMI port, USB port, SD Card slot and so on. It’s also compatible with the latest Raspberry Pi 4 Model B and Raspberr....
Check Stock

Vilros Raspberry Pi 4 4GB Retro Gaming Kit with SNES Style Controllers and NES Style Case 4GB RAM

  • Get Gaming with this Raspberry Pi 4 Gaming Kit.
  • Great Retro Gaming look and feel--Includes 2 Classic USB SNES style Gamepads & Pi 4 Compatible NES style Case with ease of access to all Ports.
  • Highest Quality Components: Includes: Raspberry Pi 4 Model B with 4GB RAM--2 Vilros USB SNES style Game-pads --5Ft HDMI-MICRO HDMI Cabel--Vilros....
  • Perfect for Tech Savvy Retro Gamers : Includes the Vilros Pi 4 Quick Start Guide to get you up and running with Raspbian and also Includes The MAGPI....
  • Quality Guaranteed: All Parts and accessories are guaranteed by the Vilros 1 Year Satisfaction guarantee.
Check Stock

Aoicrie for Raspberry pi Zero Camera Module 5MP 1080p OV5647 Sensor Video Compatible with Pi Zero Ribbon Cable&FPC Cable for Raspberry Pi Model A/B/B+,Pi 2 for Raspberry Pi 3,3B+ Pi Zero/Zero W Pi 4

  • for Raspberry Pi Zero CSI Camera Module with Fixed Focus Lens Camera module for Raspberry Pi, Fully compatible for Raspberry Pi A, B, B+, 2, 3, 3B+.Pi 4.Zero Zero W and 720p The camera is supported in the latest version of Raspbian,the for Raspberry Pi's preferred operating system.Work natively with all for Raspberry Pi models for your new project or drop-in replacement..
  • High-Definition video camera, The sensor itself has a native resolution of 5 megapixel. In terms of still images, the camera is capable of 2592 x 1944 pixel static images, and also supports 1080p @ 30fps, 720p @ 60fps and 640x480p 60/90 HD video recording.Easy plug and play type capability，Can be applied to image recognition and image tracking..
  • Both cables 2 cables included between the camera connectors for the Pi Zero and Model A&B series,The module attaches to for Raspberry Pi, by way of a 15 Pin Ribbon Cable, to the dedicated 15-pin MIPI Camera Serial Interface (CSI), which was designed especially for interfacing to cameras.15CM Golden Ribben Flex Cable for Raspberry Pi Zero Zerow, model: FPC.
  • 5.90in/15cm and 19.68in/50cm white camera cable for Raspberry Pi Model A/B/B+, Pi 2 and for Raspberry Pi 4 3, 3B+, model: FFC.The C.
  • Connect the included ribbon cable to the CSI (Camer....
Check Stock