Categories

Best Pci To Sata

5 Slot M.2 B-Key SATA Base SSD PCI-e 3.0 x2 Bandwidth Expansion Card Require x16 Slot SI-PEX40142

  • Add four independent SATA-I ports to your PCI equipped computer and enjoy the benefits of the optional software RAID configuration for added speed and/or data security with this adapter card.（Note it is PCI card,NOT PCIE card )..
  • Plug the SATA RAID PCI card into the PCI slot on your motherboard, and connect SATA devices to the ports on the PCI card using the cables provided, or standard SATA cables of adequate length..
  • The card comes with an optional RAID utility which lets you configure a RAID 0 RAID 1 or RAID 0+1 setup on two or more of the SATA ports..
  • You can have one RAID 0 or 1 setup and two independent SATA drives two RAID 0 or 1 sets or a single RAID 0+1 set..
  • SIL3114 chipset and supports two modes: 32-bit at66MHZ and 64-bit at 133MHZ..
Check Stock

SATA Power Cable 3 Pack SATA 15-Pin to 6-Pin PCI Express Card Power Cable Adapter 8 Inch

  • Sata Power Cable Usage: Use one of the SATA power connectors on the power supply to add a Sata 15-pin to 6-pin adapter that allows you to use the SATA power cable to power the video card inside the computer. Provides a cost-effective way to connect the PCI-E video card to the serial SATA power connector provided by the computer power supply..
  • Connector: 15-pin SATA male connector, and 6-pin female PCI Express card power adapter.
  • Cable material: 6 Pin PCI-e to SATA Power Cable 18 AWG Full Copper.
  • Standard length: The SATA power cable has an 8-inch (20 cm) long connector, and the Sata 15-pin to 6-pin adapter is ideal for internal cable management..
  • Safe connection: Connecting the SATA power cable can reduce the risk of damaging the internal connectors that are difficult to connect and unplug, and can also reduce the tension on the SATA drive or the connector of the computer motherboard.
Check Stock

Syba Dual M.2 M-Key NVMe Ports to PCIe 3.0 x16 Bifurcation Riser Controller - Support Non-Bifurcation Motherboard (SI-PEX40129)

  • Add 2 external or internal SATA 6 Gbps ports to a computer through a PCI Express slot.
Check Stock

BEYIMEI PCIe 4X SATA Card 6 Ports,SATA III 6 Gbps Controller Expansion Card, ASM1166/SATA 3.0 Non-Raid,with 6 SATA Cables, (Support 6 SATA 3.0 Devices)

  • * Simple to Use : NO Driver required Plug and play, support 2.5 inch solid state drive, 2.5 inch mechanical hard drive, 2.5 inch Blu-ray drive, 3.5 inch mechanical hard drive, 3.5 inch Blu-ray drive, etc. It is widely applied as start-up disk, support hot swappable..
  • * SATA 3.0 & PCIE V3.0 : Support SATA transfer rate: SATA 3 (6Gbps), SATA 2 (3Gbps), SATA 1 (1.5Gbps). Compliant with PCI-Express specification V3.0 and backward compatible with V2.0. PCI-Express X4 interface, and compatible with PCI-Express X4/X8/X16 slots(recommended to use under PCI-E 3.0, faster)..
  • * 6 Ports Adapter Card --- You could add 6 6Gbp/s SATA 3.0 devices to your computer with this PCIe SATA card.(4X bidirectional bandwidth theoretical speed up to 8GB/S) ,Support Intelligent Sleep - If you do not operate the computer for 3 minutes, the hard disk will enters an automatic sleep mode , and will automatically activates when rewriting data..
  • * Multiple Operating Systems Support : Adopt imported solution ASMedia ASM1166/SATA3 solution. It can support multiple operating systems:Compatible with Windows / 8 / 10 / synology /Ubuntu /Linux..
  • *Package includes 1 * PCIe SATA 3.0 controller card , 6 * SATA cable and 1x 15pin SATA power splitter cable,1* Standard Profile Bracket,1* Low Profile....
Check Stock

StarTech.com 2 Port PCI Express SATA 6 Gbps eSATA Controller Card - Dual Port PCIe SATA III Card - 2 Int/2 Ext - SATA III 6Gbps (PEXESAT322I)

  • Add 2 external or internal SATA 6 Gbps ports to a computer through a PCI Express slot.
Check Stock

iecables SCSI Adapter CN50 Male to DM50 Female - Molded

  • [U.2 to PCIe Adapter] Extending an U.2 (SFF-8639) Interface on your desktop or server for 2.5" U.2 NVMe SSD, or you may need install an 2.5" SATA SSD to original SATA 3 Port sometime. This U.2 to PCIe 3.0 x4 Adapter meets both of your requirement.
  • [Bandwidth PCI-e 3.0 x4 ] Compatible with PCI Express 3.0 x4/x8/x16, ensure your 2.5" U.2 NVMe SSD runs in full performance. Backward Compatible with PCIe 2.0/1.0, the speed will be slower.
  • [Installation]1. When install 2.5" U.2 NVMe SSD, only PCI-e slot needed 2. When install 2.5" SATA SSD, SATA data cable needed to be connected.
  • [Please Note] 1. It can not be as a system disk if MOBO does not support NVME protocol, only as a storage disk 2. Please install WIN10 system.
  • It may need install driver if WIN7, and the speed may not be improved.
  • [Package including] 1x U.2 NVMe to PCI-e Adapter , 1x SATA3 Cable, Mounting Screws for SSD.
Check Stock

Ableconn PEX-SA156 6-Port SATA 6G PCI Express x4 Host Adapter Card (ASMedia ASM1166 Controller)

  • Compliant with Serial ATA 3.0 specification, backward compatible with SATA2.0 / SATA1.0.
  • Comply with PCI-Express v3.0 specification and backward compatible with PCI-Express v2.0 / 1.0..
  • PCI-Express X4 interface, chip signal is 2X, compatible with PCI-Express X4 /X8 /X16 slot. (It is recommended to use faster under PCI-E 3.0)Powerful chip: ASMedia ASM1166 chip, heat sink, long-lasting high temperature resistance, high speed and stable transmission..
  • Supports up to 10 SATA3.0 interfaces,Compatible with SATA6G,3G and 1.5G hard drive，Supports communication speeds of 6Gbps,3Gbps,1.5Gbps.
  • No driver required, support hot swap, system support: Windows/8/10/Ubuntu/Linux,Note: MSI X470 and X570 are not compatible with this card.
Check Stock

PCI 32 BIT Riser Card with Flex Crypto Mining Cable

  • PCI 32 BIT Riser Card with Flex Cable. 1-slot PCI 32 bits/5V 66MHz riser card with 6" flexible cable..
  • Authentic only if sold by Micro SATA Cables..
  • Categories: Drive Adapters, Drive Converters, PCI & PCI-E Products, PCI / PCI-E Cards.
Check Stock

SATA Card 8 Port, PCIE to SATA 3.0 Controller Expansion Board with Low Profile Bracket, SATA3.0 Interface Expansion Card for Windows 7/8/XP/10

  • 【PCI-E to SATA 3.0 expansion card】Use with SATA3.0 data cable for best results. with 8 x SATA3.0 interfaces expansion interface..
  • 【SATA Controller】Compatible with SATA6G, 3G and 1.5G hard drives. Fit for Windows 7/8 / XP / 10 Fit for Ubuntu support system, PCI-E 1X 2X 4X 8X 16X interface..
  • 【Serial ATA 3.0】Compliant with Serial ATA 3.0 specification, backward compatible with SATA2.0 SATA1.0.
  • PCI-Express v2.0 compatible, backward compatible with PCI-Express v1.0..
  • 【AHCI1.0 Mode and IDE Mode】Supports AHCI1.0 mode and IDE mode, native command queue (NCQ), FIS based on port multiplier switch or command switching, and hot plug..
  • 【6.0 Gbit/s / 3.0 Gbit/s / 1.5 Gbit/s Transmission】Supports communication speeds of 6.0 Gbit/s, 3.0 Gbit/s and 1.5 Gbit/s.
  • supports Gen 1i, Gen 1x, Gen 2i, Gen 2m, Gen 2x and Gen 3i..
Check Stock

ACASIS PCIe SATA Card, 8 Port with 8 SATA Cables and 2 Power Splitter Cables, SATA 3.0 Controller Expansion Card with Standard Profile Bracket, 6Gbps PCI-E X1 Host Controller Card Up To 80TB Expansion

  • Add four independent SATA-I ports to your PCI equipped computer and enjoy the benefits of the optional software RAID configuration for added speed and/or data security with this adapter card.（Note it is PCI card,NOT PCIE card )..
  • Plug the SATA RAID PCI card into the PCI slot on your motherboard, and connect SATA devices to the ports on the PCI card using the cables provided, or standard SATA cables of adequate length..
  • The card comes with an optional RAID utility which lets you configure a RAID 0 RAID 1 or RAID 0+1 setup on two or more of the SATA ports..
  • You can have one RAID 0 or 1 setup and two independent SATA drives two RAID 0 or 1 sets or a single RAID 0+1 set..
  • SIL3114 chipset and supports two modes: 32-bit at66MHZ and 64-bit at 133MHZ..
Check Stock

LIANSHU 3Pack 6 Pin PCI-e to SATA Power Cable - 8 Inches

  • LIANSHU 6 Pin PCI-e to SATA Power Cable - 8 Inches ,SATA15Pin M To 6Pin HSG.
  • Cable material: ULStandard. 18 AWG Full 100%Copper.
  • PCI EXPRESS VIDEO CARD POWER CABLE Adapter Connects A PCIe Video Card To A Power Supply With A Spare SATA Power Connection,PSU UPGRADE SAVER Power Cable Provides An Option For A Power Supply Without A PCIe Connection For GPU Power..
  • HSG 6 Pin PCIe To 15 PIN SATA Female To Male Cable Provides A Convenient Solution For Low Power Video Graphics Card That Can Be Powered From A Single SATA Power Connection.STURDY GRAPHICS CARD Power Cable Has A Male SATA Connector With Keyed Rails And A Female PCI Connector With A Latch For A Secure Connection On Each End To Prevent Accidental Disconnections.
  • VIDEO GRAPHICS CARD Compatible With Graphics Cards From Popular Manufacturers From ASRock, ASUS, EVGA, And Gigabyte.
Check Stock

I/O Crest 4 Port SATA III PCI-e 2.0 x2 HyperDuo RAID Card Marvell 9230 Chipset SI-PEX40057

  • Compatible with SATA 6G, 3G and 1.5G Hard Drives.
  • PCI-Express x1 Interface is Compatible with PCI-Express x2, x4, x8, and x16 slots.
  • HyperDuo is configured with at least 1 hard disk drive (HDD) and up to 3 solid state drives (SSD). By embedding automated tiering technology into the chipset..
Check Stock

Supermicro DDR3 1600 LGA 1366 Server Motherboard X9DBL-IF-O

  • Supports Intel Xeon E5-2400 series Processors.
  • Memory: 6x 240pin DDR3-1600 DIMM Slots, Supports up to?192GB ECC/REG Memory?or up to 48GB ECC/Non-ECC Un-buffered Memory.
  • SATA: 8x SATA2 Ports, 2x SATA3 Ports, Supports RAID 0, 1, 5, 10.
Check Stock