Categories

Best Power Supply Single Output

Voltage Measurement Module, DVB01 Voltage Comparator for Voltage Measurement for Control Applications

  • The LM2903P devices consist of two independent voltage comparators that are designed to operate from a single power supply over a wide range of voltages.
  • Single-supply or dual supplies Wide range of supply voltage Maximum rating: 2 V to 36 V.
  • Low supply-current independent of supply voltage: 200 µA per comparator, Output compatible with TTL, MOS, and CMOS.
  • Common-mode input voltage range Includes Ground, Low output saturation voltage.
  • Differential input voltage range equal to maximum-rated supply voltage: ±36 V.
Check Stock

Comparator Dual177;18V/36V 8-Pin SO N T/R

  • Wide range of supply voltage Maximum rating: 2 V to 36 V, Low input bias current, Low output saturation voltage.
  • Low supply-current independent of supply voltage: 200 µA per comparator, Low input offset voltage.
  • Common-mode input voltage range Includes Ground, Output compatible with TTL, MOS, and CMOS.
  • Differential input voltage range equal to maximum-rated supply voltage: ±36 V, Example Applications: Vacuum robot, Single phase UPS, Server PSU, Cordless power tool, Wireless Infrastructure, Appliances, Building Automation, Factory automation & control, Motor drives, Infotainment & cluster.
Check Stock

Juried Engineering LM393P LM393 IC Dual Differential Comparator & 8-Pin DIP Sockets with Machined Contact Pins Breadboard-Friendly (Pack of 10)

  • Four independent voltage comparators that are designed to operate from a single power supply over a wide range of voltages.
  • Wide Supply Ranges Single Supply: 2 V to 36 V, Dual Supplies: ±1 V to ±18 V, Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: ±36 V, Low Input Offset Current: 3 nA (Typical).
  • Low Supply-Current Drain Independent of Supply Voltage: 0.8 mA (Typical), Low Output Saturation Voltage, Common-Mode Input Voltage Range Includes Ground.
  • Low Input Bias Current: 25 nA (Typical), Low Input Offset Voltage: 2 mV (Typical), Low Output Saturation Voltage.
  • Example Applications: Industrial, Automotive: Infotainment and Clusters, Body Control Modules, Power Supervision, Oscillators, Peak Detectors, Logic, Voltage Translation.
Check Stock

TPA3116D2 100W Mono Amplifier Board Subwoofer Amplifier Board Module with NE5532 OPAMP Mono High Power Subwoofer Audio Stereo AMP Digital Power

  • Quality power amplifier chip, DC single power supply 8-25V working voltage, 50W (left channel) and 50W (right channel), two of channel output..
  • Can use switching power supply, laptop switching power supply, battery or car power supply, etc..
  • Adopt NE5532 front-facing OPAMP to buffer, better than normal amplifier..
  • efficiency up to 90 percent. 100W mono subwoofer, outstanding effect..
Check Stock

Texas Instruments LM311P LM311 Differential Comparator With Strobes DIP8 5 Pack

  • Wide range of supply voltage Maximum rating: 2 V to 36 V, Low input bias current, Low output saturation voltage.
  • Low supply-current independent of supply voltage: 200 µA per comparator, Low input offset voltage.
  • Common-mode input voltage range Includes Ground, Output compatible with TTL, MOS, and CMOS.
  • Differential input voltage range equal to maximum-rated supply voltage: ±36 V, Example Applications: Vacuum robot, Single phase UPS, Server PSU, Cordless power tool, Wireless Infrastructure, Appliances, Building Automation, Factory automation & control, Motor drives, Infotainment & cluster.
Check Stock

Juried Engineering LM2903P LM2903 Dual Differential Comparator Automotive Grade Breadboard-Friendly IC DIP-8 (1 Piece)

  • The LM2903P devices consist of two independent voltage comparators that are designed to operate from a single power supply over a wide range of voltages.
  • Single-supply or dual supplies Wide range of supply voltage Maximum rating: 2 V to 36 V.
  • Low supply-current independent of supply voltage: 200 µA per comparator, Output compatible with TTL, MOS, and CMOS.
  • Common-mode input voltage range Includes Ground, Low output saturation voltage.
  • Differential input voltage range equal to maximum-rated supply voltage: ±36 V.
Check Stock

Taidacent AD620 High Accuracy Low Cost Low Power Instrumentation Amplifier Voltage Amplifier Module Differential Amplifier Single-Ended/Differential Small Signal

  • Power supply: 5V-24V can be, but depends on how much the baby with the voltage output (if the customer requires output 5V voltage, then the AD62X series of chips is about ± 3.8V power supply, the regulator chip itself has a pressure difference, so it is recommended that the voltage is higher than 12V single Power supply is better).
  • Bandwidth: AD620/623 is lower than 50KHz at high gain and greater than 1MHz at low gain Input signal type: single-ended signal or differential signal.
  • The maximum magnification: more than 2000 times (actual measurement), due to the gain assembly resulting in greater fluctuations in the waveform band, it is recommended to use high-gain multi-stage amplification.
  • Saturation output amplitude: AC peak 10Vpp (±5Vpp).
  • This module can be enlarged 1000 times, the circuit layout is regular, MINI, design layout and wiring are reasonable.
Check Stock

Frequency Converter AD831 Single Chip High Frequency RF Mixer Radio Frequency Conversion Module for HF and VHF Receiver, 0.1-500MHz

  • WITH VARIOUS PORTS-- There is no corresponding shielding and isolation problems, therefore, compared with the passive mixer to improve the performance of the system, reduce the system cost. The mixer is designed as a single power supply, RF, IF and LO ports with DC isolation capacitor, easy to use..
  • POWERFUL-- The operating frequency of the RF and LO inputs can be as high as 500MHz. IF output is single ended voltage output. With 250 MHz output bandwidth. A single resistor connected between pins OUT and FB is used to set the gain..
  • EASY TO USE-- When the mixer's output amplifier and the optimum source impedance, the SSB noise figure of the mixer is 10.3dB at 70MHz. Different from the passive mixer, there is no insertion loss, no need external duplex device, and no need passive termination for AD831..
  • APPLICATION-- The AD831 is a low distortion, wide dynamic range, single chip mixer, suitable for HF and VHF Receiver RF-IF frequency, second mixer in DMR base sta....
Check Stock

ART 351 EQ 31-Band 1/3 Octave Graphic Equalizer

  • The 351 is a single-channel, 31-band, 1/3-octave graphic equalizer with many features: constant Q circuitry with a 3% center frequency accuracy, 20mm center detent sliders, selectable boost/cut range of 6dB or 12dB, active balanced and unbalanced input and output connections, adjustable high-pass filter, adjustable low-pass filter, variable input level control, clip level indicators, ground lift switch, internal power supply, and selectable line voltage switch.
  • The ART 351 Single Channel 31-Band Equalizer features a rugged all-steel chassis that occupies a single 19" rackspace.
Check Stock

Mixer Module, Bandwidth Mixing 0.1‑500MHz High Frequency Transducer -10dBm for Quadrature Modulation for Base Station for HF VHF Receiver

  • Single Power Supply: The mixer module is designed to be powered by a single power supply, and the RF, IF and LO ports have DC isolation capacitors for easy use.
  • 10.3dB SSB Noise Figure at 70MHz: With the output amplifier and optimal source impedance of this mixer module, the SSB noise figure is 10.3dB at 70MHz. There is no insertion loss, no external duplexer, and no passive termination.
  • Low Distortion and Wide Dynamic Range: AD831 is a low distortion, wide dynamic range, single chip mixer, very practical.
  • -10dBm LO Power Consumption: Provides +24dBm third order intercept point, can achieve -10dBm LO power consumption, without high power LO drivers, there are no corresponding shielding and isolation problems, can improve system performance and reduce costs.
  • Wide Application: Suitable for applications such as RF‑IF down conversion in HF and VHF receivers, second mixer in base stations, DC baseband conversion, quadrature modulation and demodulation, and Doppler shift detection in imaging.
Check Stock

Texas Instruments LM358P Low Power Dual OP Amplifier, General Purpose, 8-Pin, -16-32 Volt, 9.81 mm L x 6.35 mm W x 4.57 mm H (Pack of 15)

  • Four independent voltage comparators that are designed to operate from a single power supply over a wide range of voltages.
  • Wide Supply Ranges Single Supply: 2 V to 36 V, Dual Supplies: ±1 V to ±18 V, Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: ±36 V, Low Input Offset Current: 3 nA (Typical).
  • Low Supply-Current Drain Independent of Supply Voltage: 0.8 mA (Typical), Low Output Saturation Voltage, Common-Mode Input Voltage Range Includes Ground.
  • Low Input Bias Current: 25 nA (Typical), Low Input Offset Voltage: 2 mV (Typical), Low Output Saturation Voltage.
  • Example Applications: Industrial, Automotive: Infotainment and Clusters, Body Control Modules, Power Supervision, Oscillators, Peak Detectors, Logic, Voltage Translation.
Check Stock

2000W Mining 2U Single Channel Power Supply, 110-230V Ethereum PSU for 8 GPU ETH Miner Rig Case

  • 【2000-2500W Mining Power Supply】 The mining power supply is mainly designed for cryptocurrency mining. The power supply has ten 6 pin power leads. Note: The power supply cannot be used for ASIC miners with protocols or software..
  • 【Single channel PSU parameters】 The miner PSU can be used in 110V-230V. Input AC110V output rated power is 2000W. Input AC220V, the output rated power is 2500W. Power efficiency is 80% at 110V, Power efficiency is 90% at 220V. Please reasonably calculate the consumption of the GPUs, and reserve 300-400W for the motherboard and other cable consumption..
  • 【Support 6-8 GPU graphics card】 Built in 60mm diameter cooling fan, with speed up to 12000 rpm, Which is conducive to heat dissipation. But the sound will be loud decibel: about 65-69 DB at no load. Support 8 PCS 3060TI/3070/6800/6800XT 6900/6900XT GPUs simultaneously. We recommend running 6 cards of 3080/3090 without overclocking the GPU..
  • 【Package】 Include 1.2m power cord, cable tie, screw. Over voltage protection, overloading protection, short circuit protection..
Check Stock

Juried Engineering LM393P IC Dual Differential Comparator & 8-Pin DIP Sockets with Machined Contact Pins Breadboard-Friendly (Pack of 1)

  • Wide range of supply voltage Maximum rating: 2 V to 36 V, Low input bias current, Low output saturation voltage.
  • Low supply-current independent of supply voltage: 200 µA per comparator, Low input offset voltage.
  • Common-mode input voltage range Includes Ground, Output compatible with TTL, MOS, and CMOS.
  • Differential input voltage range equal to maximum-rated supply voltage: ±36 V, Example Applications: Vacuum robot, Single phase UPS, Server PSU, Cordless power tool, Wireless Infrastructure, Appliances, Building Automation, Factory automation & control, Motor drives, Infotainment & cluster.
Check Stock