JacobsParts USB C PD DC Voltage Trigger Test Module 9V 12V 20V Adjustable Power 5A 100W E-Mark Type-C

  • Power all kinds of electronic devices with USB-C PD chargers and power banks • Test power supply capabilities.
  • Performs real PD power negotiation • Supports up to 5A / 100W • Has the e-Mark chip necessary to unlock 5A output on 100W power supplies.
  • Trigger 5V, 9V, 12V, 15V, or 20V output (not all USB-C power supplies support all voltages) • The module just performs the PD negotiation and passes the output.
  • LED voltage indicators • Retains setting after power loss.
  • Power supply must be connected to the male end of the module.
Check Stock

Acxico 2Sets Laser Sensor Module For Arduino AVR(KY-008 Laser Transmitter +Laser Receiver Sensor Module Non-modulator Tube)

  • Model: 1*Laser Receiver Sensor Module+ 1* KY-008 Laser Transmitter Module.
  • Laser Receiver Sensor Module uses the non modulated laser receiver, please use in the room where without the light, the sunlight or other lamps and lanterns will interfere, suggested in the dark environment use..
Check Stock

DISH MT2 OTA MODULE [Electronics]

  • An MT2 Over-the-Air (OTA) Module to connect your over-the-air (OTA) antenna directly to your ViP222k or ViP722k DVR satellite receiver.
  • View local, digital, over-the-air channels directly through your satellite receiver by integrating the OTA channels into your Program Guide..
  • An OTA antenna must be installed to use the Module..
  • A satellite signal and a DISH Network programming subscription is required to operate the OTA module..
Check Stock

Garage Door Opener Remote Replacement for LiftMaster 970LM 971LM 972LM 973LM - Chamberlain 953CB 950CB - Sears Craftsman 139.53681 390 Mhz Red and Orange Learn 2 Button

  • Universal remote is compatible with Lift Master garage door opener remote model numbers 970LM, 971LM, 972LM, 973LM, 974LM, 91LM, 92LM, 94LM, 96LM, 950CB, 953CB, 956CB, Craftsman garage door opener remote 139.53680, 139.53681. Compatible with Security + garage opener receiver model numbers 335LM, 535LM, 412HM, 635LM. RED/ORANGE learn button. 390 MHZ Receiver 335LM.
  • Compatible with Lift Master remote garage door opener model numbers 1240R, 1245R, 1246R, 1255R, 1256R, 1265, 1280R, 1000SDR, 2000SDR, 1245GMR, 1255GMR, 985, 2265, 2565, 1280R, 2280, 2580, 2220, 2110, ATS211R, 2500. Compatible with Chamberlain garage door opener remote model numbers 1200, 2200, 4200, 6200, 7220, CG40, CG40, PD210, PD610, PD612K, 7320, 8200, 9200, 4620, 4640, 9902, PD420, PD460-2, 9950.
  • Garage door opener remote can control Security 390 mhz Liftmaster, Chamberlain, Sears Craftsman, Raynor and Access Master garage door openers (hanging in your garage) between 1997 and 2005 that has a RED/ORANGE learn button on the motor unit.
  • Please make sure your garage door opener has RED/ORANGE learn button, or this will not work! The Learn button is located on your garage door opener. Universal garage door remote easy to follow programming instructions on package, battery is also included.....
Check Stock

Joe Morello: Drum Method 2 -- Around the Kit

  • TD-27KV V-Drum Pads and Sound Module - PD-140DS V-Pad Digital Snare - 3x PDX-100 V-Pad 10" - VH-10 V-Drum Hi-Hat - CY-12C V-Cymbal Crash - CY-13R V-Cymbal Ride - CY-18DR V-Cymbal Digital Ride - KD-10 Kick Pad - TD-27 Drum Sound Module - 2x Sound Module Mount - 2x AC Adapter - 2x Special Connection Cable - 2x Connection Cable for Crash2 - 2x Drum Key - MDS-STD2 Rack - TD-27 Sound Module with Bluetooth - MDS-STD2 Drum Stand - (Pedals & Hi-Hat Stands Not Included) - Roland 1 Year Limited.
  • Mid-size V-Drums kit with flagship-class sound.
  • TD-27 sound module with advanced Prismatic Sound Modeling derived from the flagship TD-50.
  • 14" digital snare and 18" ride cymbal with high-resolution, multi-sensor triggering for unparalleled dynamics and accurate positional detection.
  • Large-diameter pads and cymbals provide an acoustic-like playing experience.
Check Stock

Roland TD-27KV V-Drums Electronic Drum Set

  • TD-27KV V-Drum Pads and Sound Module - PD-140DS V-Pad Digital Snare - 3x PDX-100 V-Pad 10" - VH-10 V-Drum Hi-Hat - CY-12C V-Cymbal Crash - CY-13R V-Cymbal Ride - CY-18DR V-Cymbal Digital Ride - KD-10 Kick Pad - TD-27 Drum Sound Module - 2x Sound Module Mount - 2x AC Adapter - 2x Special Connection Cable - 2x Connection Cable for Crash2 - 2x Drum Key - MDS-STD2 Rack - TD-27 Sound Module with Bluetooth - MDS-STD2 Drum Stand - (Pedals & Hi-Hat Stands Not Included) - Roland 1 Year Limited.
  • Mid-size V-Drums kit with flagship-class sound.
  • TD-27 sound module with advanced Prismatic Sound Modeling derived from the flagship TD-50.
  • 14" digital snare and 18" ride cymbal with high-resolution, multi-sensor triggering for unparalleled dynamics and accurate positional detection.
  • Large-diameter pads and cymbals provide an acoustic-like playing experience.
Check Stock

Taidacent 12V 2A High Power 8mm to 18mm Wireless Charging Mat Module DIY Inductive Modules Wireless Charger Module Power Supply Kit Receiver and Transmitter Offering Technical Support

  • The charging module is an 80mm DC remote module, and the circuit is simple and practical..
  • Transmitting coil: inner diameter 70mm outer diameter 88mm thickness 1.3mm.
Check Stock

QIUCABLE USB C to Cigarette Lighter Adapter - 3ft 12V USB Type-C Male Plug to Cigarette Lighter Adapter Cable, 12 Volt USB-PD to Car Cigar Adapter Female Socket Power Cable

  • ...f the PD power supply is currently 3A at most). More power than USB to cigarette lighter adapter step up cables(max power 12V/8W)..
  • Power for 12V Car Devices - Power your Car air purifier, Driving recorder, dash cam, GPS, car interior Led lights, Garmin or other FM traffic receiver, car fan, and other automotive devices with power less than 36W, suitable for using 12 volt car devices while indoor or outdoor..
  • ATTENTION: If you connect it to a power supply that is not PD or doesn't have 12V it will send 5V to your device. Power input is from usb-c plug and output is cigarette lighter female adapter, and can't run in reverse. Feel free to contact our customer support if you have any further questions..
Check Stock

Durablow TR2003 Gas Fire Fireplace On/Off Remote Control Kit + Thermostat + Timer for Millivolt Valve, IPI Module, Replaces Wall Switch or Thermostat (Input 100-240VAC)

  • ★★ ATTENTION: This device is NOT a power supply unit. It is a switch designed for connecting to Millivolt valve, or to electric spark ignition module, or can replace wall switch..
  • ▼ All battery powered R.F. 2-button transmitter and receiver box kit gives wireless remote control to a gas heating appliance, such as gas fireplace, fire pit, stove. ▼ This is a simple On/Off remote control, gives an instant & manual control of the flame and heat..
  • ▼ Receiver with LEARN function, snap-on wall plate, and 18-inch wires with connectors to connect MILLIVOLT valve, or electric spark ignition module, or to replace wall switch. ▼ Receiver box dimension: 2.6"x2.4"x1.54". (measure your wall outlet box first).
  • ▼ Replaces Cross Reference Model #: SKY, 1001, 1001-A, 1001TH, 1001T, 1001D 1410, 1410T, 1410-A, 1410TH, RG04-1M, UN3. ▼ LEGAL DISCLAIMER: The Brand name & Model # (if listed) are for cross reference only. All Brands, Trademarks & Model Numbers remain the property of their respective owners..
  • ▼ Includes: Remote transmitter, receiver box, wall mount cover plate, screws, slide switch, wires with connectors, manuals / instructions. ▼ FCC approved. Operates at a range of 20-foot & non-directional RF signal. ▼ Transmitter operates (2) 1.5V AAA bat....
Check Stock

Taidacent 20mm to 80mm Long Distance 12V to 24V Input 5V 2A Output Wireless Power Supply Module Wireless Charging Coil Module Wireless Inductive Coil

  • The transmission voltage is designed with a wide voltage: 12V~24V..
  • Receiver coil size: outer diameter 88mm..
  • Sensing distance: Receive output 5V2A at 20mm.
  • Note: The distance between the two coils need greater than 13mm!.
Check Stock

Drone Racing League: 2017 eSports Tryouts

  • ...ke other versions of LiteRadio 2, which can act as a USB Joystick when connected to a personal computer, suitable for FPV novices to play FPV simulators like EREADRONE.
  • 【About Bind】The stock firmware of the TX module manufactured by our company is ELRS V1.0.0-RC5(the fifth release candidate version) and the Lite receiver and Micro TX Module is V1.1.0.
  • Please note that the firmware version of the Transmitter and the receiver or the TX module should be the same one and then could be bound together. If you don't know the firmware version, please contact us directly and we will solve the problem for you..
Check Stock

Oiyagai 3pcs 433MHz RF Wireless Transmitter and Receiver Module Kit for Arduino/Arm/McU/Raspberry pi (433MHz)

  • 3 x Transmitter module (433MHz) & 3 x Receiver module(433Mhz).
  • These modules are used for projects when you need to communicate wirelessly between 2 devices.
  • It is possible to increase the range by adding a small length of cable which the device will use as an aerial..
  • VCC voltage module operating voltage and good power filtering.
  • Antenna position has also affected the reception of the module, the installation, the antenna as possible straight away from the shield, high pressure, and interference source.
Check Stock

Marantz SA10S1 SA-10 Super Audio CD Player, Black

  • ...izing the adverse effect of unwanted vibrations on sound quality. And all from a package with a tiny footprint that occupies an area of just 215mm x 232mm (8.5” x 9.1”), allowing users to comfortably locate the unit on the smallest of desktops..
  • Unlike most other CD Players, the PD-301-X also features a FM Tuner module within its compact cabinet..
  • In addition to conventional analogue audio outputs, audio signals from the PD-301-X’s built-in FM tuner are also delivered from the digital audio outputs, via both the coaxial and optical connectors (of course, these connections also deliver digital audio from CD). Please note that the digital audio output format is PCM 44.1kHz/16-bit, regardless of the resolution of the original source..
Check Stock