Categories

Best Serial Ethernet Converter Module

Chase Research IOLAN DS1 1-Port Device Server (04030124)

  • Nonstandard baudrates supported with high precision.
  • Port buffers for storing serial data when the Ethernet is offline.
  • Supports IPv6 / Ethernet redundancy (STP/RSTP/Turbo Ring) with network module.
  • Modular design for scalability / DES/3DES/AES for highly secure data transmissions.
Check Stock

JacobsParts WT32-ETH01 ESP32 Module Ethernet WiFi Bluetooth Development Board 100Mbps RJ45

  • The issue with the top soldered pins has been resolved, they are now shipping with separate unsoldered pins WT32-ETH01 is an embedded serial to Ethernet module based on the ESP32 series WT32-S1 MCU. The module integrates an optimized TCP/IP protocol stack, which is convenient for users to easily complete the networking functions of embedded devices while reducing development time cost. In addition, the module is compatible with half-pad and through-hole connectors..
  • The board width is a universal width and therefore, it can be directly soldered to boards, connectors, or even breadboards, which is convenient for users to use in different scenarios..
  • ESP32 series IC is an integrated 2.4GHz Wi-Fi and Bluetooth dual-mode SOC, with ultra-high RF performance, stability, versatility and reliability, as well as ultra-low power consumption..
  • ESP32 Module: WT32-S1 240MHz dual core microprocessor 4MB SPI flash memory Oboard 10/100Mbps RJ45 Ethernet (LAN8720A PHY) 802.11n WIFI Bluetooth 4.2.
Check Stock

GCAN-205 Modbus TCP to CAN Converter, Allows User to Connect Some ModTCP Master with an existing CAN Network

  • The GCAN-204 is a CAN to Modbus RTU Slave Converter with one Serial interface and one CAN interface. It allows user to connect some Modbus Master (for example: PLC, HMI, etc) with an existing CAN network. It has integrated isolation protection module and easier to install with DIN-rail..
  • CAN industrial automation control system.
  • The serial communication device is connected to CAN-bus.
Check Stock

Agatige Frequency to Voltage Converter Module, 0-10Khz to 0-10V F/V Digital to Analog Converter Conversion Module

  • FUNCTION: The frequency of the pulse signal 0HZ to 10KHZ converts into an analog voltage signal of 0-10V. Can be used to interface switching between the PLC and the frequency converter, or interface matching such as the matching of motion control card and inverter control..
  • FEATURES: Input pulse level is 5V 12V 24V, which can be directly entered without serial resistor. The input signal frequency must maintain more than 0.5 seconds..
  • ANTI-INTERFERENCE: Conversion module's signal inputs with optical coupling isolation, which can ensure that the capability of anti-interfence..
  • APPLICATION: Frequency to Voltage Converter Module Can be used for industrial control panel PLC or other signal interface switching.
  • MAJOR SPECIFICATIONS: Output current: 5MA,Voltage: 0-10V, Input pulse level: 5V 12V 24V, Frequency: 0 to 10KHZ..
Check Stock

Gigabit Ethernet Multi-Mode LC Fiber Media Converter (SFP SX Transceiver Included), up to 550M, 10/100/1000Base-Tx to 1000Base-SX

  • Seamless Conversion of Copper to Fiber – This media converter kit includes a multimode 1000BASE-SX SFP module(850nm), which enables you to convert 1000BASE-SX fiber to 1000Base-T copper media or vice versa.
  • Extend Transmission Distance – By using this ethernet fiber media converter, you can extend link distance up to 550 metres/ 1804 ft via OM3/OM4 multimode fiber (MMF).
  • Plug and Play – Hot-swappable design makes this fiber converter easy to install and troubleshoot for newbies.
  • 1.25G Gigabit Connection – 10/100/1000Mbps Auto-Negotiation RJ45 Port Supporting Auto-MDI/MDIX and Half-Duplex / Full-Duplex Transfer Mode.
  • What You Get – 1* Gigabit Ethernet SFP to RJ45 media converter.
  • 3-year Warranty, Free Lifelong Technology Support.
Check Stock

MOXA NPort 6650-16 - 16 Ports Rackmount RS-232/422/485 Secure Device Server 100V~240VAC Input

  • Nonstandard baudrates supported with high precision.
  • Port buffers for storing serial data when the Ethernet is offline.
  • Supports IPv6 / Ethernet redundancy (STP/RSTP/Turbo Ring) with network module.
  • Modular design for scalability / DES/3DES/AES for highly secure data transmissions.
Check Stock

5PCS HC-05 Wireless Bluetooth Receiver RF Serial Transceiver Module Master Slave Integrated Bluetooth Module 6 Pin Wireless Serial Port Communication BT Module

  • HC-05 Bluetooth Module is an easy to use Bluetooth SPP (Serial Port Protocol) module, designed for transparent wireless serial connection setup..
  • Default baud rate:9600, Button: Press the button.
  • the module enter the AT mode. AT commands are executed only in AT mode..
  • HC-05 is able to operate in both master and slave mode. Its communication is via serial communication which makes an easy way to interface with controller or PC. It's ideal replacement to your wired serial connection..
  • HC-05 Wireless BT Module: with this HC 05 Bluetooth module,You can quickly add the Bluetooth feature to your motherboard project, and then you can use your android phone to control some gadgets, such as: switch, LED..
  • Note: The module doesn’t suitable for IOS system..
Check Stock

Bluetooth Serial Port Transceiver Baseboard, HC-05 Wireless Bluetooth Transceiver Module, Mini Low Power Consumption

  • Enhanced data rate (EDR) conforms to the 2Mbps and 3Mbps modulation modes of the V2.0.E.2 specification..
  • Support Bluetooth connection through AT command, set baud rate, password, save parameters after setting parameters..
  • Bluetooth UART RS232 serial converter module for easy transfer of UART data..
  • On board 3.3V regulator chip, ROHS compliant, compact size..
  • Full speed Bluetooth operation, support for full Piconet and Scatternet..
Check Stock

SainSmart USB 4 Channel Relay Automation (5V)

  • NOYITO 2-Channel Micro USB Relay Module is equipped with a stable USB to serial port chip and a microcontroller. It can use the serial port debugging software to send serial commands on the computer to control the opening and closing of the 2-channel relay..
  • Onboard high performance microcontroller chip, CH340 USB control chip.With power LED indicator and relay status LED.On-board 2-channel 5V, 10A/250VAC, 10A/30VDC relay, long relay life, can work 100,000 times continuously..
  • Module with overcurrent protection and relay diode freewheel protection..
  • NOYITO 8-Channel Micro USB Relay Module ASIN：B09RGTSHHW.
  • NOYITO 4-Channel Micro USB Relay Module ASIN：B09RGVQXXT.
Check Stock

2Pcs HC-06 RS232 4 Pin Wireless Bluetooth Serial Transceiver Module Bi-Directional Serial Support Slave and Master Mode

  • Industrial serial port bluetooth, Drop-in replacement for wired serial connections, transparent usage. You can use it simply for a serial port....
  • Operating voltage: 3.3V(Note:SPP-CA Bluetooth module serial port level to 3.3V, if connect 5V level,the system needs to increase the level conversion....
  • Small size, low power consumption,high sensitivity for send and receive.
  • Allows your device to both send or receive the TTL data via Bluetooth....
  • Defaults: Salve, baud rate 9600, Bluetooth name HC-06, pairing password 1234, LED status light on.Core module uses HC-06, leads from the module....
  • Applications: The Bluetooth module is mainly used for short-range data wireless transmission,such as Bluetooth wireless data transmission,Industrial....
Check Stock

Digi International 70001851 230Kbps Ethernet Device Server

  • Lantronix 2 Port Serial (rs232/ Rs422/ Rs485) To Ip Ethernet Device Server - Us Domestic 110 Vac - Convert From Rs-232.
  • Rs-485 To Ethernet Using Serial Over Ip Technology.
  • One 10/100 Mbps Fast Ethernet Rj-45 Port.
Check Stock

Wiitek SFP+ to RJ45 Copper Modules, 10GBase-T Transceiver Compatible for Cisco SFP-10G-T-X, Ubiquiti, Netgear, Mikrotik, Unifi (Cat 6a/7 or Better, 30-Meter)

  • WIDE COMPATIBILITY:This 10G Copper SFP+ Transceiver is 100% compatible for Cisco SFP-10G-T-X, Ubiquiti, D-link, TP-LINK, Supermicro, Netgear, Mikrotik, Unifi and Other Open Switches, connecting 10g ethernet Switch, Edge Router, media converter.
  • CABLE DISTANCE:10GBase-T SFP Module supports Links up to 30m using Cat 6a/7 or Better Cable , works for 5GBase-T, 2.5GBase-T using Cat 6a/7, and 1000Base-T using Cat 5e cable or better(10G SFP+ Ports).
  • PROTOCOLS: 10Gb RJ45 SFP Compatible SFF-8431 and SFF-8432 MSA , IEEE 802.3az.
  • Each Module is individually 100% tested on the 10G RJ45 Ethernet Switch before delivery.
  • HOT SWAPPABLE:Hot-swappable transceivers that plugs into an 10Gb SFP+ port,plug and play,no need to power down if installing or replacing.
  • SUPPORT: 30 Days Free-returned, 3-year Product Quality Assurance, Free Lifelong Technology Support..
Check Stock

SparkFun ESP8266 Thing - Dev Board - WiFi-enabled microcontroller compatible with Arduino for Internet of Things WiFi Development On-board FTDI USB-to-Serial converter PCB trace antenna U.FL connector

  • All module pins broken out for ease of use. On-board FTDI USB-to-Serial. +19.5dBm output power in 802.11b mode.
  • 802.11 b/g/n. Wi-Fi Direct (P2P), soft-AP. Integrated TCP/IP protocol stack.
  • Integrated TR switch, balun, LNA, power amplifier and matching network. Integrated PLLs, regulators, DCXO and power management units.
  • Integrated low power 32-bit CPU could be used as application processor.
  • The USB-to-serial converter means you don't need any peripheral components to program the chip. Simply plug in a micro USB cable..
Check Stock