Categories

Best Stainless Steel Solenoid Valves

Motorized Ball Valve- 1/4 Stainless Steel Ball Valve with Full Port 9-24V DC and 2 Wire Reverse Polarity by U.S Solid

  • SAFE AND RELIABLE- Made of SS304 steel, with NSF certification, this ball valve is safe for drinking water.
  • NPT THREADING- 1/4” Stainless steel threading, manufactured and measured according to National Pipe Thread standards.
  • 9V-24V DC- Works effectively over entire voltage range.
  • Limit switch cuts off power after valve is fully open....
  • 2 WIRE REVERSE POLARITY SETUP- Simple two wire connection, valve completely de-energizes after opening or closing.
  • ALTERNATIVE TO SOLENOID VALVES- Automatically cuts off power once fully open or fully closed.
  • This reduces likelihood of overheating, making it a....
Check Stock

1\ HEAVY DUTY HIGH FLOW IN-LINE COMPRESSED AIR PRESSURE REGULATOR 180 CFM

  • CO2 pressure regulator has two valves to independently measure flow rate and remaining CO2 tank contents (CO2 tank sold separately).
  • Valves have dual-scale readings in psi and kg/cm.
  • Needle valve flow control provides precise flow adjustment and measurement.
  • Includes flow regulator, needle valve, electronic solenoid, and bubble counter.
  • NOTE:Kindly refer to the Regulator Set Up Procedure provided as a PDF manual in the product description section.
Check Stock

AC Compressor Control Solenoid Valve Replacement Compatible with VW Audi Sanden BOLT DOWN STYLE PXE16 PXE13 MK5

  • Highest quality control valve available GUARANTEED! Our valves use the highest quality materials. Be cautious of cheap valves as most are factory B stock from sanden and have an incredibly high failure rate!.
  • PLEASE PHYSICALLY CHECK YOUR A/C COMPRESSOR BEFORE ORDERING several different manufactures for the AC compressor were use! This solenoid is ONLY COMPATIBLE WITH SANDEN PXE16 PXE13 COMPRESSOR VALVE HELD IN WITH A BOLT!.
  • Compatible with many Volkswagen / Audi applications from 2006 + including Jetta and Golf TDI. The OEM and other aftermarket brand solenoid have an EXTREMELY high failure rate! Will cause intermittent / no AC issues.
  • WILL ONLY FIT SANDEN COMPRESSORS WITH VALVES HELD IN WITH A BOLT! PLEASE PHYSICALLY CHECK YOUR COMPRESSOR BEFORE ORDERING!.
Check Stock

HuthBrother Injector Tune Up SHIM Kit Fits 1994-2003 7.3L powerStroke Diesel Engines (NO TOOLS)

  • ★【Package includes】–TEN .004″ thick special stainless steel washers. (TWO TO BE INSTALLED UNDER THE ARMATURE PLATE TO INCREASE THE CLEARANCE to .004″.
  • ★【Package includes】–FORTY .002″ and FORTY .003″ stainless steel SOLENOID SPACER SHIMS. One of each placed under all four corners of the coil (for a total .005″) to increase the SOLENOID to armature clearance, when SOLENOID is energized..
  • ★【Package includes】–STEP BY STEP INSTRUCTIONS WITH PICTURES to install the two .004″ armature shims and INSTALL the .002″ and .003″ SOLENOID SPACER SHIMS (total .005″) and tips on thing to check with the valve cover off..
  • ★【 Fits Following 】–Kit Works on most HEUI injectors.
  • 1994 – 2003 7.3L PowerStroke, International T444E / DT466e / 1530E . Also works on Cat 3126B top solenoid , International Perkins 4.5L, 6.0L, & 1300edi HEUI injectors..
  • ★【After-Sales Service 】–Pleases make sure the part number of new replacement matches your original equipment before ordering. If you encounter any problem, feel free to let us know. We will be more than happy to reply your message within 24 hours..
Check Stock

Motorized Ball Valve- 1/2 Stainless Steel Electrical Ball Valve with Full Port 9-24V AC/DC and 3 Wire Setup by U.S Solid

  • SAFE AND RELIABLE- The valve body is made of SS304 steel, with NSF certification, this ball valve is safe for drinking water.
  • NPT THREADING- ½" Stainless steel threading, manufactured and measured according to National Pipe Thread standards.
  • 9V-24V AC/DC- Works effectively over entire voltage range.
  • No power expended once fully open or fully closed.
  • 3 WIRE, 2 POINT CONTROL SETUP- Simple three wire connection, with two points of control.
  • ALTERNATIVE TO SOLENOID VALVES- Automatically cuts off power once fully open or fully closed.
  • This reduces likelihood of overheating, making it a....
Check Stock

Wyin 4L Aquarium Co2 Generator System with Single Gauge Display Pressure Gauge, DIY Co2 Generator System Kit, Automatic Pressure…

  • ...n water and absorbed by plants, keeping your aquarium full of life. When using this product for the first time, there will be large bubbles in the refiner, which will gradually disappear within 3 days.
  • 【What's in The Box?】 The box you receive will come with a cylinder, stainless steel pressure-reducing valve, filter, bubble counter, solenoid valve, solenoid valve power supply, solenoid valve connection cable, spare sealing ring, spare atomizer piece, 4 snap-on suction cups, one-way valve, stainless steel U-tube, 2 stainless steel atomizer, air tube, funnel, syringe, and English installation instructions.
  • 【Professional Factory & Peace of Mind After-Sales】 We are a manufacturer specializing in CO2 generator systems. Our co2 generator system is made of 304 stainless steel, far better than a simple plastic bottle generator, more durable, stable, safe, and high-pressure resistant. We have a professional after-sales group, you can contact us at any time if you have any problems with the products you buy, and we will give you a satisfactory solution.
Check Stock

1/4inch DC 12V 2 Way Normally Closed Electric Solenoid Air Valve

  • .WIC Valve is compatible with SMC valves. Has two holes in the bottom and can be mounted in any position..
  • .2ACK Series valve is a Zero differential solenoid valve which can be operated at 0 PSI (Vacuum)..
  • .Comes with a ED 100% encapsulated coil which suitable to operate in continuous service and constant energized..
  • .This solenoid valve has one G1/4" inch DN8 inlet and one G1/4" inch DN8 outlet port. Valve stays close when the coil is de-energized- and it opens when energized..
  • .1/4inch DC 12V 2 Way Normally Closed Pneumatic Aluminum Electric Solenoid Air Valve WIC Valve 2ACK series 2-way normally closed solenoid valve is to control On/Off of air and inert gas..
Check Stock

3 Pack 20\ x 4.5\ BB Blue Whole House Filter Housing 1\ Inlet/Outlet Ports w/ Pressure Release + 1/8\ Gauge Hole

  • Material：This housing is made of high quality 304 thicken stainless steel, corrosion resistant. heat resistance, pressure resistance, good wear resistance.
  • This is a heavy duty， 145psi rated filter housing for dirt, rust, scale particles, taste/odors, or other contaminants..
  • Applicaiton：Ideal for filtration of water for the whole house, kitchen sink, or for commercial uses. Also suitable for industrial fluid treatment. Avoid the risks of failure and damage of flooding from using low-cost plastic filter housings..
  • FLIEXBLITY-3/4" NPT Full Port inlet and outlet.Maximum strength and durability..
  • Especially suitable for applications where solenoid valves are used and frequent water hammer occurs. For high flow rates and minimal pressure drops.
Check Stock

Industrial Misting System - Patio Misting System - 250 PSI Misting Pump, Stainless Steel Tubing - For Residential. Commercial, Outdoor Restaurant and Industrial Misting Application (20 Nozzle System)

  • Base 20 Nozzle Stainless Steel Mist Kit Includes: 250 psi mid pressure pump with built-in solenoid and filtration 38ft Stainless Steel tubing for push lock (Pre-cut 2ft sections) 22ft UV coated Flexible 1/4" feed line 20- Nickel Plated Push Lock Misting Tees 1- End plug 2- Nozzle plugs 20- Nickel plated brass/stainless steel Nozzles (0.012") Stainless Steel Mounting Clamps and all necessary fittings required for easy D-I-Y installation.
  • Misting Pump Features : Stainless Steel Mist Line Whisper quiet operation Built in Solenoid Valve Built in Filtration Outdoor Enclosure Wall Mountable Steel Enclosure Max Pump Pressure 250 Psi 110v AC Supports up to 30 nozzles Cleanable Brass-Stainless Steel ultrafine misting nozzles Reusable high pressure push lock fittings Stainless Steel Clamps.
  • Applications Include : Residential Patio Misting Greenhouse Humidification Commercial Outdoor Cooling Outdoor Restaurant Misting Industrial Misting.
  • Do it yourself misting system, easy to install, with Push to Connect Nickel plated fittings, rated for 1800 PSI..
Check Stock

ZRDR 4L Co2 Generator System with Dual Gauge Display Pressure Gauge,DIY Co2 Generator System Kit, Automatic Pressure Relief Valve Bubble Counter for Plants Aquarium, Stable Output

  • 【Professional Factory & Peace of Mind After-Sales】 We are a manufacturer specializing in CO2 generator systems. Our co2 generator system is made of 304 stainless steel, far better than a simple plastic bottle generator, more durable, stable, safe, and high-pressure resistant. We have a professional after-sales group, you can contact us at any time if you have any problems with the products you buy, and we will give you a satisfactory solution.
  • 【New upgrade bubble counter】As the water of the co2 generator system bubble counter evaporates quickly, In view of this, we have carried out a new upgrade to the bubbler. The bubble gauge is equipped with a syringe, which can be directly used to inject water (there is a one-way valve inside the generator, only into the water without leakage). And you can also add water during use, no need to close the air outlet, no need to remove the air tube, convenient for your use.
  • 【Safety protection】 The zrdr co2 generator system 4l with automatic pressure relief valve, when the pressure in the cylinder exceeds 70KG will automatically release the pressure. A co2 generator system with a 12V waterproof solenoid valve, make y....
Check Stock

mistcooling 24'' OSC Misting Fan Kit - High Pressure (2 Fans White Color)

  • Base Fan Mist Kit Includes: 2 - 24'' High velocity 3 Speed Oscillating Fan with 6 Nozzle Stainless Steel Ring 1- 1500PSI High Pressure Pump with Solenoid, Pressure Switch and Filtration 2- 25ft Roll of Flexible HP Tubing 1/4'' 12- Ultrafine, Anti-drip Brass/Stainless Steel Misting Nozzles - Stainless Steel Mounting Clamps and All necessary fittings for easy DIY installation.
  • - 110v AC (Available in 12vdc and 220v on request).
  • - Supports up to 10 Fans with 6 nozzles FAN Features: - UL 507 certified for outdoor use - High Velocity (Air throw up to 20 feet) - Corrosion resistant finish –.
  • 10ft pre-wired 3-prong plug for 120VAC - 5600 CFM, 1/4HP, 2.4 Amps - Quiet operation - Totally enclosed, maintenance free high performance motor with thermal overload protection - Stainless Steel 6 Nozzle Mist Ring (we also offer White and Grey Color Tubing) contact us if you wish to get a different color.
Check Stock

Motorized Ball Valve- Stainless Steel Ball Valve with Full Port 9-24V DC and 2 Wire Reverse Polarity by U.S Solid 1 inch

  • RELIABLE AND SAFE- The metal components of this ball valve are made entirely of SS304 and SS316 stainless steel.
  • NPT THREADING-1” thread, manufactured and measured according to National Pipe Thread standards.
  • This electrical ball valve is full port, meaning the....
  • 9V-24V DC- Works effectively over entire voltage range.
  • Limit switch cuts off power after valve is fully open....
  • 2 WIRE REVERSE POLARITY SETUP- Simple two wire connection, valve completely de-energizes after opening or closing.
  • ALTERNATIVE TO SOLENOID VALVES- Automatically cuts off power once fully open or fully closed.
  • This reduces likelihood of overheating, making it a....
Check Stock

mistcooling Outdoor Misting Fan System 18\ Fan - High Pressure (18\ - 2 Fans Black)

  • Base Fan Mist Kit Includes: 1 - 18'' High velocity 3 Speed Fan with 4 Nozzle Stainless Steel Ring 1- 1500PSI High Pressure Pump with Solenoid, Pressure Switch and Filtration 1- 25ft Roll of Flexible HP Tubing 1/4'' 4- Ultrafine, Anti-drip Brass/Stainless Steel Misting Nozzles - Stainless Steel Mounting Clamps and All necessary fittings for easy DIY installation..
  • - 110v AC (Available in 12vdc and 220v on request).
  • - Supports up to 8 Fans FAN Features: - UL 507 certified for outdoor use - High Velocity (Air throw up to 20 feet) - Corrosion resistant finish – 9ft pre-wired 3-prong plug for 120VAC - 6400 CFM, 1/10HP,.
  • 1.4 Amps - Quiet operation - Totally enclosed, maintenance free high-performance motor with thermal overload protection - Stainless Steel 4 Nozzle Mist Ring, all kits come with Black color tubing (we also offer White and Grey Color Tubing) contact us if you wish to get a different color tubing..
Check Stock