Categories

Best Thermostat Differential Setting

Dr Infrared Heater DR999, 1500W, Advanced Dual Heating System with Nightstand Design, Furniture-Grade Cabinet, Remote Control

  • Can heat up a large room with Dual Heating System: Infrared Quartz tube + PTC.
  • Produces 60-percent more heat or 50 degree higher than other brands in the market.
  • Modern design with furniture-grade cabinet makes this nightstand heater a great way to update your bedroom décor.
  • Accurate electronic thermostat with push button power and mode setting. Dial for temperature and timer setting.
  • Electronic Thermostat: range 50 to 86 degrees.
  • Rated to heat up a large room with Dual Heating System: Infrared Quartz tube + PTC.
Check Stock

KETOTEK KT8230 Digital Temperature Controller Thermostat Regulator 120VAC 30A Fahrenheit -22~572℉ Heating Cooling for Incubator Brooder Refrigerator Fermenter Greenhouse Reptile

  • 【Wide temperature range.】The range for KT8230 is -22~572℉, This is a relay temperature controller, There is no voltage output directly, you need to connect additional power supply for the load, then it can be set by differential (1~80℉) to turn on/off the load, it is like a switch..
  • 【Output is 30A relay, more accurate.】The temperature controller 120V can be used for big power equipment, like incubator, brooder, refrigerator,Fermenter,Greenhouse,etc. 1°F accuracy to keep the temperature in desired range..
  • 【Support delay start function and temperature correction.】The cooler and heater will delay to work if you set the delay time(PL: 0~7min) not 0, You can set depend on what you need. -30.0°F～30.0°F calibrate the temperature when there is error..
  • 【Safe protection.】Temperature Regulator will alarm when it exceed temperature limit or sensor error, alert you when something wrong happened. You can also set the low(LS) and high temperature limit(HS) to change the temperature range, LS < Setting Temperature < HS..
  • 【Simple operation.】 All parameters setting can be saved after restart, you don’t need to set the thermostat regulator when power off, or restart it from vacation. 2m NTC sensor allows more possibility for home.
Check Stock

279769 Dryer Thermal Cut-Off Kit, 3387134 Dryer Thermostat & 3392519 Thermal Fuse for Whirlpool Kenmore Dryers 3390291 3977394

  • This kit fits specific Whirlpool manufactured dryer models including Amana, Jenn Air, Kenmore, Magic Chef, and Maytag..
  • 279679 Thermal Cut Off Kit replaces 279548, 2796769, 2821, 3387812, 3389946, 3398671, 3977394, 695563, 80001, AH334278, AP3094224, EA334278, PS334278..
  • 3387134 Thermostat is an Operating Thermostat rated at L155*-25* differential, with a 250 Volt 2 Watt Heat Anticipator. The 2 outside terminals are 1/4″ male & the 2 inside terminals are 3/16″ male. Replaces part numbers 3387134, 3-6910, 306910, 3387135, 3387139, AP3131939, AP6008270, ET187, PS344510 and PS11741405..
  • 3392519 thermal fuse is a one-time use thermal fuse which attaches to the blower wheel housing of your clothes dryer. It cannot be re-set and must be replaced when continuity between the pins is no longer present. Terminal size is 3/16″. Replaces part numbers AP3132867, 2986, 3388651, 694511, 80005, AH345113, EA345113, ET401, PS345113..
  • Package includes: 1 * 279679 Thermal Cut Off Kit, 1 * 3387134 Thermostat, 1 * 3392519 Thermal Fuse. ( Non-OEM ).
Check Stock

Ventamatic XXDUOSTAT Adjustable Dual Thermostat/Humidistat Control for Power Attic Ventilators

  • THERMOSTAT/HUMIDISTAT CONTROL: The Dual Thermostat and Humidistat is designed for use with Power Attic Ventilators. The dual controls allow for a user to limit the operation of the fan based on user selected temperature and humidity levels..
  • ADJUSTABLE DUOSTAT: This item is often called a Duostat and is an essential tool for homeowners to regulate the temperature and humidity levels while preventing their power attic ventilator from running in continuous operation mode.
  • ENERGY EFFICIENT POWER ATTIC VENTILATOR: It provides energy-efficient operation of power attic ventilators and the temperature ranges from 50°F to 120°F..
  • DUAL HUMIDITY CONTROL: Adjustable Thermostat and Humidistat Control has 10 Amps, 120 Volts AC. Thermostat setting adjusts from 60 - 120 degrees F (normal settings are 85 - 110 degrees F). Humidistat setting adjusts from 30 - 90% (normal settings are 60 - 70% depending on local humidity levels). If either setting is too low, fan will run continuously. If setting is too high, ventilation will be inadequate. It has limited lifetime warranty..
  • REMOVAL OF HEAT: The Duostat allows for worry free operation during both winter and summer months by allowing the homeowner to not manually turn on and off their attic fan when needed. It remov....
Check Stock

Honeywell L8148A1017 Immersion-Type Controller

  • Includes transformer to provide power for the low voltage control circuit.
  • Operating Range, High Limit: 140F to 240F.
Check Stock

Dixell XR40CX-5N1C1 230V/50Hz-60Hz Digital Thermostat Controller with Defrost Management Programmable-Commercial for Refrigeration Units

  • Suitable for appliances including:for applications on medium or low temperature refrigerating units.XR40CX-5N1C1 230V/50-60Hz..
  • The regulation is performed according to the temperature measured by the thermostat probe with a positive differential from the set point:if the temperature increases and reaches set point plus differential the compressor is started and then turned off when the temperature reaches the set point value again. In case of fault in the thermostat probe the start and stop of the compressor are timed through parameters COn and COF..
  • Two defrost modes are available through the tdF parameter: defrost through electrical heater (tdF= EL) and hot gas defrost (tdF = in). Other parameters are used to control the interval between defrost cycles (IdF), its maximum length (MdF) and two defrost modes: timed or controlled by the evaporator?s probe (P2P).At the end of defrost dripping time is started, its length is set in the FSt parameter. With FSt =0 the dripping time is disabled..
  • SAFETY PRECAUTIONS Check the supply voltage is correct before connecting the instrument. Do not expose to water or moisture: use the controller only within the operating limits avoiding sudden temperature changes with high atmospheric humidity to prevent formation of ....
Check Stock

Dixell XR60CX-5N1C1 Digital Thermostat Controller with Defrost Compressor Control of Evaporator Fans 230V/50-60Hz Programmable-Commercial for Refrigeration

  • The regulation is performed according to the temperature measured by the thermostat probe with a positive differential from the set point: if the temperature increases and reaches set point plus differential the compressor is started and then turned off when the temperature reaches the set point value again.In case of fault in the thermostat probe the start and stop of the compressor are timed through parameters COn and COF..
  • Two defrost modes are available through the tdF parameter:defrost through electrical heater (tdF= EL) and hot gas defrost (tdF = in).Other parameters are used to control the interval between defrost cycles (IdF), its maximum length (MdF) and two defrost modes: timed or controlled by the evaporator?s probe (P2P).At the end of defrost dripping time is started, its length is set in the FSt parameter. With FSt =0 the dripping time is disabled..
  • Forced activation of fans This function managed by the Fct parameter is designed to avoid short cycles of fans, that could happen when the controller is switched on or after a defrost, when the room air warms the evaporator. Functioning: if the difference of temperature between the evaporator and the room probes is more than the value of the Fct parameter, the fans are switched on. With Fct=0 t....
Check Stock

Refrigerator Thermostat Freezer Refrigeration Temperature Controller Universal WPF-20

  • WIDELY APPLICATION – Control the temperature of refrigerator, freezer, display cabinet, congealer, beverage cooler and similar product.
  • TEMPERATURE CONTROL – The scope of and differential temperature control can be a significant change.
  • IDEAL REPLACEMENT – The model WPF-20 has 65cm long probe wire with 2 pins, ideal replacement for your damaged thermostat.
  • UNIVERSIAL USE – As long as the shape and size match, suitable for a variety of different brands of products..
  • 2 YEARS WARRANTY – Professional support.
Check Stock

Optimus Portable Ceramic Thermostat Heater, H-7004, Silver

  • 4 Position Function Switch (Off, Fan, Low and Hi).
  • Portable ceramic heater in a compact, space-saving design.
  • 4-position function switch for off, fan only, low heat, or high heat.
  • Measures approximately 7 by 9 by 6 inches.
Check Stock

Furrion Chill Single Zone Thermostat - FACW12SA-BL , Black

  • Wall Thermostat: The Single Zone Basic Wall Thermostat lets you adjust the temperature inside your RV or Camper. It has 4 different operating modes to ensure optimal comfort throughout your RV..
  • Digital Display: Has a digital LCD display that shows your settings clearly. 3 fan speeds with auto fan function..
  • Touch Operation: The thermostat comes with a simple touch operation with an elegant touch sensitive button layout that is easy to use..
  • Auto Restart Function: The wall thermostat can automatically restart and resume the last known setting after a power interruption..
  • Warranty: The Single Zone Basic Wall Thermostat comes with Furrion's 12 month Warranty. Works with Furrion's Single Zone Controller to control Furrion Chill AC (sold separately)..
Check Stock

Lennox 15S63 iComfort E30 Smart Thermostat

  • Feels Like™ Setting: Similar to the “Feels Like” temperature in a weather report, this takes into account temperature and humidity, making your home feel exactly like you want.
  • Allergen Defender: Monitors the air quality and pollen levels in your local zip or postal code and automatically turns the system fan on as needed to clean your home’s air..
  • Perfect Temp: Allows you to set the ideal temperature. The system then automatically adjusts heating and cooling to maintain that setting.
  • Smart Away™ Mode: Uses the location services in your smartphone to detect when you’re leaving, and automatically changes the temperature to a more energy-efficient setting..
  • Alexa Integration: The iComfort E30 smart thermostat is an Amazon® Alexa-enabled, smart-home-compatible thermostat. It works with Amazon Echo, Echo Dot and Tap devices allowing the homeowner to ask Alexa to adjust the temperature..
Check Stock

Costco Greenmade The Heat Machine Parabolic Heater

  • SMALL HEATER MEASURES: 6.2" X 4.74" x 8.3" . Manual controls. Fully Assembled. Carrying handle for easy transport. Adjustable thermostat for....
  • THREE MODES HEATER WITH FAN: 1. High Heat (1500-watt), 2. Low Heat(750-watt ), 3. Fan Only. The power indicator light lets you know when it’s....
  • CERAMIC HEATER ELEMENTS: Ceramic space heaters are fast to heat, produce abundant heat without open coils, and are long-lasting.
  • SPACE HEATER WITH THERMOSTAT: The thermostat system can according to the thermostat setting let your room remain at a comfortable temperature. This....
  • FOR SAFETY: 1. An automatic overheat system will shut the unit off when the parts of the heater overheat. 2. TIP-OVER SWITCH will shut off unite when....
Check Stock

KT99 Temperature Controller 120V 10A Digital Thermostat Regulator Switch Dual 1.5m Waterproof Probe for Heater Cooler Fahrenheit Display Aquarium

  • 【Two direct output】KT99 digital thermostat support two independent direct output, with 2pcs 1.5m NTC waterproof sensor can work with two independent equipment, with °F display..
  • 【Easy operation】KT99 Temperature controller control the load by setting the start and stop temperature. -58~248°F wide control range is good for both heater cooler..
  • 【Compressor delay time, alarm setting】 KT99 thermostat regulator can set the compressor delay time(0~5min) to make the cooler delay start. By setting high/low temperature alarm value to keep the home appliance, incubator, seeding pads, refrigerator ,reptiles, Aquarium, and other appliances safe..
  • 【Data storage and reset function.】 All parameters setting can be saved after short circuit and power off, and it also can be reset as requirement..
  • 【Temperature calibration】±1°F Control Accuracy with (-30~30°F) Temperature Calibration, can make the all process more accurate, keep the temperature in desired range..
Check Stock