uniquegoods 6V 12V 24V 28V 3A 80W DC Motor Speed Controller (PWM) Speed Adjustable Reversible Switch 1203BB DC Motor Driver Reversing

  • 80A CURRENT---The speed controller regulator is of new two-way large power silicon controlled rectifier and the current can be up to 80A, which is a good solution to over-current of electric stove wire caused by low resistance during cooling.
  • STABLE & DURABLE---This voltage regulator is adjusted with button which is much more stable than potentiometer. Voltage regulator has wave voltage absorbing circuit and effective protects large power silicon controlled rectifier, longer service life and more durable.
  • HEAT DISSIPATION ENHANCING---Designed with large and thick heat sink, the speed controller regulator can enhance heat dissipation more effectively.
  • OUTPUT VOLTAGE ADJUSTING---The speed controller regulator can easily adjust the output voltage on a scale of 0-100% (nonlinear) to power electric device.
  • WIDE APPLICATION---The speed controller regulator can be used as power supply for large electrical devices of less than 10000W, enough for household appliances or for small factory, could be widely used as heat controller on electric stoves, water heaters, light dimmer on lamps, speed controller on small motors, or temperature controller on electric soldering iron, etc.
Check Stock

10000W SCR Digital Voltage Regulator,AC 220V 80A Electrical Motor Speed Controller Regulator, High Power Voltage Regulator Dimming Thermostat

  • 10000W resistance load limit power, room temperature for a long time is recommended to be used within 5000W, voltage regulation: AC 10V to 230V (adjust begin 20V), this is an easy-to-use voltage regulator that can control the brightness or speed of the light. Use a new bidirectional high-performance thyristor. The current can reach up to 100 A, and solves the problem of overcurrent caused by small resistance when the induction cooker cable is cooled..
  • 10000W SCR voltage regulator standard aluminum housing safe and durable super power electronic voltage regulator. It is widely used in resistive loads, such as heating wires, incandescent lamps and most (not all) single-phase AC motors..
  • 10000W speed controller operating voltage AC 110V-230V. Maximum power 10000W (resistive load), long term operating power 7000W. Voltage adjustable from AC 0V to near input voltage. Full copper 75A super large current terminal. The trigger circuit is unique, the control voltage is accurate and there is no hysteresis, the resistive load is turned off to 0, and after starting, it will be adjusted from 10V, adjust to the supply voltage that is closest to the input..
  • Connect the SCR voltage regulator to the front of the circuit of the electrical appliance. The ''input' and """"....
Check Stock

20 Pieces 3 Pins AMS1117-3.3 DC 4.75V-12V to 3.3V Voltage Regulator Down Power Supply Buck 800mA Module

  • ... to install: please check the product pictures carefully for the wiring diagram steps before using, simple dual-panel design and the input output using the 3 pin single row pin for easy connection, the input voltage is higher than output voltage 1.2V, the module will work normally.
  • AMS1117-3.3 is a positive voltage regulator step down power supply module, support DC 4.75-12V input and 3.3V fixed voltage and 0.8A current output.
  • Electronic devices partner: the 3 pins AMS1117-3.3 voltage regulator mini step down power supply module, can be applied to electronic devices which need 3.3V power supply, such as SCM project design, MCU development and more, easy to be connected and provide the power supply.
  • Where to use: the voltage to 3.3V 800mA DC buck module is applicable for high-efficiency linear regulator published active power regulator battery charger active instrument.
  • Compatible with: the 3 pins AMS1117-3.3 voltage regulator mini power supply is compatible with Arduino MEGA2560, MSP430 development board, 3.3V low power consumption MCU, FPGA/CPLD PLD programmable logic systems, ARM7 ARM9 ARM11 STM32, etc..
  • Provide more safety: the AMS1117-3.3 800mA DC buck module features overheat shutdown circuit provides overload and over-temperature protection, ....
Check Stock

CKT3800-400 Touch Screen Dry Block Temperature Calibrator, Dry Type Temperature Calibration Furnace Temperature Range 50℃~400℃

  • Note: This product series's input supply voltage is 220V, currently it does not support 110V input voltage, if end user's country use 110V input voltage, need to buy the 110-220V converter or regulator, buyers can buy the converter from us or buy a regulator locally. For 220V input voltage country, no need to buy the converter/regulator..
Check Stock

Voltage Regulator Rectifier For John Deere 355D GT242 GT262 GT275 Lawn Tractors

  • ★100% Brand new high performance Voltage Rectifier Regulatorand All parts are tested and quality controlled prior to shipment.
  • ★Replacement Part Numbers: M70121,M97348,21066-2056, 21066-2070,SH578-12, SH626-12.
  • ★This Voltage Rectifier Regulator is made up of high quality aluminum , highest grade lamination materials,higher grade of electronic components.This rectifier has overheat protection , help to dissipate excess voltage,prevent over-charging battery , improved heat sink and charging capabilities.
  • ★This Voltage Rectifier Regulator is made up of high quality aluminum , highest grade lamination materials,higher grade of electronic components..
  • ★Package including: 1 X Voltage Rectifier Regulator as images display.
Check Stock

CKT3800-150B Touch Screen Dry Block Temperature Calibrator, Dry Type Temperature Calibration Furnace Temperature Range -30℃~150℃

  • Note: This product series's input supply voltage is 220V, currently it does not support 110V input voltage, if end user's country use 110V input voltage, need to buy the 110-220V converter or regulator, buyers can buy the converter from us or buy a regulator locally. For 220V input voltage country, no need to buy the converter/regulator..
Check Stock

CKT3800-150A Touch Screen Dry Well Block Temperature Calibrator, Dry Type Temperature Calibration Furnace Temperature Range -20℃~150℃

  • Note: This product series's input supply voltage is 220V, currently it does not support 110V input voltage, if end user's country use 110V input voltage, need to buy the 110-220V converter or regulator, buyers can buy the converter from us or buy a regulator locally. For 220V input voltage country, no need to buy the converter/regulator..
Check Stock

Stepper Motor HAT for Raspberry Pi,Jetson Nano Onboard Dual DRV8825 Motor Controller Built-in Microstepping Indexer Drives Two Stepper Motors Up to 1/32 Microstepping 5V 2.5A

  • Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano.
  • Protection features: Overcurrent Protection (OCP), Thermal Shutdown (TSD), VM Undervoltage Lockout (UVLO).
  • Integrates 5V regulator, allows providing power to Raspberry Pi.
  • 6 available microstepping modes, configured with the DIP switches: full-step, half-step, 1/4-step, 1/8-step, 1/16-step, and 1/32-step.
  • Adjustable motor drive current via potentiometer, maximum 2.5A current output.
  • Onboard dual DRV8825 motor controller IC with built-in microstepping indexer, drives two stepper motors, easy to use.
  • Onboard multi connector options for stepper motors in different specifications.
Check Stock

W10189190 W10197428 TSD2 Refrigerator Compressor Start Relay and 2264017 Overload Assembly Replacement Part For Kenmore Electrolux Whirlpool Refrigerators Freezer W10662129 241941003 W2319792 2255198

  • ✅【W10189190 TSD2 Start Relay Replace number】This W10197428 W10189190 TSD2 refrigerator start device combination replaces W10197428 W10197427....
  • ✅【W10662129 Run Capacitor Replace number】2264017 W10662129 Refrigerator Freezer Compressor Run Capacitor Replaces....
  • ✅【Compatible brand and Compatible Refrigerator Model】This refrigerator parts kit can fit for Kenmore,Whirlpool,Amana, Maytag,Jenn-Air,Magic....
  • ✅【【High Quality Material and easy to install】This W10189190 TSD2 Start Relay and W10662129 Capacitor kit are made of made of sturdy and....
  • ✅【Packaging Includes & Guarantee】:1 x W10189190 start relay , 1 x W10662129 Capacitor and 2 x Terminal Block . (After Sale Guarantee-for any....
Check Stock

Voltage Regulator Rectifier Compatible with Kohler Engine CH730-0165 CH730-0170 62570 64569 ECH749 ECV740 Replace 25 403 39-S 25-403-32-S 25 403 05-S 25 403 08-S 25 403 20-S 25 403 21-S 25 403 29-S

  • Replace Part Number: Voltage regulator replacement for Kohler Part 25-403-39-S, 25-403-32-S, 25-403-05-S, 25-403-08-S, 25-403-20-S, 25-403-21-S, 25-403-29-S.
  • Compatible with Kohler Engine: CH730-0165 CH730-0170 ECH749 ECV740 62570 64569. See product description below for more detailed compatibility models.Compatible with Kohler Engine: CH730-0165 CH730-0170 ECH749 ECV740 62570 64569. See product description below for more detailed compatibility models.Fitment for Toro Zero-Turn Mowers model 74255.
  • Plug and Play: The voltage regulator is easy to install, no complicated tools are required, you just need to remove the old rectifier and tighten all loose connections. Perfect match with the original voltage regulator, cost-effective. No modification, cutting or drilling is required.
  • High-Quality Aluminum Alloy Material: The regulated rectifier is made of high-quality aluminum alloy material, which has good heat dissipation performance, wear-resistant and rust-proof, strong and durable, ensuring the best durability.
  • Excellent Performance: The voltage regulator rectifier provides stable voltage, improves ignition efficiency, can rectify and control power supply, is stable and reliable, and has high precision. Replacement for Kohler engine directly replaces the ....
Check Stock

Auto Mechanic - Brake Systems Mechanics and Hydraulics

  • 101 Pages - 01/14/2013 (Publication Date) - TSD Training (Publisher).
Check Stock

Gasoline and Diesel Fuel Systems Mechanics and Hydraulics

  • 136 Pages - 01/14/2013 (Publication Date) - TSD Training (Publisher).
Check Stock

Outboard Rectifier 3 Wires Fits for 1980-2001 Johnson Evinrude 15 60 65 75 85 88 9.9 90 100 110 112 115 140 150 175 200 235 HP, Voltage Marine Regulator 18-5708 583408 582399 580795 581603

  • Voltage Regulator Rectifier Fits for Johnson Evinrude Outboard Motors, Repl. OEM# 580765 580795 582399 583408 581603 582307 580841 581305 583408 Sierra 18-5708. Compatible Models 50HP 1971-1975, 55HP 1976-1977, 60HP 1970-1971, 1986-1991, 65HP 1972-1973, 1989 , 65HP Comm 1984-1991, 70HP 1973-1991, 75HP 1975-1976, 1978-1988..
  • Voltage Regulator Rectifier Fits for :85HP 1970-1983, 88HP 1987-1996, 90HP 1984-1990, 1994, 1996-1997 , 100HP 1967-1968, 1971-1972, 1990, 1994, 100HP Comm 1987, 1990, 110HP 1986-1989, 112HP 1994-1996, 115HP 1969-1970, 1973-1985, 1990, 1994, 1997, 125HP 1971-1972, 135HP 1973-1984, 150HP 1978, 175HP/185HP 1977-1978, 200HP 1976-1978, 235HP 1978, 2.5/2.6 L SEA DRIVE 1982, 1.6 L SEA DRIVE1983 , 2.6 L SEA DRIVE 1983..
  • Brand new Voltage Regulator Rectifier Made of use high quality aluminum, highest grade lamination materials,higher grade of electronic components. Achieves greater stability and reliability than ordinary brands. It will match even exceed OEM parts in compatibility and performance.
  • This rectifier has overheat protection, helps to dissipate excess voltage, prevents over-charging battery, improves heat sink and charging capabilities. Replace a new regulator rectifier can raised your lights brightness, improve the phenomenon of l....
Check Stock