DIYmall USB to TTL Serial Cable Adapter FTDI Chipset FT232 USB Cable TTL for Arduino ESP8266 Pack of 1pc
- FTDI based USB to TTL Serial Cable are designed using the the standard FT232BL chipset.
- Please note that this cable supports very low power devices-5V..
- It can work with Raspberry Pi serial console.
- UART interface IC device which handles all the USB signal and protocols.
- What you will get is : 1 X USB to TTL serial cable.
Check StockYongnuo YN568EX YN-568EX TTL High Speed 1/8000 Flash Speedlite for Canon
- TTL Flash with High Guide Number, GN58@ISO100,105mm, support TTL, M, Multi flash..
- The YN568EX III can synchronize with all shutter speeds, realize TTL and manual flash, the maximum shutter sync is up to 1/8000..
- The YN568EX III is equipped with the USB interface, you can download the latest firmware from YONGNUO official website to upgrade the speedlite..
- The YN568EX III is equipped with the battery electric power display function, allows you to check the battery remaining capacity easily..
- The recycling time for full output just takes 2 seconds.
- you can get high speed current-return experience even without using brand new batteries, which will only takes 3-4 seconds..
Check StockYONGNUO Upgraded YN568EX III Flash Speedlite Wireless Slave TTL with HSS 1/8000 for Nikon DSLR Cameras
- TTL Flash with High Guide Number, [email protected],105mm, support TTL, M, Multi flash..
- The YN568EX III can synchronize with all shutter speeds, realize TTL and manual flash, the maximum shutter sync is up to 1/8000..
- The YN568EX III is equipped with the USB interface, you can download the latest firmware from YONGNUO official website to upgrade the speedlite..
- The YN568EX III is equipped with the battery electric power display function, allows you to check the battery remaining capacity easily..
- The recycling time for full output just takes 2 seconds.
- you can get high speed current-return experience even without using brand new batteries,....
Check StockELEGOO 8 Channel DC 5V Relay Module with Optocoupler Compatible with Arduino UNO R3 MEGA 1280 DSP ARM PIC AVR STM32 Raspberry Pi
- 5V 8-Channel Relay interface board, each one needs 70mA Driver Current.
- Equiped with high-current relay, AC250V 10A.
- Each relay has normally open and normally closed contact. Can be selected by jumper relay and TTL or ground..
- With power indicator,8-way road has a status indicator. With a relay coil to absorb the diode protection..
- Standard interface that can be controlled directly by microcontroller (Arduino , 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL logic).
- The 8 channels are optically isolated, safe, reliable, anti-interference. Widely used for all MCU control, industrial sector, PLC control, smart home control。For a complete data sheet for this relay board, please download it from: http://dwz.win/UhW.
Check StockRakstore Speak Recognition Voice Recognition Module V3 Compatible with for Arduino Support 80 Kinds of Voice DC 4.4-5.5 V High Accuracy
- Digital Interface: 5V TTL level for UART interface and GPIO.
- Analog Interface: 3.5mm mono-channel microphone connector + microphone pin interface.
- Recognition accuracy: 99% (under ideal environment);Size: 31mm x 50mm.
Check StockMaikrt Embedded QR Code Scanning Module USB and UART Serial Port Barcode Scanner Identification Module Bar Code Reader for Access Control, Locker Scan Code Payment etc
- A small 1D/2D codes reader,Can be embedded in any device for scanning code to identify other items, by using the intelligent image recognition algorithm.Configurable via scanning 'configuration code',Module matching light source, Can work in the dark..
- Embedded QR code scanning module is used for access control, channel gate, locker, scan code payment, etc. And other industry equipment to achieve smart project,The performance is stable and the decoding speed is very fast..
- 2D/QR code scanning module support linux,Android, windows and other systems, Can easily capture bar codes 1D, 2D on labels, paper, and mobile phone or computer displays,Sensitive and accurately..
- USB and TTL dual interface, equipped with 9pin terminal line and USB cable, which is convenient for you to convert between UART TTL serial port and USB interface. No need to worry about the use of interface types..
- After receiving our products, connect to the line, after power-on That can scan the code.
- The module scans the code directly and sends the result to your host computer automatically. After receiving the data, the host computer can proceed to the next step..
Check StockYONGNUO YN200 Wireless Flash Speedlite 200W TTL M Multi HSS 1/8000s 2.4G Pocket Flash Strobe Monolight + 2900mAh Lithium Battery + Bare Bulb + Lamp Holder
- YN200 can receive the controlling and triggering signal from the TTL master unit such as YN862 series, YN560-TX PRO series , realizing TTL and M/Multi....
- Supports YONGNUO new upgraded RF radio flash system.
- Using removable bare tube lamp tube, GN60 high index.
- [email protected] ISO100 (using reflector cover).....
- It is equipped with large capacity battery with imported cell, using Type-C interface charger, which supports quick charging with PD protocol power....
- Equipped with Micro USB interface, supports firmware upgrade, users can log in the Yongnuo official website to download....
- It can receive the master optical control signals of Yongnuo,C/N, and supports S1 and S2 pre-flash cancel trigger mode. Equipped with 3.5mm....
Check StockBeaster Voice Recognition Module with Microphone Dupont Jumper Wire Speech Recognition Voice Control Board for Arduino
- This product is a speaker-dependent voice recognition module. It supports up to 80 voice commands in all..
- This board has 2 controlling ways: Serial Port (full function), General Input Pins (part of function). General Output Pins on the board could generate several kinds of waves while corresponding voice command was recognized..
- Digital Interface: 5V TTL level for UART interface and GPIO.
- Analog Interface: 3.5mm mono-channel microphone connector + microphone pin interface.
Check StockSainSmart 8-Channel Relay Module
- 5V 8-Channel Relay interface board, and each one needs 15-20mA Driver Current.
- Equipped with high-current relay, AC250V 10A.
- Standard interface that can be controlled directly by microcontroller (Arduino , 8051, AVR, PIC, DSP, ARM, ARM, MSP432, TTL logic).
- Indication LED's for Relay output status.
Check Stock1900 Patterns DJ Disco Party Lights,Sumger Full Color Laser Animation Projector,DMX Sound Activated Stage Lighting,Remote Control RGB Beam Effect Scan Light for Christmas Halloween Bar Dance Wedding
- Control mode:MX512 signal control / Auto-run /Music control/ master-slave.Control channels: 6/34CHS.Modulation: TTL.
- 7 Color RGB Light:It's a mini size rgb animation light with 15 groups of pattern library , 1900 patterns . 20kpps scanning system with TTL Modulation . Equipped with international DMX interface , RJ45 - DMX interface , can be connect to tiger, pearl , MA and other consoles..
- PDMX functions:Pattern break pen, rotate, move, zoom, fade, change color, change size, etc..
- Mini and easy to carry:The portable bracket is convenient,the aluminum profile is luxurious,and the heat dissipation is better.Size:9.7*7.0*7.59inch,Weight:4.62 Pounds.
- Solution for Mini bars, ktv, party, music bar , night club private room , ballroom, disco room etc..
Check StockYONGNUO YN14EX II Macro Ring Flash Light Kit with Large Size LCD Display Adapter Rings Color Temperature Filters Hot Shoe Mount Compatible with Canon DSLR Cameras
- ♥M/TTL Flash Supported: Support Exposure Compensation, FEB, Rear-curtain sync, FE Lock, Modeling Light, menu access to Canon camera..
- ♥Macro Ring Type Dual-Lamp Flash: Support M/TTL flash ratio setting, and the flash tube A and B can be adjusted together or individually, it can create shadows on the subject and make the photo with sculpture effect..
- ♥Large-size LCD Display: Equipped with large size LCD display, which can be more clear, more intuitive to see and set flash function, convenient to use..
- ♥LED Focus Assist Light: High brightness LED focusing assistant lamp can easily focus when the environment is dark..
- ♥With PC Sync Interface: YN14EX II is equipped with standard PC synchronous interface, which allows you convenient to use synchronous flash by using PC synchronous line..
Check Stock100W LED Logo GOBO Projector Ip67 Waterproof DJ Effect Light Including Free Custom Glass GOBO to Project Image for Hotel Company Store Wedding Advertising Indoor and Outdoor Use (100W)
- Control mode:MX512 signal control / Auto-run /Music control/ master-slave.Control channels: 6/34CHS.Modulation: TTL.
- 7 Color RGB Light:It's a mini size rgb animation light with 15 groups of pattern library , 1900 patterns . 20kpps scanning system with TTL Modulation . Equipped with international DMX interface , RJ45 - DMX interface , can be connect to tiger, pearl , MA and other consoles..
- PDMX functions:Pattern break pen, rotate, move, zoom, fade, change color, change size, etc..
- Mini and easy to carry:The portable bracket is convenient,the aluminum profile is luxurious,and the heat dissipation is better.Size:9.7*7.0*7.59inch,Weight:4.62 Pounds.
- Solution for Mini bars, ktv, party, music bar , night club private room , ballroom, disco room etc..
Check StockSainSmart 16-Channel 12V Relay Module Board for Arduino DSP AVR PIC ARM
- 12V 16-Channel Relay interface board, and each one needs 15-20mA Driver Current.
- Equipped with high-current relay, AC250V 10A.
- Standard interface that can be controlled directly by microcontroller (Arduino , 8051, AVR, PIC, DSP, ARM, ARM, MSP433, TTL logic).
- Indication LED's for Relay output status.
Check Stock