zdyCGTime USB 3.1 Front Panel Header to USB 3.0 20Pin Header Extension Cable for ASUS Motherboard 20cm Black (20p)

  • Work for ASUS Motherboard. plz note that ONLY support usb3.1/usb3.0 device, it can't work at USB2.0(480Mbps).
  • USB 3.1 require a different front panel header than USB 3.0.
  • First motherboard with this is the ASUS ROG MAXIMUS IX FORMULA,STRIX Z270I/Z270G etc.There are no official release of the specs for the USB 3.1 header yet (as of this writing).
  • The USB 3.1 port interface is using the USB 3.0 pin set and more. It is design to be backwards compatible..
  • USB 3.1 Front Panel Header to USB 3.0 Front Panel Header 20Pin Extension Cable 20cm.
Check Stock

USB 3.1 Type C Front Panel Header Cable 1.5 Ft.NC XQIN USB 3.1 Type E to USB 3.1 Type C Female Extension Cable with Panel Mount Screw

  • Make use of mainboard USB3.1 front panel Type-E port to convert into USB type-C port. The type-C reversible design simplifies the connection and....
  • Tested and certified by USB Association. It adopts 16-pin USB3.1 cable and four high-speed signal lines. The use of silver-plated material to reduce....
  • Connector 1: Type-C Female with Panel. Connector 2: USB 3.1 Front Panel Header.
  • Motherboard supported - ASUS ROG MAXIMUS IX FORMULA,STRIX Z270I/Z270G.
  • WORRY FREE WARRANTY: NC XQIN USB 3.1 Front Panel Header to USB-C Type-C Female Extension Cable is backed with 18 months friendly manufacturer warranty....
Check Stock

Genuine Dell Optiplex 980 Small Form Factor (SFF) System Motherboard Mainboard Systemboard, Compatible Part Number: C522T

  • ... SDRAM (non-ECC memory only), Speed 1066 MHz or 1333 MHz, Connectors - four, Capacity - 1 GB, 2 GB, or 4 GB, Minimum memory - 1 GB, Maximum memory - 16 GB, Audio: integrated.
  • Video: Integrated Intel graphics media accelerator HD, Peripheral Interfaces: Back panel -two connectors for line-in/ microphone and line-out, Front panel - two front-panel connectors for headphones and microphone, eSATA - one 7-pin connector, Network -one RJ45 connector, Parallel -one 25-pin connector (bidirectional), Serial -one 9-pin connector.
  • 16550C-compatible, USB - Front panel - two connectors, USB - Back panel -six connectors, Video - one 15-hole VGA connector one 20-pin DisplayPort connector.
  • System Board Connections: one 120-pin connector PCI Express x16 data width (maximum), one 164-pin connector Express Lane, Serial ATA - three 7-pin connectors, Memory - four 240-pin connectors, Internal USB - one 10-pin connector (supports two USB ports), Processor fan - one 5-pin connector, Front I/O - one 26-pin connector, Front panel control - one 14-pin connector, Processor - one 1156-pin connector, Power 12V - one 4-pin connector, Power - one 24-pin connector, Internal serial card - one 14-pin connector, Internal speaker - one 5-pin connector, PCI Express x1 (wireless card) - one....
Check Stock

BYEASY Front Panel USB 3.0 Hub 5 Ports, 3.5 Inches Internal Metal USB Hub with 2 USB 3.0 Ports, SD/TF Card Reader and USB 3.1 Gen 1 Type-C Port Fits Any 3.5\ Floppy Disk Bay (PCI-02)

  • USB Front Panel for PC with Huge Expansion: Convert your 3.5’’ floppy disk drive space into 2 USB 3.0 ports, 1 SD slot, 1 Micro SD slot and 1 type-c port. Increase the scalability of desktop computers to meet various needs..
  • Super Speed: The usb 3 front panel uses the latest USB 3.0 chip with a maximum transmission speed of 5Gbps. It is backward compatible with USB 2.0/1.1/1.0 devices. Notes: It is not recommended to use the USB 3. 0 port to charge the devices and the charging speed is slow..
  • Easy to Install, Plug and Play: Quickly adds 5 ports through an available 19pin slot for connecting a variety of external USB devices. The product package contains 6 screws to make this front panel USB hub more stable..
  • Great compatibility and easy to use: Fully plug and play without any drivers. Compatible with Windows 10/8/8. 1/7/ Vista/ XP and Mac OS X, Linux and chrome OS. ( the USB 3. 0 hub reverse compatible USB 2. 0 and USB 1. 1. ).
  • Package Contents: BYEASY 3.0 usb hub front panel (PCI-02), 6*screw, user Manual, 1-year and friendly customer service. Please feel free to Contact us at any time..
Check Stock

USB Front Panel Adapter, JoyReken Vertical USB C Header Adapter, USB 3.1 Type-E Key-A to USB 3.0 20Pin Header Converter for Type C Motherboard

  • Supports all motherboards with USB 3.0/ 3.1 19-pin header.
  • Motherboard: USB 3.0 Internal 19 Pin MB Male Housing Header.
  • Front Panel: USB 3.1 A-Key 20 Pin Front Panel Female Header / NOTE: Does not convert from 5GB/s to 10GB/s.
  • Easy way to access USB-C and support front panel header, doesn't require to have latest motherboard to experience USB-C technology..
  • ** Note on USB current over limit issue: The power from the USB 3.0 header on the motherboard has a power rating at 4.5W (0.9A x 5V). However, many USB-C devices can withdraw power up to 100W (20A x 5V). This may result in a power shut down to protect the motherboard and its components..
Check Stock

Wang-Data 50 Sets M6 Square Hole Hardware Cage Nuts & Mounting Screws Washers for Server Rack and Cabinet (M6 X 20mm)(Screw+Washer+cage nut)

  • TECHNICAL PRO PS17U Rack Mount 17 outlet power supply surge protector with 5V USB charging ports, A/C power center designed to eliminate extension cords and messy wires, 13 power switches on front panel with blue illumination..
  • DEPENDABLE 15A Replaceable Fuse housing on front panel, 15 rear panel 120V 3-prong plug sockets on rear of the unit, perfect solution for switching on and off specific lights and sound equipment, convenient 5V USB charging port on the front panel (3x1A and 2x2A), additional 2x2A 5V USB charging port on rear panel..
  • HIGH LOAD POWER CORd (4 foot), maximum load is 15 amps or 1800 watts, rack mountable ears can be used for a rack or can be rotated 90 degrees to mount under or over a shelf or deck.
  • USB LED Work Light and USB LED light strip included, dimensions are 19" width with ears x 4.5" depth x 3.5" height, 110V/220V.
  • Use for DJ, PA, Karaoke, Studio and Home, this listing and price is for 1 Technical Pro power supply.
Check Stock

Cablecc USB 3.1 Front Panel Header to USB-C Type-C Female Extension Cable 40cm with Panel Mount Screw

  • USB 3.1 require a different front panel header than USB 3.0..
  • The USB 3.1 port interface is using the USB 3.0 pin set and more. It is design to be backwards compatible (will explain later)..
  • There are no official release of the specs for the USB 3.1 header yet (as of this writing),.
  • But first motherboard with this is the ASUS ROG MAXIMUS IX FORMULA,STRIX Z270I/Z270G etc..
  • Connector1: Type-C Female with Panel Connector2: USB 3.1 Front Panel Header.
Check Stock

Inateck PCIe to USB 3.2 Gen 2 Card, with 20Gbps Bandwidth, Internal USB Type-E Port for Front Panel USB Type C, RedComets U24

  • Multi-port Extension Card: Inateck RedComets U24 extends a PCIE x4 slot to 3 USB Type-A ports, 1 USB Type-C port, and 1 internal USB Type-E port, all of which are USB 3.2 Gen 2 ports..
  • Fast Transfer Rate: The USB Type-A port at the bottom exclusively takes a 10Gbps bandwidth. The other four USB ports share a 10Gbps bandwidth, and each port can achieve a 10Gbps transfer rate when solely used..
  • Designed for Front Panel USB Type-C: The USB Type-E port usually offers up to 10Gbps transfer rate for your front panel on the computer case. To experience 10Gbps transfer better, please ensure that the USB ports of front panel also support 10Gbps transfer..
  • Wide Compatibility: The card is compatible with Windows 7/8/10, Linux and Mac OS 10.8.2 and above. Driver-free on Windows 8/10, Linux and Mac OS 10.8.2. On Windows 7 a driver is needed. You can download it from Inateck official site..
  • Simple Installation: The product draws power directly from the PCIe slot. There is no requirement for external power supply. The installation is as easy as ABC..
Check Stock

Tccmebius TCC-QL5E 5.25 Inch PC Multifunction Dashboard Media Front Panel, with SATA e-SATA Dual USB 3.0 6 Port USB 2.0 Audio Ports and Five-in-one Card Reader

  • 【USB 3.0 Front Panel】High speed front USB 3.0 interface for an efficient and effortless data transfer.
  • 【6 Card Slots Front Panel】6 card slots offer quick and easy access to the most common-used card formats, support M2, MSO, Memory, MS, XD, 64G CF card..
  • 【LED Indicator】High quality material ensure durability, LED indicator make you keep an eye on work status..
  • 【eSATA USB 3.1 Port】Equipped with eSATA and USB 3.1 port to meet your needs..
  • 【5.25 Front Panel】Can be easily and neatly installed into a 5.25.
Check Stock

Xiwai USB 3.0 HUB 4 Ports Front Panel to Motherboard 20Pin Connector Cable for 5.25' CD-ROM Bay

  • USB 3.0 HUB 4 Ports Front Panel to Motherboard 20Pin Connector Cable for 5.25" CD-ROM Bay.
  • Build-in GL3520 Chipset Compliant with USB Base Specification 3.0.
  • USB3.0 interface and 5.5inch bay of PC front panel.
  • Compliant with USB 3.0 Super-Speed (5Gbps), USB 2.0 Hi-Speed (480Mbps), USB 1.1 Low-Speed (1.5Mbps).
Check Stock

CY USB 3.1 Front Panel Socket to USB 3.0 20Pin Header Male Extension Adapter for Motherboard

  • Connector1: USB 3.0 Front Panel Socket / Connector2: USB 3.1 Front Panel Header.
  • The adapter is a converter to convert the available USB 3.0 header of a motherboard into a USB 3.1 header. Thus the USB 3.1 port of a housing can also....
  • Even the most up-to-date motherboards with AMD AM4 or Intel 2066 sockets are not always equipped with a USB 3.1 header. The adapter is the perfect....
  • The small converter is plugged into a USB 3.0 header that provides two USB 3.0 lanes. Thus, two data lines with 5 Gbps each are available, which are....
  • The converter thus provides a full-fledged USB 3.1 port..
Check Stock

DEVMO USB 3.1 Front Panel Header to USB 3.0 20Pin Header Extension Cable Compatible with ASUS Motherboard 20cm Black

  • Compatible with ASUS Motherboard . Only support usb3.1/usb3.0 device it can't work at USB2.0(480Mbps).
  • USB 3.1 Front Panel Header to USB 3.0 20Pin Front Panel HeaderExtension Cable 20cm 0.65ft.
  • USB 3.1 port interface uses USB 3.0 pin set and more. It is design to be backwards compatible (will explain later)..
  • The USB 3.1 port interface is using the USB 3.0 pin set and more. It is design to be backwards compatible.There are no official release of the specs....
  • There are no official release of the specs for the USB 3.1 header yet (as of this writing) But first motherboard with this is the ASUS ROG MAXIMUS IX....
Check Stock

Fractal Design Core 1100 - Mini Tower Computer Case - mATX - High Airflow and Cooling - 1x 120mm Silent Fan Included - Brushed Aluminium - Black

  • An extremely compact Micro ATX Case, designed for exceptional airflow and cooling.
  • Brushed aluminum-look front panel with a sleek, three dimensional textured finish.
  • Easy access I/O on front panel, with audio and both USB 3. 0 and USB 2. 0 ports.
  • Front panel dust filters and closed top and bottom panels help maintaining a dust free interior.
Check Stock