Categories

Best Vent pipe

Sewer Skewer XL Vent Defroster for Sewer Pipes & Roof Vents, Copper Tee, Made in USA

  • PREVENTS SEWER PIPES FROM CLOGGING -The Sewer Skewer XL prevents sewer vent pipes from freezing and stops methane sewer gas backup.
  • MELTS SNOW & ICE - Made of copper which conducts heat from the sun and sewer gas to the top of sewer vent to melt ice and snow.
  • LONGER SEWER SKEWER FOR PROBLEMATIC SEWER VENTS – Includes two 15” screw on extension pipes that makes total length approximately 47” long and extends down 45”.
  • RATED FOR -25 DEGREES & FITS ANY SIZE PIPE – No measuring required, simply drop it in the sewer vent pipe and it begins to work.
  • ASSEMBLED IN USA BY ADULTS WITH DISABILITYS WITH PORTIONS SUPPORTING DISABLED VETERANS.
Check Stock

BIRASIL Indoor Tortoise Habitat for Landscaping, Wooden Large Tortoises Enclosure for for Small Animals, Outdoor Elevated Raised Garden Bed for Vegetable Flower, Planters Boxes for Backyard Balcony

  • Do you have problems with bird's nests in your dryer vent pipe?or Do you want to eliminate the dryer lint dust?Vent hood Lint Catcher Bag for your dryer..
  • This listing is for (1) the lint bag only. The vent hood is not included.This vent bag will fit 4" diameter dryer vent pipe, 4" diameter vent elbow or 4" dryer vent hood..
  • Measure your vent hood before ordering!EACH LINT CATCHER BAG if you lay it flat it is approximately 9"W x (13" to 16"L ).
  • COLOR OF LINT CATCHER MIGHT VARY (mostly black or gray).Captures lint from the dryer vent. Attach the LintCatcher bag to the exterior vent hood..
  • To keep the bag in place please use a string, clamp, magnet (where possible), wire or screw. NOT INCLUDED..
Check Stock

Deflecto Dryer Vent, Wide Mouth Galvanized Vent Hood with Pipe, Silver, 4” (GVH4NR) , GRAY

  • 4” wide mouth galvanized vent hood and pipe, perfect for dryer or bathroom venting.
  • Vent hood is 5 7/8" wide by 6” tall, and angled out to 3 3/4".
  • Vent pipe is 11 3/8" long with a 4” diameter.
  • Gravity damper helps prevent birds and rodents from entering the home through the dryer vent.
Check Stock

Vent Systems 4\ inch Elbow 90 degree Duct Pipe Connector Flexible Round Tube Ventilation Hose ABS Plastic 100 mm

  • Made of High Quality ABS Plastic and perfectly designed for home improvement, DIY and Trade.
  • Flexible Coupling, Male Fitting for a 4 Inch pipe - Compatible with Round Pipe, Flexible Hose and other pipe, 90 degree elbow.
  • Easy to install - fit perfectly with any other pipe, vent and connector. Push-fit duct and fittings together..
  • Elastic 90 degree Elbow Ducting Pipe Connector is simple to adjust and connect with pipe..
  • Vent Systems products are made to be used for home improvement, office improvement. They are portable, high quality and long durability..
Check Stock

Class A Customs 40 Gallon RV Waste Black Water Holding Tank WT-4000

  • 40 Gallon RV Waste Water Holding Tank MADE IN THE USA by Class A Customs using Medium Density Polyethylene (MDPE) Resin TANK NOT FOR FRESH OR DRINKING WATER USE – WASTE/GRAY WATER USE ONLY – Used in RV’s Campers, Trailers, Motorhomes and Tiny Houses.
  • INSTALLED OUTLET 3” ABS Female Pipe - outlet can not be moved DO NOT over-tighten fittings damage will occur Dump valves do not hook directly to the 3" ABS fitting, from the outlet run PVC or ABS piping (not included), dump valve (not included) is added to the piping..
  • INLET & VENT INSTALLATION Class A Customs Black Water Tanks only come with the outlet the end user will determine where the inlet and vent will need to be placed and install, hardware NOT included. TANK MUST BE VENTED allowing air in and out when in use. *DO NOT PRESSURIZE TANK* DO NOT over-tighten fittings damage will occur..
  • NOT INCLUDED Inlet and Vent Fittings / Additional Fittings / Hardware / Mounting Hardware / Dump Valve / Piping NOT INCLUDED.
Check Stock

Class A Customs 27 Gallon RV Waste Black Water Holding Tank WT-2700

  • 27 Gallon RV Waste Water Holding Tank MADE IN THE USA by Class A Customs using Medium Density Polyethylene (MDPE) Resin TANK NOT FOR FRESH OR DRINKING WATER USE – WASTE/GRAY WATER USE ONLY – Used in RV’s Campers, Trailers, Motorhomes and Tiny Houses.
  • INSTALLED OUTLET 3” ABS Female Pipe - outlet can not be moved DO NOT over-tighten fittings damage will occur Dump valves do not hook directly to the 3" ABS fitting, from the outlet run PVC or ABS piping (not included), dump valve (not included) is added to the piping..
  • INLET & VENT INSTALLATION Class A Customs Black Water Tanks only come with the outlet the end user will determine where the inlet and vent will need to be placed and install, hardware NOT included. TANK MUST BE VENTED allowing air in and out when in use. *DO NOT PRESSURIZE TANK* DO NOT over-tighten fittings damage will occur..
  • NOT INCLUDED Inlet and Vent Fittings / Additional Fittings / Hardware / Mounting Hardware / Dump Valve / Piping NOT INCLUDED.
Check Stock

Class A Customs 14 Gallon RV Waste Black Water Holding Tank WT-1400

  • 14 Gallon RV Waste Water Holding Tank MADE IN THE USA by Class A Customs using Medium Density Polyethylene (MDPE) Resin TANK NOT FOR FRESH OR DRINKING WATER USE – WASTE/GRAY WATER USE ONLY – Used in RV’s Campers, Trailers, Motorhomes and Tiny Houses.
  • INSTALLED OUTLET 3” ABS Female Pipe - outlet can not be moved DO NOT over-tighten fittings damage will occur Dump valves do not hook directly to the 3" ABS fitting, from the outlet run PVC or ABS piping (not included), dump valve (not included) is added to the piping..
  • INLET & VENT INSTALLATION Class A Customs Black Water Tanks only come with the outlet the end user will determine where the inlet and vent will need to be placed and install, hardware NOT included. TANK MUST BE VENTED allowing air in and out when in use. *DO NOT PRESSURIZE TANK* DO NOT over-tighten fittings damage will occur..
  • NOT INCLUDED Inlet and Vent Fittings / Additional Fittings / Hardware / Mounting Hardware / Dump Valve / Piping NOT INCLUDED.
Check Stock

Class A Customs 31 Gallon RV Waste Black Water Holding Tank WT-3100

  • 31 Gallon RV Waste Water Holding Tank MADE IN THE USA by Class A Customs using Medium Density Polyethylene (MDPE) Resin TANK NOT FOR FRESH OR DRINKING WATER USE – WASTE/GRAY WATER USE ONLY – Used in RV’s Campers, Trailers, Motorhomes and Tiny Houses.
  • INSTALLED OUTLET 3” ABS Female Pipe - outlet can not be moved DO NOT over-tighten fittings damage will occur Dump valves do not hook directly to the 3" ABS fitting, from the outlet run PVC or ABS piping (not included), dump valve (not included) is added to the piping..
  • INLET & VENT INSTALLATION Class A Customs Black Water Tanks only come with the outlet the end user will determine where the inlet and vent will need to be placed and install, hardware NOT included. TANK MUST BE VENTED allowing air in and out when in use. *DO NOT PRESSURIZE TANK* DO NOT over-tighten fittings damage will occur..
  • NOT INCLUDED Inlet and Vent Fittings / Additional Fittings / Hardware / Mounting Hardware / Dump Valve / Piping NOT INCLUDED.
Check Stock

Class A Customs 30 Gallon RV Waste Black Water Holding Tank WT-3000

  • 30 Gallon RV Waste Water Holding Tank MADE IN THE USA by Class A Customs using Medium Density Polyethylene (MDPE) Resin TANK NOT FOR FRESH OR DRINKING WATER USE – WASTE/GRAY WATER USE ONLY – Used in RV’s Campers, Trailers, Motorhomes and Tiny Houses.
  • INSTALLED OUTLET 3” ABS Female Pipe - outlet can not be moved DO NOT over-tighten fittings damage will occur Dump valves do not hook directly to the 3" ABS fitting, from the outlet run PVC or ABS piping (not included), dump valve (not included) is added to the piping..
  • INLET & VENT INSTALLATION Class A Customs Black Water Tanks only come with the outlet the end user will determine where the inlet and vent will need to be placed and install, hardware NOT included. TANK MUST BE VENTED allowing air in and out when in use. *DO NOT PRESSURIZE TANK* DO NOT over-tighten fittings damage will occur..
  • NOT INCLUDED Inlet and Vent Fittings / Additional Fittings / Hardware / Mounting Hardware / Dump Valve / Piping NOT INCLUDED.
Check Stock

Class A Customs 24 Gallon RV Waste Black Water Holding Tank WT-2400

  • 24 Gallon RV Waste Water Holding Tank MADE IN THE USA by Class A Customs using Medium Density Polyethylene (MDPE) Resin TANK NOT FOR FRESH OR DRINKING WATER USE – WASTE/GRAY WATER USE ONLY – Used in RV’s Campers, Trailers, Motorhomes and Tiny Houses.
  • INSTALLED OUTLET 3” ABS Female Pipe - outlet can not be moved DO NOT over-tighten fittings damage will occur Dump valves do not hook directly to the 3" ABS fitting, from the outlet run PVC or ABS piping (not included), dump valve (not included) is added to the piping..
  • INLET & VENT INSTALLATION Class A Customs Black Water Tanks only come with the outlet the end user will determine where the inlet and vent will need to be placed and install, hardware NOT included. TANK MUST BE VENTED allowing air in and out when in use. *DO NOT PRESSURIZE TANK* DO NOT over-tighten fittings damage will occur..
  • NOT INCLUDED Inlet and Vent Fittings / Additional Fittings / Hardware / Mounting Hardware / Dump Valve / Piping NOT INCLUDED.
Check Stock

Class A Customs 38 Gallon RV Waste Black Water Holding Tank WT-3800

  • 38 Gallon RV Waste Water Holding Tank MADE IN THE USA by Class A Customs using Medium Density Polyethylene (MDPE) Resin TANK NOT FOR FRESH OR DRINKING WATER USE – WASTE/GRAY WATER USE ONLY – Used in RV’s Campers, Trailers, Motorhomes and Tiny Houses.
  • INSTALLED OUTLET 3” ABS Female Pipe - outlet can not be moved DO NOT over-tighten fittings damage will occur Dump valves do not hook directly to the 3" ABS fitting, from the outlet run PVC or ABS piping (not included), dump valve (not included) is added to the piping..
  • INLET & VENT INSTALLATION Class A Customs Black Water Tanks only come with the outlet the end user will determine where the inlet and vent will need to be placed and install, hardware NOT included. TANK MUST BE VENTED allowing air in and out when in use. *DO NOT PRESSURIZE TANK* DO NOT over-tighten fittings damage will occur..
  • NOT INCLUDED Inlet and Vent Fittings / Additional Fittings / Hardware / Mounting Hardware / Dump Valve / Piping NOT INCLUDED.
Check Stock

Class A Customs 28 Gallon RV Waste Black Water Holding Tank WT-2800

  • 28 Gallon RV Waste Water Holding Tank MADE IN THE USA by Class A Customs using Medium Density Polyethylene (MDPE) Resin TANK NOT FOR FRESH OR DRINKING WATER USE – WASTE/GRAY WATER USE ONLY – Used in RV’s Campers, Trailers, Motorhomes and Tiny Houses.
  • INSTALLED OUTLET 3” ABS Female Pipe - outlet can not be moved DO NOT over-tighten fittings damage will occur Dump valves do not hook directly to the 3" ABS fitting, from the outlet run PVC or ABS piping (not included), dump valve (not included) is added to the piping..
  • INLET & VENT INSTALLATION Class A Customs Black Water Tanks only come with the outlet the end user will determine where the inlet and vent will need to be placed and install, hardware NOT included. TANK MUST BE VENTED allowing air in and out when in use. *DO NOT PRESSURIZE TANK* DO NOT over-tighten fittings damage will occur..
  • NOT INCLUDED Inlet and Vent Fittings / Additional Fittings / Hardware / Mounting Hardware / Dump Valve / Piping NOT INCLUDED.
Check Stock

Class A Customs 18.5 Gallon RV Waste Black Water Holding Tank WT-1850

  • 18.5 Gallon RV Waste Water Holding Tank MADE IN THE USA by Class A Customs using Medium Density Polyethylene (MDPE) Resin TANK NOT FOR FRESH OR DRINKING WATER USE – WASTE/GRAY WATER USE ONLY – Used in RV’s Campers, Trailers, Motorhomes and Tiny Houses.
  • INSTALLED OUTLET 3” ABS Female Pipe - outlet can not be moved DO NOT over-tighten fittings damage will occur Dump valves do not hook directly to the 3" ABS fitting, from the outlet run PVC or ABS piping (not included), dump valve (not included) is added to the piping..
  • INLET & VENT INSTALLATION Class A Customs Black Water Tanks only come with the outlet the end user will determine where the inlet and vent will need to be placed and install, hardware NOT included. TANK MUST BE VENTED allowing air in and out when in use. *DO NOT PRESSURIZE TANK* DO NOT over-tighten fittings damage will occur..
  • NOT INCLUDED Inlet and Vent Fittings / Additional Fittings / Hardware / Mounting Hardware / Dump Valve / Piping NOT INCLUDED.
Check Stock