Categories

Best Wide Range Voltage Input

Voltage Measurement Module, DVB01 Voltage Comparator for Voltage Measurement for Control Applications

  • The LM2903P devices consist of two independent voltage comparators that are designed to operate from a single power supply over a wide range of voltages.
  • Single-supply or dual supplies Wide range of supply voltage Maximum rating: 2 V to 36 V.
  • Low supply-current independent of supply voltage: 200 µA per comparator, Output compatible with TTL, MOS, and CMOS.
  • Common-mode input voltage range Includes Ground, Low output saturation voltage.
  • Differential input voltage range equal to maximum-rated supply voltage: ±36 V.
Check Stock

Texas Instruments LM311P LM311 Differential Comparator With Strobes DIP8 5 Pack

  • Wide range of supply voltage Maximum rating: 2 V to 36 V, Low input bias current, Low output saturation voltage.
  • Low supply-current independent of supply voltage: 200 µA per comparator, Low input offset voltage.
  • Common-mode input voltage range Includes Ground, Output compatible with TTL, MOS, and CMOS.
  • Differential input voltage range equal to maximum-rated supply voltage: ±36 V, Example Applications: Vacuum robot, Single phase UPS, Server PSU, Cordless power tool, Wireless Infrastructure, Appliances, Building Automation, Factory automation & control, Motor drives, Infotainment & cluster.
Check Stock

Juried Engineering LM324N LM324 Quadruple Independent High-Gain Frequency-Compensated Operational Amplifier Op-Amp IC DIP-14 14-PIN DIP Breadboard-Friendly (Pack of 3)

  • The LM324 consist of four independent high-gain frequency-compensated operational amplifiers that are designed specifically to operate from a single supply or split supply over a wide range of voltages..
  • Low Supply-Current Drain Independent of Supply Voltage: 0.8 mA Typical, Wide Supply Ranges:003c/b003e Single Supply: 3 V to 32 V Dual Supplies: ±1.5 V to ±16 V.
  • Low Input Bias and Offset Parameters - Input Offset Voltage: 3 mV Typical - Input Offset Current: 2 nA Typical - Input Bias Current: 20 nA Typical.
  • Common-Mode Input Voltage Range Includes Ground, Allowing Direct Sensing Near Ground.
  • Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: 32 V.
Check Stock

Juried Engineering LM324N LM324 Quadruple Independent High-Gain Frequency-Compensated Operational Amplifier Op-Amp IC DIP-14 14-PIN DIP Breadboard-Friendly (Pack of 10)

  • The LM324 consist of four independent high-gain frequency-compensated operational amplifiers that are designed specifically to operate from a single supply or split supply over a wide range of voltages..
  • Low Supply-Current Drain Independent of Supply Voltage: 0.8 mA Typical, Wide Supply Ranges:003c/b003e Single Supply: 3 V to 32 V Dual Supplies: ±1.5 V to ±16 V.
  • Low Input Bias and Offset Parameters - Input Offset Voltage: 3 mV Typical - Input Offset Current: 2 nA Typical - Input Bias Current: 20 nA Typical.
  • Common-Mode Input Voltage Range Includes Ground, Allowing Direct Sensing Near Ground.
  • Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: 32 V.
Check Stock

Juried Engineering LM2903P LM2903 Dual Differential Comparator Automotive Grade Breadboard-Friendly IC DIP-8 (1 Piece)

  • The LM2903P devices consist of two independent voltage comparators that are designed to operate from a single power supply over a wide range of voltages.
  • Single-supply or dual supplies Wide range of supply voltage Maximum rating: 2 V to 36 V.
  • Low supply-current independent of supply voltage: 200 µA per comparator, Output compatible with TTL, MOS, and CMOS.
  • Common-mode input voltage range Includes Ground, Low output saturation voltage.
  • Differential input voltage range equal to maximum-rated supply voltage: ±36 V.
Check Stock

Juried Engineering LM393P IC Dual Differential Comparator & 8-Pin DIP Sockets with Machined Contact Pins Breadboard-Friendly (Pack of 1)

  • Wide range of supply voltage Maximum rating: 2 V to 36 V, Low input bias current, Low output saturation voltage.
  • Low supply-current independent of supply voltage: 200 µA per comparator, Low input offset voltage.
  • Common-mode input voltage range Includes Ground, Output compatible with TTL, MOS, and CMOS.
  • Differential input voltage range equal to maximum-rated supply voltage: ±36 V, Example Applications: Vacuum robot, Single phase UPS, Server PSU, Cordless power tool, Wireless Infrastructure, Appliances, Building Automation, Factory automation & control, Motor drives, Infotainment & cluster.
Check Stock

Onyehn 2pcs LTC1871 DC-DC Boost Step-up Voltage Converter Module 100W High Power Adjustable Output 3.5-35V Power Regulator Board with LED Voltage Meter

  • No user/operator instructions or data sheets.Find the download data by yourself, please make sure you consider whether you know the operation before buying. Size: 68x42x14mm, LTC1871 IC with External MOSFET..
  • Conversion Efficiency: Up to 96%. Low input voltage or a large difference between input and output voltage will degrade the current capacity and efficiency..
  • Boost voltage to a stable regulated output. Useful for a wide range of applications, such as powering 5V USB devices from a 3.7V lithium cell, powering higher powered electronics from a 12V battery, and a wide range of automotive and electronic projects. Constant voltage regulation, not for raw LEDs..
  • Button to switch measurement of the input or output voltage, and LED indicates the current measurement of the input or output voltage.
  • The nixie tube can be turned off by another button. Mentioned states are able to be memorized, is not lost even if the power is disconnected. (On-board marked "IN" LED is turned on, the nixie tube display input voltage value, "OUT" LED bright display is the output voltage value)..
  • Output voltage must be greater than input voltage, do not apply reverse polarity voltage, voltmeter works only when input is >= 4V..
Check Stock

QJFCare Waterproof DC Buck Converter Voltage Regulator 36V 48V Step Down to 12V 30A 360W Adjustable Power Converter Transformer for Golf Cart Car ,Vehicle

  • 【Input Voltage】-36V 48V Input range: 30V-60V.
  • Output Voltage: DC 12V 30A 360W.Wide input voltage,small size and easy to place in any....
  • 【Multiple Intelligent Protection Function&Stable Performance】 - Synchronization rectification technology-maximum transfer efficiency of 96%, low....
  • 【Safty Protections】 - Protection of input momentary high voltage,output over heat,over-load, over-current, over-temperature, short-circuit,....
  • 【Waterproof Rating】 - IP68, 100% waterproof , can work in rain, waterproof housing makes the converter ideal for use in a wide range of....
  • 【Wide Application】 - Used in golf cart,club car,bus, cmb, large trucks,taxi radio,motor, speaker, GPS, LED car display screen, air-conditioner,....
Check Stock

High Speed Comparator High Speed Frequency Meter Front Shaping Comparator for Low-Voltage Applications Conversion Circuit

  • LOW VOLTAGE APPLICATIONS -- The input common mode range is better than the swing input, which is very suitable for low voltage applications..
  • APPLICATION -- Digital module can be used for wide voltage range and periodic signal shaping..
  • FRONT END ADJUSTMENT -- Used as a front end conditioning module in time domain measurements for frequency and phase difference..
  • PARAMETER -- The input voltage is 10 to 1000mV, the input frequency is about 200MHz DC, and the input impedance is 50 ohms..
  • RAIL TO RAIL OUTPUT -- The output level mode is rail to rail output, which can directly drive TTL / CMOS level..
Check Stock

DS18 3AVS 14.4V Car Audio Stabilizer Constant Steady Output Voltage

  • DS18 3 amp Volt stabilizer - input any voltage between 6-16v and get steady output at 14.4V..
  • Wide voltage input, steady output voltage @ 14.4V..
  • Strong performance, high reliability, & best preset voltage.
  • Input voltage range: 6-16v. Output voltage: constant 14.4V..
  • Voltage stabilized accuracy: 003c 0.5%. Ripple factor: 003c 0.1%. transfer efficiency: 003e 85%..
Check Stock

Bridgold 10pcs LM339 339 Quad Differential Comparator ICS for High Voltage Digital Logic Gate Circuit, DIP14

  • Wide common mode input voltage range, Vic=0～Vcc-1.5V.
  • Input offset voltage is small, VIO=±2mV.
  • The differential input voltage range is very large, even equal to vcc.
  • The output is compatible with TTL, DTL, MOS, CMOS, etc..
Check Stock

ACEIRMC 3pcs 20A 300W CC CV Step Down Module Adjustable DC 6-40V to 1.2-36V Voltage Regulator Buck Converter Constant Current Power Supply Module

  • Aceirmc buck converter input voltage range is DC 6-40V, adjustable output voltage range is DC 1.2-36V, can be used to convert 24v to 12v 5v, adjustable output current range is 0-20A, max output power is 300W. The step down regulator can apply to constant output current..
  • With a wide input voltage range from 6V to 40V, the step-down converter can accurately adjust output voltage and current. The efficiency can be up to 95%,(measured at 20A, converting 24V to 12V)..
  • Short Circuit Protection: Self-recovery(cannot short circuit for long time). Plus, when input and output is common grounded, no-load CV output constant voltage,CC output constant current.
  • Adopting 75V / 80A large current dual MOS tube designed step-down board, Input and output use high frequency low resistance electrolytic capacitor, low ripple, and gives a stable output. Large current 30A connection screw terminals, more convenient to install.
  • Application: DIY stabilized voltage supply, LED car display, mobile power, industrial equipment appliances, LED driver, monitor, solar energy, fans, photovoltaic energy, motor, etc....
Check Stock

Taidacent THS4131 Fully Differential Input/Output Low Noise Amplifier Module Single Ended to Differential Single Ended Input Double Ended Output

  • Name: THS4131 Fully Differential Amplifier Size: 45mm X 34mm Supply Voltage Range: 5V Single Supply ±15V Dual Supply.
  • This module can implement single-ended to differential, single-ended input, and double-ended output. Has high performance, low noise, wide power supply voltage range and other advantages..
  • The THS413x consists of a true fully differential signal path from input to output. This design produced excellent common-mode noise suppression wells that improved total harmonic distortion..
  • Chip features High performance 150 MHz - 3 dB bandwidth (VCC = ±15V) 51V/us slew rate -100dB third harmonic distortion (250kHz) 2. Low noise 1.3 nV/vHz Input Reference Noise Differential input/cent output Balanced Output Suppresses Common Mode Noise Reduce second harmonic distortion from dry differential output.
  • Wide supply voltage range VCC-5 V Single Supply to ±15V Dual Supply ICC (SD) = 860 u A Shutdown Mode (THS4130) Chip application Single-ended to differential conversion Differential ADC Driver Differential antialiasing Differential transmitters and receivers Output Level Translator.
Check Stock